Cd-ZSM-5沸石催化剂的制备、表征和芳构化催化性能

采用离子交换、浸渍和混合三种方法制备镉改性ZSM-5沸石催化剂,考察了改性方法和镉含量对催化剂的表面酸性和Cd状态以及芳构化性能的影响。结果表明,加入镉降低了B酸性,Cd~(2+)与沸石结合形成了L_(1612)酸中心,其生成量取决于改性方法和Cd含量,并与芳构化活性提高有直接关系。     

Clinical study in epidural injection with lappaconitine compound for post-operative analgesia

In this study, the effect and side-effect of epidural injection with lappaconitine compound for post-operative analgesia was observed. One hundred and twenty patients were randomly divided into 4 groups. Lappaconitine compound (LB) consisted of 12 mg of lappaconitine and 22.5 mg of bupivacaine, was given to group A (the group of observation), and lappaconitine 12 mg, bupivacaine 22.5 mg and morphine 2 mg to group B, C and D respectively for control. All were given by epidural injection with single blind method during post-operative pain of incision operation. Result showed that the initiating of analgesia was quicker in group A and C than that in group B and D, and the efficacy was group D > A > C > B. There was significant difference between group A and B in the above two parameters, P < 0.01 and P < 0.05. The analgisia maintenence time of single injection was D > A > B > C, that of group D was significantly longer than that of group A (P < 0.01). It indicated that the epidural injection with LB was more rapid and potent than that with lappaconitine alone in post-operative analgesia, and the former had no side-effect, it was safer than morphine.     

离子注入中污染的产生及防护

本文概述了离子注入过程中污染产生的原因和防止污染的措施，特别强调了对微粒污染和金属污染的防护以满足ＵＬＳＩ加工对离子注入的要求。     

Normal-incidence InAs self-assembled quantum-dot infrared photodetectors with a high detectivity

An InAs/AlGaAs quantum-dot infrared photodetector based on bound-to-bound intraband transitions in undoped InAs quantum dots is reported. AlGaAs blocking layers were employed to achieve low dark current. The photoresponse peaked at 6.2 /spl mu/m. At 77 K and -0.7 V bias, the responsivity was 14 mA/W and the detectivity, D*, was 10/sup 10/ cm/spl middot/Hz/sup 1/2//W.     

High-frequency small signal AC and noise modeling of MOSFETs for RFIC design

High-frequency (HF) AC and noise modeling of MOSFETs for radio frequency (RF) integrated circuit (IC) design is discussed. A subcircuit RF model incorporating the HF effects of parasitics is presented. This model is compared with the measured data for both y parameter and f_T characteristics. Good model accuracy is achieved against measurements for a 0.25 μm RF CMOS technology. The HF noise predictivity of the model is also examined with measured data. Furthermore, a methodology to extract the channel thermal noise of MOSFETs from HF noise measurements is presented. By using the extracted channel thermal noise, any thermal noise models can be verified directly. Several noise models including the RF model discussed in this paper have been examined, and the results show that the RF model can predict the channel thermal noise better than the other models     

LDD方法在提高电路工作电压中的应用研究

研究了利用轻掺杂漏结构来制作高电源电压器件的工艺方法。分析了ＬＤＤ结构参数对器件击穿特性的影响，并结合实验结果对Ｎ＾－区的注入剂量，长度及引入的串联电阻进行了优化设计。     

NMOS器件两次沟道注入杂质分布和阈电压计算

分别考虑了深浅两次沟道区注入杂质在氧化扩散过程中对表面浓度的贡献。对两次注入杂质的扩散分别提取了扩散系数的氧化增强系数、氧化衰减系数和有效杂地系数，给出了表面浓度与工艺参数之间的模拟关系式，以峰值浓度为强反型条件计算了开启电压，文章还给出了开启电压、氧化条件、不同注入组合之间的关系式。     

A new image coding algorithm using variable-rate side-matchfinite-state vector quantization

A new side-match vector quantizer, NewSMVQ, is presented in this paper. Three techniques are incorporated to improve the image quality, encoding speed, and bit rate for compressing images. The experimental result shows: i) the encoding time of NewSMVQ is almost 7 times faster than that of SMVQ (ordinary fixed-rate side-match vector quantizer) and CSMVQ (variable-rate SMVQ) and ii) NewSMVQ outperforms SMVQ and CSMVQ in terms of bit rate versus image quality tradeoffs.     

Recording of volume hologram using a beam pattern from taperedoptical fiber

A photorefractive volume hologram was recorded and probed using light diffracted from a tapered optical fiber as a reference beam. A single-mode fiber (SMF) was chemically etched and tapered to give a complicated beam pattern, and it is shown that the tapered optical fiber can be utilized to increase the storage density of the volume hologram. Spatial selectivity of the volume hologram with this method was increased by two times compared to the normal SMF referencing, which is due to the fact that the complicated beam pattern has little correlation with its shifted version     

Revised cutoff values of serum aminotransferase in detecting viral hepatitis among CAPD patients: experience from Taiwan, an endemic area for hepatitis B

BACKGROUND: To determine the best cutoff values of aspartate aminotransferase (AST) and alanine amino-transferase (ALT) in detecting viral hepatitis C infection among patients of continuous ambulatory peritoneal dialysis (CAPD). METHODS: 90 (44 male and 46 female) CAPD patients and 526 adult controls (266 male, 260 female) were enrolled. Serum AST and ALT were measured by an auto-analyser monthly. Serum HBsAg was examined using a RIA method and anti-HCV by an second-generation EIA method. The best cutoff values of AST and ALT for detecting viral hepatitis were obtained from the ROC (receiver-operating characteristic) curve. RESULTS: The prevalence of anti-HCV(+) was significantly higher in CAPD patients (16.7%) than in normal controls (4.9%), while that of HBsAg(+) was similar in both groups. CAPD patients had significantly lower levels of serum aminotransferases compared to normal controls. Mean AST were 23.8 IU/l in normal control and 18.8 IU/l in the CAPD patients (P < 0.001). Mean ALT were 21.9 IU/l in normal controls and 15.3 IU/l in the CAPD patients (P < 0.001). CAPD patients with HCV infection had higher serum AST and ALT levels than those without. However, HBV infection did not cause significant serum aminotransferase elevation in patients. The conventional cutoff values of AST (40 IU/l) and ALT (40 IU/l) for detecting viral hepatitis yielded only a sensitivity of 27.3 and 18.2% respectively; on the contrary, our revised cutoff values of AST (24 IU/l) and ALT (17 IU/l) had better sensitivities (AST, 72.7%; ALT, 63.6%). For serial aminotransferase values, the sensitivity of AST and ALT for detecting HCV were 36.4 and 27.3% by conventional criteria, and were both 81.8%, by our newly revised criteria. CONCLUSIONS: Serum aminotransferase cutoff values should be modified for screening viral hepatitis in a CAPD population. Our new cutoff criteria had important clinical implications in providing benefits of earlier detection and possible prevention from chronic hepatic deteriorations.