The effects of plasma etching induced gate oxide degradation onMOSFET's 1/f noise

The effects of the plasma etching process induced gate oxide damages on device's low frequency noise behavior are investigated on MOSFET's fabricated with different field plate perimeter to gate area ratio antennas. Abnormal 1/f noise spectrum with a shoulder centered in the frequency range of 100 and to 1 kHz was frequently observed in small geometry devices, and it is attributable to a nonuniform distribution of oxide traps induced by plasma etching process     

A newly robust controller design for the position control ofpermanent-magnet synchronous motor

A robust controller which is designed by employing variable-structure control and linear-quadratic method is presented for a permanent-magnet synchronous motor (PMSM) position control system. It is to achieve accurate control performance in the presence of plant parameter variation and load disturbance. In addition, it possesses the design flexibility of the conventional state feedback control. It is applied to the position control of a PMSM. Simulation and experimental results show that the proposed approach gives a better position response and is robust to parameter variations and load disturbance     

COIL中BHP浓度对发生O_2(~1△)的影响

本文实验研究了BHP的浓度对产生O2（1△）的影响。实验结果表明：当BHP浓度大于3.5M时，Cl2利用率以及O2（1△）的产率将不依赖于BHP浓度的变化而变化，同时，实验结果表明，使用低浓度的BHP对COIL的操作是可行的。     

Optical dot gain on newsprint determined with the Lund nuclear microprobe

A technique for measuring optical dot gain, i.e. the relative difference between the actual screen dot and the optically perceived one, is presented. By combining measurements from the non-optical nuclear microprobe with data from image analyzing technique the optical dot gain can be determined. The procedure to reach pixel by pixel correlation on a micrometer scale is discussed. In the newsprint sample studied in this investigation a typical optical dot gain between 15 and 20% was deduced. The variation in the optical dot gain was correlated with other characteristic parameters of the print and newsprint and especially a positive correlation to the mass density of the newsprint was observed.     

铝液夹杂物检测DMIRT－Ⅲ法的试验研究

提出了一种新的铝液夹杂物快速检测方法。导出了该法的检测原理方程。分析并试验研究了影响检测重复性和分辨率的因素。试验选择了较好的检测参数，并获得了较好的检测结果。     

Reply to comments on “Error rate performance of theprojection code”

The authors reply to the comments by Koppelaar and Tolhuizen (see ibid. vol.46, no.9, p.573, 1998). They state that the optimum choice of the slopes used to perform the encoding process in a projection code always results in maximizing the minimum Hamming distance so that d=2 ^r     

Two-level optimal output feedback stabilizer design

The paper addresses the design of two-level power system stabilizers using an optimal reduced order model whose state variables are torque angles and speeds. The reduced order model retains their physical meaning and is used to design a two-level linear feedback controller that takes into account the realities and constraints of electrical power systems. The two-level control strategy is used, and a global control signal is generated from the output variables to minimize the effect of interactions. The effectiveness of this controller is evaluated and a multimachine system is given as an example to illustrate the advantages of the proposed method. Responses of the system with a two-level scheme and an optimal reduced order scheme are included for comparative analysis.