淀积条件对GDa—SiNx薄膜电学特性的影响

本文讨论了用辉光放电法制备氮化硅薄膜时衬底温度、射频功率和气体流量比对薄膜的电导率、介电常数和击穿强度的影响。通过优化生长条件，制备了优质非晶氮化硅薄膜，其介电常数为７．５、击穿强度为５．５ＭＶ／ｃｍ、电导率为１０－１３（Ωｃｍ）－１。     

水动力学数学模型并行计算技术研究及实现

基于MPI(Message Passing Interface)消息传递实现了黄河二维水动力学数学模型的并行编程。以数据的分布存储作为区域划分的依据,实现了计算量的负载平衡;在全局网格和局部区域之间建立映射关系,并且在临界单元、进出口单元、共用节点等通过规约等进行特殊处理,一方面尽可能的减少通讯量,另一方面也避免消息的阻塞。采用曙光4000A系统的8个CPU进行计算的加速比达0.8,多CPU并行计算极大的提高了计算任务的容量,使得无法在单机上完成的巨量计算成为可能。     

透过3GSM看通信业未来发展两大趋势

3GSM大会的规模一年比一年大,此次是我连续第六次参加3GSM大会.仅大会的前3天就有55,000多名参观者,使今年的大会成为最热闹的一届.     

多掺炼新疆渣油的催化裂化工业生产技术

兰州石化公司以加工新疆原油为主，重油收率高，平均在37％左右，所生产的重油主要靠催化裂化装置来加工，多余部分以低附加值重油出厂。随着涩宁兰天然气工程的逐渐建成，低附加值重油出厂将受到严重威胁，因此，催化裂化装置加工重油显得尤为重要。兰州石化公司炼油厂1.2Mt/a重催装置通过采用先进技术进行改造，使重油掺炼比由41.52%提高到52.20%，提高了10.68个百分点，年多加工重油14.95万t，产品收率达到79.20%以上，能够灵活调节产品结构，创造了良好的经济效益。     

Coplanar stripline resonators modeling and applications to filters

This paper presents coplanar stripline (CPS) resonators and their practical implementations to filters. Five types of CPS resonator are built using open and short-ended strips. Lumped-element equivalent circuits are presented for each resonator. Their performances are investigated and compared in terms of Q factor or bandwidth. Two types of bandpass filter are developed with the resonators. The bandpass filters have low-passband insertion losses and wide-stopband suppression bandwidths. Lumped-element equivalent circuits are presented for the bandpass filters. A wide-band CPS-to-microstrip transition is developed for the measurements. The back-to-back transition has an insertion loss of less than 3 dB and a return loss of better than 10 dB for the frequency range from 1.3 to 13.3 GHz (1:10.2)     

异丁烷与丁烯在炭化树脂负载PW_(12)催化剂上的烷基化

探讨了炭化树脂负载杂多酸PW1 2 催化剂制备的适宜条件 ,反应工艺条件对催化剂催化异丁烷与丁烯烷基化反应及产物分布的影响 ,分析了催化剂具有较高活性的原因 ,进行了催化剂稳定性实验。并与其它类固体酸催化剂进行了对比。     

石油系油浆与煤系闪蒸油的焦化性能——I．热解条件的影响

通过偏光显微镜观察了石油系油浆（LH）与煤系闪蒸油（SN）焦化后所得焦块的光学结构。结果表明，在较宽条件下两种原料单独焦化均得不到取向度高的流线型结构。将两种原料以一定比例混合后先热解丙焦化所得焦块的光学结构明显好于二者混合后直接焦化所得焦块的光学结构，其中LH和SN以3：2的重量比混合后在440℃、1MPa下热解3．5h然后再在530℃、1MPa下焦化8h所得焦块为具有较高取向度的流线型结构，适合于作为针状焦的起始原料。     

迅速发展的有机电致发光(OEL)显示器件

有机电致发光显示器件以其全固体、自发光、宽视角、高对比、快响应、低功耗、更轻薄等比液晶显示器件更为优越的特性 ,在小尺寸平板显示市场上正开始向 LCD挑战     

Residue curve maps for reactive distillation systems with liquid-phase splitting

A model has been developed to study the effects of chemical kinetics on the residue curve maps (RCM) for reactive distillation systems with liquid phase splitting. In the model, chemical reaction can occur in both or only one of the two liquid phases. The heating policy V/V₀=H/H₀ is applied so that the kinetic effect can be described by a single parameter, the Damköhler number Da. The effects of reaction kinetics on pseudohomogeneous and heterogeneous mixtures have been compared. The properties of their RCMs are the same outside, but are fully different inside the liquid-liquid (L-L) region if they have different chemical equilibrium curves. Inside the L-L region, the chemical equilibrium curve coincides to a unique reactive liquid-liquid tie line in case that the pseudohomogeneous chemical equilibrium curve intersects with the L-L envelope. When the reaction occurs in only one of the two liquid phases, the residue curves inside the L-L region are strongly affected by the L-L envelope, especially at high Da. In the present paper, first an illustrative arbitrary reaction system, and then the reaction of cyclohexene with water to cyclohexanol are analysed with respect to their RCMs.