Investigations on the Behavior of HVOF and Cold Sprayed Ni-20Cr Coating on T22 Boiler Steel in Actual Boiler Environment

High temperature corrosion accompanied by erosion is a severe problem, which may result in premature failure of the boiler tubes. One countermeasure to overcome this problem is the use of thermal spray protective coatings. In the current investigation high velocity oxy-fuel (HVOF) and cold spray processes have been used to deposit commercial Ni-20Cr powder on T22 boiler steel. To evaluate the performance of the coatings in actual conditions the bare as well as the coated steels were subjected to cyclic exposures, in the superheater zone of a coal fired boiler for 15 cycles. The weight change and thickness loss data were used to establish kinetics of the erosion-corrosion. X-ray diffraction, surface and cross-sectional field emission scanning electron microscope/energy dispersive spectroscopy (FE-SEM/EDS) and x-ray mapping techniques were used to analyse the as-sprayed and corroded specimens. The HVOF sprayed coating performed better than its cold sprayed counterpart in actual boiler environment.     

Structural,Optical, and Ferroelectric Behaviors of Cu_(1-x)Li_xO(0≤x≤0.09) Nanostructures

We report structural,optical,and ferroelectric behaviors of lithium-doped copper oxide(Cu1-xLixO with x =0.0,0.05,0.07,and 0.09) nanostructures synthesized by hydrothermal method.The XRD pattern indicates the pure phase formation of CuO without any impurity,and the crystallite size is found to be increases for x =0–0.07 and decreases for x =0.09.FESEM analysis shows that the average size of Cu1-xLixO nanostructures increases with the increasing the Li-doping concentrations up to 7% and then decreases for 9% Li doping concentration.Moreover,Raman and photoluminescence spectrum also confirm the phase formation of CuO.A significant reduction in optical band gap is observed up to x =0.07,and then band gap increases for x =0.09 due to segregation of the impurities on the surface or grain boundaries,which may suppress the grain growth and results the enhancement in optical band gap.Moreover,a weak ferroelectricity is observed in CuO nanostructures for pure and 9% Li doping through polarization versus electric field(P–E).     

Effect of velocity slip in axially undefined porous bearings

A theoretical analysis of the performance characteristics of axially undefined journal bearings was carried out. The analysis takes into account the velocity slip at the surface of the porous medium by using the Beavers-Joseph criterion. Results are presented for various bearing characteristics and compared with earlier results obtained by using the no-slip condition.     

Gallium(III) triflate: an efficient and a sustainable Lewis acid catalyst for organic synthetic transformations

Green chemical processes play a crucial role in sustainable development, and efficient recyclable catalysts that can be conveniently applied in various chemical reactions are the key elements for the development of sustainable synthetic processes. Many organic transformations rely on Lewis and Br?nsted acid catalysts, and such molecules have been widely studied in organic synthesis. Over the years, researchers have looked for Lewis acid catalysts that provide high selectivity and high turnover frequency but are also stable in aqueous media and recoverable. Since the first preparation of trifluoromethanesulfonic acid by Hazeldine (triflic acid, HOTf), researchers have synthesized and used numerous metal triflates in a variety of organic reactions. Even though the rare earth metal triflates have played a major role in these studies, the majority of rare earth triflates lack one or more of the primary properties of sustainable catalysts: low cost and easy availability of the metals, easy preparation of triflates, aqueous/thermal stability, recyclability, and catalytic efficiency. In this Account, we describe the synthetic applications of Ga(OTf)(3) and its advantages over similar catalysts. Ga(OTf)(3) can be conveniently prepared from gallium metal or gallium chloride in excess of trifluoromethanesulfonic acid (triflic acid) under reflux. Among many Lewis acid catalysts recently studied, Ga(OTf)(3) is water tolerant and soluble and requires very low catalyst loading to drive various acid-catalyzed reactions including Friedel-Crafts alkylation, hydroxyalkylation, and acylation selectively and efficiently. In many reactions Ga(OTf)(3) demonstrated high chemo- and regioselectivity, high yields, excellent stability, and recyclability. We successfully synthesized many biologically active heterocycles and their fluoroanalogs under mild conditions. Many challenging reactions such as the ketonic Strecker reactions proceed efficiently via Ga(OTf)(3) catalysis. Because it is stable in water, this catalyst provides the opportunity to study substrates and develop new synthetic protocols in aqueous media, significantly reducing the production of hazardous waste from organic solvents and toxic catalyst systems.     

Synthesis of trideuteratedO-alkyl platelet activating factor and lyso derivatives

Racemic heavy isotope analogs of 1-O-alkyl-sn-glycero-3-phosphocholine (lysoPAF) and 1-O-alkyl-2-O-acetyl-sn-glycero-3-phosphocholine (PAF) were prepared for use as internal standards to facilitate quantitative studies based on mass spectrometry. Starting from pentadencane-1,15-diol andrac-glycerol-1,2-acetonide, a convergent synthesis of 1-O-[16′-²H₃]hexadecyl and 1-O-[18′-²H₃]octadecylrac-glycero-3-phosphocholine and their acetyl derivatives is described. Three deuterium atoms were introduced at the terminal position of the 1-O-alkyl group by displacement of thep-toluensulfonyl group from 1-O-alkyl-15′-p-toluensulfonate and 1-O-alkyl-17′-p-toluensulfonate with [²H₃]-methylmagnesium iodide. The 1-O-alkyl-17′-p-toluensulfonate was obtained by reaction of the 1-O-alkyl-15′-p-toluensulfonate with allylmagnesium bromide, followed by reductive ozonolysis and treatment withp-toluenesulfonyl chloride. The hydroxyl group at C-2 was protected by a benzyl group and removed at a late stage in the synthesis. This provided the corresponding lysoderivatives or allowed preparation of racemic PAF by subsequent acetylation of the free hydroxy group. The phosphocholine moiety was introduced at glycerol C-3 by reaction with bromoethyldichlorophosphate and trimethylamine. The synthetic compounds were analyzed by FAB/MS and GC/NICIMS. They were shown to contain less than 0.6% protium impurity.     

Adhesion Science and Surface Analysis. Typical Examples

A number of surface modification methods using mechanical, chemical, electrochemical or physical processes have commonly been employed to treat adherend surfaces and improve adhesion in various bi- or multi-layered systems which play a key role in many advanced technologies. Results reported in this review paper deal more particularly with components of polymer-metal systems and provide typical examples of surface analysis obtained by x-ray photoelectron spectrometry (XPS), ion scattering spectrometry (ISS), low-energy electron induced x-ray spectrometry (LEEIXS), optically stimulated electron emission (OSEE) and Fourier transform infra-red spectrometry (FTIR). These examples concern, on the one hand, metallic adherends (aluminum, stainless steel, zinc-coated steel, gold) the surfaces of which were modified by cleaning, etching, oxidation, conversion or chemical grafting and, on the other hand, bonded joints (polyester-steel and epoxy-aluminum systems) which were delaminated using a peel test and a three-point flexure test, respectively.     

Copper‐Catalyzed C–N,C–O Coupling Reaction of Arylglyoxylic Acids with Isatins

The copper(II)‐catalyzed decarboxylative coupling reactions of arylglyoxylic acids with isatins afford 4H‐benzo[d][1,3]oxazin‐4‐ones via decarbonylation and concurrent C–N, C–O bond formation.

     

Antifungal,antiaflatoxin and antioxidant potential of chemically characterized Boswellia carterii Birdw essential oil and its in vivo practical applicability in preservation of Piper nigrum L. fruits

The study explores the chemical profile, antimicrobial and antioxidant activity of Boswellia carterii essential oil (EO). The EO significantly inhibited growth and aflatoxin production by the food borne toxigenic strain of Aspergillus flavus at 1.75 μl/ml and 1.25 μl/ml respectively. It exhibited broad fungitoxic spectrum against 12 food borne moulds and also showed strong antioxidant activity, IC₅₀ value and % inhibition of linoleic acid peroxidation being 0.64 μl/ml and 51.68% respectively. The antifungal action of EO was observed in terms of reduction in ergosterol content of plasma membrane of A. flavus. As fumigant in food system in storage containers, the EO provided 65.38% protection against fungal deterioration of Piper nigrum. GC–MS results revealed 31 components of EO. The chemically characterized B. carterii EO may thus be recommended as plant based preservative in view of its antifungal, antiaflatoxigenic, antioxidant activity and efficacy in food system.     

An investigation of the flocculation characteristics of polyacrylamide‐grafted chitosan

To investigate the flocculation characteristics of polyacrylamide (PAM)‐grafted chitosan, a series of PAM‐grafted chitosan copolymer (Chito‐g‐PAM1 to Chito‐g‐PAM4) have been synthesized by ceric ammonium nitrate‐induced solution polymerization technique in nitrogen atmosphere. The flocculation characteristics of the polymer samples (PAM, grafted and ungrafted chitosan) were studied by settling test and jar test methods in the colloidal suspensions of kaolin, iron ore, silica, and bentonite powder. It was found that the settling performance of Chito‐g‐PAM3 is best among the polymer samples. The jar test results indicate that the ungrafted chitosan has better water clarifying performance than both the PAM and grafted chitosan. © 2009 Wiley Periodicals, Inc. J Appl Polym Sci, 2009     

Phosphotungstic Acid: An Efficient Catalyst for the Aqueous Phase Synthesis of Bis-(4-hydroxycoumarin-3-yl)methanes

In this present work, we report that phosphotungstic acid provides a simple, efficient and environmentally benign route is a two-component one-pot domino Knoevenagel-type condensation/Michael reaction between 4-coumarin derivative and an aldehyde in water as a solvent in shorter duration with high yields.