氟塑料—石墨板式换热器在高温强腐蚀换热工况中的应用

通过氟塑料－石墨板式换热器在化纤生产中高温强腐蚀换热工况中的实际应用，并与常规换热器的使用情况的对比分析，阐述了这种新型换热设备的特点。     

邻—(4—乙基苯甲酰基)苯甲酸的研究

本文阐述了通过Friedel-Crafts反应合成邻-(4-乙基苯甲酰基)苯甲酸的方法.研究了影响产物质量的因素,提出了适宜的工艺条件.     

插补法CAI研究

数字程序控制计算机辅助教学是将计算机技术用于数字程序控制的教学过程，它帮助学生学习并模拟教学实验．本文介绍了数字程序控制中直线插补和圆孤插补的ＣＡＩ实现方法．     

Trends and variations in neonatal length of in-hospital stay in Canada

The objectives of this study were to evaluate the possible mechanisms involved in prolongation of bleeding time in pre-eclamptic patients receiving a magnesium sulfate infusion to prevent convulsions. Eighteen pre-eclamptic patients near term or at term (4 cases 33 to 35 weeks; the remainder > 36 weeks) were studied. Fifteen of them received magnesium sulfate infusion; 3 did not and served as controls. Bleeding time (modified Ivy method with Surgicutt), platelet count, platelet aggregation pattern, as well as serum arachidonic acid metabolites [thromboxane B2 (TxB2) and 6-Keto-prostaglandin F1 alpha (6-Keto-PGF1 alpha)] werde done on admission to the labor floor (before magnesium infusion) and repeated at discontinuation of the infusion, 12-24 hours postpartum; the controls received the second test 24 hours postpartum. Thirteen of 15 patients receiving magnesium sulfate had an increase in bleeding time from an average of 6 minutes 31 seconds to 11 minutes 56 seconds, an 82% rise (p < 0.004). In 2 there was a decrease. Among the 3 controls the averages were 6 minutes 38 seconds and 6 minutes 3 seconds. The total magnesium given ranged from 52.5 to 145 grams. Platelet counts averaged 251,000/mm3 (range 145,000-519,000). Platelet aggregation pattern done in 11 patients and was normal and unchanged after magnesium in 10 of the patients with increased bleeding time and one control. TxB2 and 6-Keto-PGF1 alpha levels did not change significantly either after magnesium administration (688 and 135 pgm/ml, to 654 and 117) or in controls (695 and 230 pgm/ml, to 445 and 225). Likewise, the ratio of these 2 substances did not change in either group (6.3 to 6.6, and 4.2 to 2.2). There was no correlation between duration of infusion or total magnesium given and directions of small changes observed. This study confirms a prior preliminary observation that magnesium sulfate infusion, as currently used to prevent eclamptic convulsions, induces a significant prolongation of bleeding time. This effect is mediated neither by changes in platelets count or aggregation pattern, nor by changing the level or ratios of serum arachidonic acid metabolites (TxB2 and 6-Keto-PGF1 alpha). Further studies are needed to clarify the mechanism of this clinically important observation of increased bleeding following magnesium sulfate infusion.     

提高柴油机缸盖内腔铸造质量的工艺措施

缸盖是柴油机上的重要零件之一。铸造毛坯不可避免地存在劈缝、内腔粘砂、粗糙、局部不通等内腔质量问题 ,从而影响缸盖串水冷却效果。本文介绍了一些工艺措施 ,较好地解决了这个问题。     

莲心中可溶性成分的有效提取

采用不同的原料处理,改变提取的流程和提取时间，测定不同条件下所得提取液的可见吸收光谱，以此反映各提取液的组分和浓度是否发生变化，并比较在最大吸收波长下各提取液的吸光度大小，从而确定将莲心捣碎后，加热回流时间为60min的提取方法效果最佳。     

H.248协议在UMTS核心网中的应用

描述了H.248协议的连接模型和消息结构,分析了H.248协议在UMTS核心网中的实现方案,并给出了一个应用实例,最后探讨了实现中可能面对的问题和解决方案。     

喷射轧制Fe-4.5%Si硅钢片的组织和性能

采用喷射成形和轧制工艺制备了厚度为0.5mm的Fe-4.5%Si高硅钢片，并对其密度、显微组织和电磁性能进行了测试分析，研究结果表明：在最佳的喷射成形和轧制工艺条件下，所制备硅钢片的磁感应强度B25为1.544T、B50为1.641T；铁损P1050为1.437W/kg、P1550为3.43W/kg，说明喷射成形轧制技术可以制备出高磁感应强度、低铁损的高硅钢片。     

二维谐振子与二维氢原子的能量及波函数

借助于ＳＵ(１,１)代数,找出了二维谐振子与二维氢原子的能量及波函数间的关系．     

Si衬底上Ta-N/Cu薄膜性能研究

对Si衬底上Ta-N/Cu薄膜进行了电学和热学分析，结果发现500℃以下薄膜电随几乎不变，600-690℃下的退火引起的电阻率降低是由于Ta-N电阻的热氧化和Cu熔化扩散引起的，而690℃以上的电阻率增加是由于Cu引线传输能力减弱所致，为0.18μm以下的超大规模集成电路中的Cu引线和电阻薄膜的制作提供了有益的借鉴。