Research on charge ordering and magnetic properties in La0.3Ca0.7Mn1-xWxO3 system

The perovskite manganite sample La0.3Ca0.7Mn1-xWxO3 （x = 0.08, 0.12） was prepared by the solid-state reaction method. The effect of W doping on the Mn site to La0.3Ca0.7MnO3 charge ordering phase and the changing process of magnetic properties were studied through the measurement of the M-T curve, M-H curves, and ESR curves of the sample. The results showed that when x = 0.08, the charge ordering （CO） phase exists in the system, the transition temperature Tco= 275 K, and the system exhibits PM when T 〉 275 K. The system transforms from spin-disordering paramagnetism to spin-ordering antiferromagnetism in the charge ordering state with the temperature decreasing from 275 K to 230 K. The long-range antiferromagnetism forms and AFM/CO states coexist between 230 K and 5 K. There is a little ferromagnetic component in the AFM/CO background in a low temperature range. When x = 0.12, the CO phase in the system has almost melted completely. There is a little remnant of the CO phase below 150 K. The system exhibits paramagnetism when T 〉 150 K and transforms from paramagnetism to ferromagnetism when T〈 150 K.     

Cr对低碳Si-Mn系TRIP钢组织与力学性能的影响

主要研究了Cr对低碳Si-Mn系TRIP钢组织与力学性能的影响。首先利用Formastor-F型膨胀仪测定了含Cr和不含Cr两种低碳钢的连续冷却转变(CCT)曲线,分析指出了Cr对连续退火工艺的潜在影响;然后采用Gleeble-3800热/力模拟试验机对两种钢的薄板试样进行了连续退火模拟实验,并通过拉伸试验测定了力学性能;最后采用金相、扫描电镜、X-射线衍射分析等技术考察分析了两种钢的显微组织。结果表明:含Cr的TRIP钢的组织比较细小,铁素体晶粒近似等轴分布;两种TRIP钢的残余奥氏体含量相近,但含Cr钢的残余奥氏体中的含碳量较高。分析认为这是由于含Cr钢在热轧阶段较易生成细小的组织,而在热处理阶段则抑制贝氏体的生成,最终获得稳定的残余奥氏体。     

Tri-Gate Bulk MOSFET Design for CMOS Scaling to the End of the Roadmap

A tri-gate bulk MOSFET design utilizing a low-aspect-ratio channel is proposed to provide an evolutionary pathway for CMOS scaling to the end of the roadmap. 3-D device simulations indicate that this design offers the advantages of a multi-gate FET (reduced variability in performance and improved scalability) together with the advantages of a conventional planar MOSFET (low substrate cost and capability for dynamic threshold-voltage control).     

涤纶复合丝（POY＋DTY）的研发

DTY和POY网络复合丝是以聚酯直纺生产的两种不同规格的POY丝为原料,通过对加弹机进行适当改造,利用不同的加工路线,使一股POY丝经过加捻后形成DTY,再与另一股POY丝网络合股形成包芯复合丝.该复合丝利用POY丝和DTY丝的收缩差异和染色差异等不同风格特性,使得布面形成一种具有雪花状的色丁效果.该复合丝属于差别化纤维,是国家鼓励发展的项目,它具有优良的吸湿排汗性能和弹性保暖性能,是保暖内衣的首选面料,市场前景广阔.     

光纤荧光传感器衰减寿命的加权对数拟合法

荧光寿命的检测是荧光光学传感器的核心内容，国际上尝试了多种方法来拟合这种理论上为单指数衰减信号的荧光衰减曲线。这些方法包括非线性函数标准拟合方法。即Levenburg-Marquardt方法，以及Prony方法、FFT方法，对数拟合法等等。为了克服在实际应用中发生的信号退化，需要在测量信号衰减寿命的同时测量信号的初始强度。文章介绍了一种加权的对数拟合法，经计算机仿真及实际数据测试均可以得到和Levenburg-Marquardt方法非常接近的结果，且拟合时间大大缩短，测量稳定性大大提高。仿真测试及具体实验测试结果显示了这种方法的有效性。该方法不仅与Levenburg-Marquardt方法的偏差曲线非常相似，而且实验测得的荧光寿命与Levenburg-Marquardt方法偏差在0．2％以内。     

几种OLED有源驱动电路中像素单元电路的分析

在有机电致发光器件两管单元有源驱动电路的基础上．分析了几种四管单元电流控制型和电压控制型的驱动电路，它们都能补偿TFT阈值电压的漂移．但都有各自的优缺点：前者能准确地调节显示的灰度，但它的响应速度慢；后者的响应速度快，但不能准确地调节显示的灰度。     

Luminescent Properties of Nanometer Si with Embedded Structure

Blue luminescence at about 431nm is obtained from epitaxial silicon after C^ implantation,annealing in hydrogen ambience and chemical etching sequentially. When annealed in nitrogen ambience and etched accordingly, there is a much narrower peak at about 430nm. During C^ implantation,C=O compounds are introduced into and embedded in the surface of nanometer Si formed during annealing,at last, nanometer silicon with embedded structure is formed,which contributes to the blue emission.     

Distributed Optical Fiber Sensor for Multi-point Temperature Measurement

The distributed optical fiber sensing technology is overviewed, which is based on Raman scattering light theory. Basic operation principle, structure, system characteristics and signal processing are discussed. This structure and method of the signal processing possess of certain spatial resolution, hence will ensure the practicability of system.     

基于TMN的电信管理网研究与实现

为解决由于电信事业的发展对电信管理网所提出的更高要求,即兼容性、可持续性、综合技术应用性等方面的要求,提供了一种基于TMN架构的电信管理网的设计实现架构,对整个系统的架构进行了概括性的分析。该系统是一个成功应用的商用系统,采用了J2EE架构,对J2EE架构的应用具有一定的启示作用。依照该架构实现的电信管理网系统,无论从软件的复用性,可扩展性及产品的功能特点等指标,均满足了当前电信事业发展的要求。