PSO-IIIA(3)亚砜萃取Pt(IV)的机理

研究表明,在酸性介质中,亚砜萃取Pt(Ⅳ)的主要机理为酸性缔合,其萃合物组成为H_2PtCl_6·6H_2O·2PSO。并计算了亚砜萃取Pt(Ⅳ)的萃取平衡常数。     

Molybdate and tungstate as corrosion inhibitors for cold rolling steel in hydrochloric acid solution

The inhibition effects of molybdate and tungstate on the corrosion of cold rolling steel (CRS) in hydrochloric acid solution (0.1-0.5 M) were investigated by weight loss and electrochemistry methods. The results reveal that both molybdate and tungstate are very good inhibitors with little concentration. The adsorption of inhibitors on the CRS surface basically obeys the Langmuir adsorption isotherm equation. The effect of temperature on the corrosion behavior of CRS was also studied at 25 °C and 35 °C, the thermodynamic parameters such as adsorption heat (ΔH⁰) and adsorption free energy (ΔG⁰) were calculated. In the same conditions, a comparative study of corrosion inhibition of molybdate and tungstate indicated that molybdate was the better inhibitor in 0.1 M HCl. However, the value of percentage inhibition efficiency (IE) was dependent on the concentration of inhibitors in 0.2-0.5 M HCl. It seemed that molybdate did not have the strong inhibitive effect compared to tungstate with relatively small concentration of inhibitors, but molybdate was a better inhibitor over a wide concentration range of inhibitors. A kinetic study of cold rolling steel in uninhibited and inhibited acid was also discussed. Various parameters such as rate constant k and the kinetic parameter B were calculated for the reactions of corrosion. Polarization curves showed that both molybdate and tungstate are mixed-type inhibitors in acidic media.     

细磨活化对白钨矿浸取行为的影响SCIEI

本文研究了细磨活化对白钨矿浸取行为的影响.实验结果表明,细磨活化后白钨矿在HCl-Na_3PO_4介质中的浸出速率显著加快,钨的浸出率由原来的约8％提高到99％以上.红外光谱和X射线分析结果表明,细磨除了使白钨矿比表面积显著增大外,还在固体的表面和内部产生缺陷结构,增加了矿物表面的反应活性,改善了白钨矿的分解,使得白钨矿的浸出能在较低的温度顺利进行。     

THE EFFECT OF FURNACE ATMOSPHERE DUE TO COMBUSTION UPON HYDROGEN CONTENT IN LIQUID STEEL

<正> 在炼钢过程中,炉气中水汽是钢液中含氢的主要来源。就平炉而言,除了空气湿度和炼钢原材料带入炉中的水分以外,还有煤气燃烧生成的水汽。根据过去的研究结果,由于空气湿度直接或间接引起的水汽分压,一般波动于0.01—0.08个大气压之间,而煤气燃烧废气中的水汽分压则经常在0.1个大气压以上,有时甚至可以超过0.2     

高强度结构钢的韧性启裂和稳态扩展

研究了具有一定韧度的高强度结构钢裂纹早期扩展阻力与材料的微观组织结构、应力状态、变形历史和应变特性之间的关系。结果表明:裂纹扩展阻力(指J_R阻力曲线中的J_i和dJ/da)主要决定于裂纹尖端的塑性约束程度和应力应变场中消耗的弹性能和塑性功。这与三轴应力状态函数σ_mσ~(1/2)有关。材料的流变曲线描述了形变过程中的变形历史和应变特性,有明显的阶段性,其中第Ⅱ阶段的变形历史和应变特性制约着裂纹的启裂过程,第Ⅲ阶段的变形历史和应变特性制约着裂纹的扩展过程。应变硬化率dσ/dε可以敏感地反映出材料内部的应力分布和微观断裂机制。     

THE MIGRATION OF IMPURITY ATOMS AND HYDROGEN EMBRITTLEMENT CRACKING

<正> 一般认为裂纹材料的氢脆开裂是一个和氢原子扩散有关的过程。在负载条件下,氢原子将从四周扩散到裂纹尖端高应力区,当局部浓度达到临界值即起始开裂。开裂的每一步只能跃进一定距离,当裂纹扩展到氢含量很低的区域便暂时停止,然后,氢原子又再扩散聚集,如此往复,裂纹以不连续开裂方式向前扩展。     

A SUPERSONIC FLAME CUTTING TORCH

<正> 我们在不断改进过去的火焰切割喷嘴的基础上,经过理论计算,设计并试制成功火焰切割用超音速喷嘴,使用效果良好,现在已经推广使用。 一、纹影分析 为了鉴定并改进喷嘴的设计和制造,借助于纹影仪,可以对超音速氧射流密度梯度的变化进行观察和照相,并对氧射流流场进行定性分析。 根据理论计算,圆柱型喷嘴当其工作压力超过0.893公斤力/厘米~2(表压)时,出口     

Bioleaching of refractory gold ore （ Ⅱ ）——Mechanism on bioleaching of arsenopyrite by Thiobacillus ferrooxidans

1　ＩＮＴＲＯＤＵＣＴＩＯＮＢｉｏｌｅａｃｈｉｎｇｐｒｏｃｅｓｓｅｓｈａｖｅｂｅｅｎｕｓｅｄｅｘｔｅｎｓｉｖｅｌｙｔｏｒｅｃｏｖｅｒｂａｓｅｍｅｔａｌｓ (ｍａｉｎｌｙｃｏｐｐｅｒ)ａｎｄｕｒａｎｉｕｍｆｒｏｍｌｏｗ ｇｒａｄｅｏｒｅｓａｎｄｍｏｒｅｒｅｃｅｎ     

取向硅钢晶粒取向的不均匀分布及其检测

利用X射线衍射和背散射电子衍射检测了取向硅钢板表层和中心部位的宏观织构和微观晶粒取向分布,观察了相应的晶粒组织。结果表明,二次再结晶不彻底的成品钢板的表面会残留非{110}<001>取向的小晶粒,并影响钢板的软磁性能。取向硅钢板表层的晶粒取向分布能够在一定程度上反映出钢板的质量,因此可以借助X射线表面无损检测技术发展取向硅钢织构的工业在线检测技术。     

提高醇基镁砂粉涂料性能的研究

通过正文试验确定了高锰钢铸件使用的醇基镁砂粉涂料基本配比；并对其可点燃性、高温烧结性能进行了改进。生产试验在明：新涂料的各种性能指标显著提高，铸件表面质王明显改善。