Effect of Wall Surface Properties at Different Drying Kinetics on the Deposition Problem in Spray Drying

Current methods in alleviating the wall deposition problem in spray drying emphasize mainly controlling the stickiness of the drying particles and less attention is placed on the properties of the dryer wall. In this experimental study, the effect of wall surface properties on the deposition mechanism has been investigated. Properties considered in classifying different wall materials were surface energy, roughness, and dielectric properties. The model solution contained sucrose, representing low-molecular-weight sugars commonly encountered in spray drying of fruit and vegetable juices. The effect of wall properties on deposition was explored at different drying rates producing particles of different surface rigidity. Larger surface roughness produced higher deposition fluxes for particles with high impact velocity and moisture. Surface energy and surface roughness were found to have no significant effect for dry rigid particles at the middle and bottom elevation of the drying chamber. However, material with lower surface energy (Teflon) exhibited less deposition for rubbery particles at such elevations. Analysis shows that dielectric wall material (Teflon) tends to enhance deposition of dry particles because of attrition at the surface. Higher wall temperature was found to produce slightly more deposition. The results of this work give a general indication of the effect of wall material on the deposition problem and provide the fundamental understanding for further studies along this line. Proper selection of dryer wall material will provide potential alternatives for reducing the deposition problem.     

哈得逊隆起下石炭统基准面旋回与储集层预测

依据基准面旋回原理和方法,综合利用哈得逊地区的钻井、测井、地震以及地球化学资料,在研究区下石炭统识别出1个Ⅰ型和3个Ⅱ型层序界面,将哈得逊地区下石炭统划分为3个中期基准面旋回：SC1、SC2、SC3,对应于早石炭世海侵的3个海进-海退旋回.SC1旋回以滨岸砂坝沉积为主,而SC2、SC3旋回发育潮坪沉积体系.研究认为,SC1旋回滨岸砂岩及SC2下降半旋回的潮间带薄层砂岩为有利储集砂体,是地层-岩性型油气藏的重点勘探目标.     

一台循环流化床锅炉U型二次分离的改进对过热器爆管的影响

文章通过对一台循环流化床锅炉U型二次分离装置的改进，减少了过热器爆管的介绍，给出了采用多次离心分离技术，改善和提高烟尘分离效率，从而改善过热器外部工作条件，达到减少爆管发生的措施，相应提出了一些有关的建议。     

厦门市筼筜湖城市防汛排涝现状及其对策

本文通过分析筼筜湖的自然概况、防汛排涝系统设施及实际运行等资料,提出进一步提高筼筜湖防汛排涝能力的对策。     

基于作业测定技术的后桥壳生产线工艺评价及优化

以某企业后桥壳生产线为研究对象,运用作业测定技术中的时间研究法,测定后桥壳各工序的标准时间,评价工艺及找到瓶颈工序;运用"5W1H"提问技术,根据"ECRS"原则,同时结合工艺设计及企业资源情况,对后桥壳生产线现有工艺进行评价及优化,改善后,使生产线的产能每天提高了10件,生产能力提高了33.57%.     

One-to-Many and Many-to-One Optical Chaos Communications Using Semiconductor Lasers

A theoretical construction of one-to-many (OTM) and many-to-one (MTO) chaos synchronization communications using semiconductor lasers is presented. One center laser provides strong injections (strong link) to other side lasers, and the side lasers also provide weak injections (weak link) to the center one. Simulation results show that the side lasers synchronize with the center laser through injection-locking. In addition, messages transmitted via the strong links or the weak links experience strong chaos pass filtering, enabling us to realize OTM and MTO communications.     

影响混凝土强度的因素及控制措施

分析了水泥强度等级、水灰比和骨料质量等内因,及施工条件、养护温度、湿度、龄期等外因对混凝土强度的影响,并提出了控制混凝土强度的相应措施,以确保混凝土强度符合设计及施工要求,从而保证建筑物结构安全。     

偏振化能量色散X射线荧光光谱仪的新进展

能量色散X射线荧光光谱仪,由于其仪器本身结构比较简单,X射线的分析线强度利用率高,又能同时接受所有X射线光谱,近年来逐渐被广泛采用.特别半导体技术飞跃发展,促使半导体探测器分辨能力的提高,目前商品化的Si(Li)漂移探测器在MnKα5.9 keV处和计数率在10000cps以下时,其能量分辨率已达157 eV,这样大大扩大它的使用.从长远观点看,1998年47届Denver会议上,美国国家标准技术研究院(NIST)提出3 eV微热量计(micro calorimeter),其能量分辨率几乎可达到波长色散水平.当然目前由于成本昂贵,还没有达到实用阶段,另外偏振化技术的应用,使谱线散射背景大大降低,使能量色散X射线荧光痕量分析已达μg/g级,并成为地质、环保、冶金材料的科研和生产主导分析方法之一.从1992年开始斯派克分析仪器公司就开始生产偏振化能量色散X射线荧光光谱仪.     

化学还原法制备纳米铜粉的研究

本文采用KBH4在液相中化学还原CuSO4,并加入KOH和络合剂EDTA ,制得了纳米级的纯净的铜粉 ,通过调整反应物的浓度 ,可以消除Cu2 O等杂质。制备的纳米铜粉还存在一定程度的团聚 ,需试验加入分散剂来改善。