3.5代通信中链路自适应技术的研究和仿真

3.5代移动通信中的链路自适应技术使用自适应调制编码和快速混合重传技术替代了3代中使用的功率控制技术。仿真结果比较了这两种新技术与功率控制技术的性能,证明了这两个新技术显著地提高了网络平均的吞吐量。     

ANALYSIS AND PROCESSING OF LMF－COSTAS STEPPED FREQUENCY RADAR SIGNAL

Linear Modulated Frequency (LMF) Costas Stepped Frequency Radar (SFR) signal is introduced. Its ambiguity function is derived and analyzed in detail and its feasibility is validated in theory. The scheme of the proposed signal processing is also presented. The results of theoretic analysis and simulation show that, by using the proposed signal and increasing the bandwidth of the total stepped frequency, the ambiguity sidelobe is well suppressed and the range-velocity coupling in the stepped frequency radar is also greatly weakened.     

长江口北支水道水沙特性分析

从实测资料出发,结合水流数值计算成果,对长江口北支水道的水流、泥沙和含盐度等资料进行分析,得出了北支水道的水沙特性,并分析了水沙变化与河床变化的相互关系.北支水道在1958年南通河段河势控制后,径流分流比逐年下降,并渐趋稳定于3%左右.北支水道受径流影响越来越小,主要受潮流作用.随着水沙特性的逐年变化,北支水道0 m以下槽蓄容量逐年减小,并渐趋稳定,北支上段为逐年淤积最快的区域.由此反过来影响了水沙条件的进一步变化,使北支上段平均潮差增加,北支的会潮点由崇头附近下移至青龙港附近.     

Bioprocess applications of model-based estimation techniques

The last decade has seen the development of a number of approaches for estimating those variables which are difficult to measure on-line in industrial process situations. Whilst a range of techniques is available, a common element is the use of process knowledge in the form of a system model. In the case of bioprocess systems, although a large range of models has been presented in the literature, their use in estimation schemes on an industrial scale has been limited. A number of reasons can be identified for their low level of utilisation. Of particular significance is the uncertainty which exists in quantifying system performance and the process-model mismatch which inevitably results. The level of ‘pre-defined model’ uncertainty, together with the knowledge gained during the course of the fermentation, serves to dictate estimator structure. The paper considers a range of estimation strategies and contrasts, through industrial applications, their performance characteristics and utility.     

Using thermally stimulated currents to find defective capacitors

BaTiO₃ multilayer capacitors with a nominal capacitance of 3.5nF have been carefully measured using the thermally stimulated current (TSC) technique. When a 300V polarization voltage is applied at room temperature, a new TSC peak appeared in defective sample A after it has been immersed in water. No new peak was found in good-quality sample B after a similar treatment. The accelerated life test shows that sample A hasa much shorter life than sample B in terms of insulation resistance.     

Effects of α‐form or β‐form nuclei on polymorphic crystalline morphology of poly(butylene adipate)

The effects of α‐form and β‐form nuclei on polymorphic morphology of poly(butylene adipate) (PBA) upon recrystallization from the molten state up to various T_max values were examined by differential scanning calorimetry (DSC), wide‐angle X‐ray diffraction (WAXD) and polarized light microscopy (PLM). In this study, PBA with complex melting and polymorphism behaviour was used as a model for examining different types and extents of residual nuclei. As the PBA initially containing the sole α‐crystal was brought to a molten state of various T_max, the extents of trace α‐form crystal nuclei varied and were dependent on T_max. Furthermore, it did not matter whether, initially, the PBA contained α‐ or β‐form crystals (or both) because only a single type of α‐nuclei could be left upon treatment to the molten liquid state at T_max. Therefore, only the α‐crystal in PBA had ‘memory capacity’ in the molten liquid state while the β‐crystal did not. This was so because the latter had been completely transformed into the solid state prior to being heated into a liquid. PBA crystallized before α‐nuclei could be packed into α‐crystal, regardless of the crystallization temperature (T_c). For recrystallization from molten PBA without any nuclei, the crystalline polymorphism was correspondingly influenced by T_c. Copyright © 2005 Society of Chemical Industry     

德国大型设备的出口包装

一、前言德国作为全球几大工业国之一,是世界上有名的机械电子设备出口国。这些年来大量的德国大型设备和生产线成套设备漂洋过海出口到了中国,这些设备涉及到汽车、石油、化工、钢铁、机械、电子等行业。怎样保证这些大型设备和成套设备安全抵达中国或其它国家用户所在地,是摆在德国有关生产企业与运输包装企业面前的重要课题。本文结合作者在德国汉堡出口包装有限责任公司——塞库瑞塔斯公司(Securitas)看到的情况,介绍一下有关德国大型设备出口包装的方法。     

光纤码分多址技术在城域接入网中的应用

分析了光纤码分多址技术O -CDMA在城域接入网中的应用。回顾了O -CDMA技术的发展历史 ,详细地介绍了O -CDMA技术的特点 ,其具有的公平性、灵活性、网络控制管理、对服务区处理能力以及高的安全性使O -CDMA技术成为较好的城域接入网技术。阐述了目前在应用中O -CDMA存在的一些技术方面的问题     

MX345芯片及单片机控制

MX345芯片用于产生模拟信令—CTCSS单音.本文在介绍MX345编码/解码器工作原理的基础上,设计出MX345芯片与单片机的接口电路.最后给出控制软件.