分布式光纤拉曼放大器的增益平坦设计

介绍了在波分复用（WDM）系统中分布式光纤拉曼放大器（FRA）的理论分析模型。在此基础上，对增益平坦设计所需考虑的因素进行了分析；最后通过试验证明了它的有效性。     

Hf-doped and NH/sub 3/-nitrided high-K gate dielectric thin film with least drain current degradation and flatband voltage shift

A novel technique to form high-K dielectric of HfSiON by doping base oxide with Hf and nitridation with NH/sub 3/, sequentially, is proposed. The HfSiON gate dielectric demonstrates excellent device performances such as only 10% degradation of saturation drain current and almost 45 times of magnitude reduction in gate leakage compared with conventional SiO/sub 2/ gate at the approximately same equivalent oxide thickness. Additionally, negligible flatband voltage shift is achieved with this technique. Time-dependent dielectric breakdown tests indicate that the lifetime of HfSiON is longer than 10 years at V/sub dd/=2 V.     

基于子波变换的涡街流量传感器信号分析

长期以来 ,如何提取潜在噪声下的涡街流量信号一直是个问题。流体流速脉动 ,局部阻力 ,随机振动———所有这些因素都给解决这一问题带来难度。文章应用子波变换消噪理论 ,从软件滤波的角度分析了强噪声干扰下的涡街流量信号 ,并提出了单支重构计数方法。分析结果表明 ,这种方法对低流速流量计量效果很好 ,能够有效地扩展量程下限     

Ripple: a wireless token-passing protocol for multi-hop wireless mesh networks

This work presents a wireless token-passing protocol, named Ripple, for wireless mesh networks (WMNs). In contrast to existing random-access approaches, Ripple uses a decentralized controlled-access approach to protect nodes from unintentional packet collisions and maximize the spatial reuse. The performance of Ripple under an error-free wireless channel was investigated and the accuracy of the analysis was verified by simulation. Simulation results also indicated that Ripple achieved throughput, stability, and QoS enhancement than that of 802.11 DCF under a highly loaded situation.     

羧酸系列集油剂的水面集油性能

研究了十二烷酸、十四烷酸、十六烷酸和十八烷酸在淡水中的集油能力。结果表明，这4种羧酸在淡水表面的表面膜压随其分子中碳数的增加而增大。其中后两者的表面膜压高达45～50mN／m，显著高于各类油膜膜压，满足集油剂对表面活性物质膜压的要求。4种脂肪羧酸在淡水中使柴油油膜的收缩率在1min时达到最大值，分别为80．0％、81．8％、83．8％和88．2％。它们的己醇、正庚醇、正辛醇、仲辛醇溶液的集油持续性，总体上随羧酸分子碳数增加而增大。其中十六烷酸和十八烷酸集油能力非常接近，它们的正庚醇、正辛醇和仲辛醇溶液使柴油膜面积收缩率在120h后仍保持在66．0％～70．2％。该类集油剂毒性低，易为生物降解，有实际应用前景。     

High-frequency small signal AC and noise modeling of MOSFETs for RFIC design

High-frequency (HF) AC and noise modeling of MOSFETs for radio frequency (RF) integrated circuit (IC) design is discussed. A subcircuit RF model incorporating the HF effects of parasitics is presented. This model is compared with the measured data for both y parameter and f_T characteristics. Good model accuracy is achieved against measurements for a 0.25 μm RF CMOS technology. The HF noise predictivity of the model is also examined with measured data. Furthermore, a methodology to extract the channel thermal noise of MOSFETs from HF noise measurements is presented. By using the extracted channel thermal noise, any thermal noise models can be verified directly. Several noise models including the RF model discussed in this paper have been examined, and the results show that the RF model can predict the channel thermal noise better than the other models     

Fabrication of 1.55 μm VCSELs on Si using metallic bonding

Using AuGeNiCr multilayered metals as the wafer bonding medium, long-wavelength GaInAsP/InP vertical cavity surface emitting lasers employing Al-oxide/Si as the upper and lower distributed Bragg reflectors were fabricated on Si substrate with the bonding interface formed outside the vertical cavity surface emitting laser cavity. Laser emission at 1.545 μm was measured under pulsed operations near room temperature. The low-temperature metallic bonding process demonstrates a great potential in device fabrication     

A fully soft-switched extended-period quasi-resonantpower-factor-correction circuit

This paper presents the design criteria, procedure, and implementation of a soft-switched power-factor-correction (PFC) circuit based on the extended-period quasi-resonant (EPQR) principles. All power electronic devices including switches and diodes in the circuit are fully soft switched. The design method is demonstrated in a prototype circuit. The operating principles are confirmed with computer simulation and experimental results. A comparison of the EP-QR operation and zero-voltage-transition (ZVT) pulse-width modulation (PWM) method     

参数化图形库技术

本文论述了参数化图形库的实现原理，建立了以尺寸叠加算法为基础的参数化图形库开发工具，利用这种开发工具建立的图形数据可以由数据库管理，方便有效。     

超声波车辆车轴探头的研制与应用

提出了一种用于检测在役车辆车轴产生疲劳裂纹的超声波方法,设计了中心孔探头与斜角探头一起,完成了对车辆车轴的关键区域探伤。