外加剂混凝土动态与静态坍落度损失的流变特性

本文对动、静态下混凝土坍落度损失的规律进行了研究,并从流变学的角度分析了外加剂对动、静态下混凝土坍落度损失的影响坍落度损失存在差别的原因.     

单光子时间分辨在线谱仪系统中的接口电路

本文介绍单光子时间分辨在线谱仪系统中的多道分析器与IBM PC/XT微型计算机接口的工作原理及控制程序。     

石油系油浆与煤系闪蒸油的焦化性能——I．热解条件的影响

通过偏光显微镜观察了石油系油浆（LH）与煤系闪蒸油（SN）焦化后所得焦块的光学结构。结果表明，在较宽条件下两种原料单独焦化均得不到取向度高的流线型结构。将两种原料以一定比例混合后先热解丙焦化所得焦块的光学结构明显好于二者混合后直接焦化所得焦块的光学结构，其中LH和SN以3：2的重量比混合后在440℃、1MPa下热解3．5h然后再在530℃、1MPa下焦化8h所得焦块为具有较高取向度的流线型结构，适合于作为针状焦的起始原料。     

Total transfer capability computation for multi-area power systems

This paper presents a method for multi-area power system total transfer capability (TTC) computation. This computation takes into account the limits on the line flows, bus voltage magnitude, generator reactive power, voltage stability, as well as the loss of line contingencies. The multi-area TTC problem is solved by using a network decomposition approach based on REI-type network equivalents. Each area uses REI equivalents of external areas to compute its TTC via the continuation power flow (CPF). The choice and updating procedure for the continuation parameter employed by the CPF is implemented in a distributed but coordinated manner. The proposed method leads to potential gains in the computational efficiency with limited data exchanges between areas. The developed procedure is successfully applied to the three-area IEEE 118-bus test system. Numerical comparisons between the integrated and the proposed multi-area solutions are presented for validation.     

Monoalkyl Esters of Isoalkylphosphonic Acid as Extractants in Rare Earth Separation

Four monoalkyl esters of isoalkylphosphonic acids have been studied for the chromatographic separation ofrare earths (RE).The relationship between distribution ratios and acid concentration of the eluants forsamarium and ytterbium has been explored.The characteristics of these extractants loaded onto macroreticularpoly (methyl methacrylate) resin beads for the separation of lanthanum,cerium,praseodymium and neodymiumhave been compared.Among the extractants studied,mono(1-methylheptyl) ester of isooctylphosphonic acidwas found to be the best for RE separation.The acidity for separation is lower than any known P-containingextractants for the same purpose.For instance,with 1.73 mol·L~(-1) nitric acid as eluent,thulium,ytterbium andlutetium can be separated quantitatively.The extractant-loaded resins possess high column efficiency with goodkinetic characteristics.The extraction mechanism was also explored.     

Stability analysis of regional and national voting schemes by a continuous model

The previous discrete-model-based stability analysis of regional and national voting has been extended to a continuous-model-based analysis in the simultaneous presence of white and concentrated components of noise, reconfirming the previous conclusion that regional voting with smaller sized regions always demonstrates an improved stability over those with larger sized regions, including the national voting in its limiting case in particular. The conclusion remains valid as long as the weak distribution assumption is valid.     

Ultrasonic thin-walled tube wave structure for sensing devices

Theoretical and experimental investigations of thin-walled tube acoustic wave devices for gravimetric sensing applications are presented. Integrated sensor configurations have been demonstrated by employing a sol-gel processed thin piezoelectric lead zirconate titanate (PZT) film. This was coated coaxially on stainless steel tubes and interdigital transducers (IDT) fabricated as the transmitter and receiver on the curved tube surfaces. We have observed tube waves along both the axial and circumferential directions between 1 and 6.6 MHz. We have also analyzed the mass sensitivities of different modes propagating along the tubes and shown that high mass sensitivity can be achieved by keeping the tube wall thin     

Stability of Mixtoxantrone Hydrochloride in Solution

A stability-indicating reversed-phase high performance liquid chromatographic method was developed for the detection of mitoxantrone HC1 and its degradation products under accelerated degradation conditions. The degradation kinetics of mitoxantrone HC1 in aqueous solution over a pH range of 1.18 to 7.20 and its stability in propylene glycol-or polyethylene glycol 400-based solutions were investigated. The observed rate constants were shown to follow apparent first-order kinetics in all cases. The pH-rate profile shows that maximum stability of mitoxantrone HC1 was obtained at pH 4.01. No general acid or base catalysis from acetate or phosphate buffer species was observed. The catalysis rate constants on the protonated mitoxantrone imposed by hydrogen ion water and hydroxy ion were determined to be 3.72 × 10 min^-1 5.64 × 10-min^-1 and 1.108 × 10^-2min^-1, respectively. The degradation rate constants of mitoxantrone affected by different ionic strength systems. Irradiation with 254 nm UV light at 25±0.5°C was found when canpared with the light-protected controls. Incorporation of nonaqueous propylene glycol or polyethylene glycol in the pH 4.01 mitoxantrone solution shows an increase in its stability at 502±0.5°C.     

Cast bulk ZrTiAlCuNi amorphous alloys

Cylindrical bulk amorphous samples with diameters up to 10 mm have been prepared by casting ZrTiAlCuNi alloys in a copper mould. In order to rank glass-forming ability as a function of alloy composition, alloys were also cast into wedge-shaped moulds; to a first approximation, the thickness of the amorphous region obtained can be taken as an indication of glass-forming ability. The compositions which lead to the production of bulk glasses all have reduced glass transition temperatures in excess of 0.65 and the extremely high glass-forming ability of these compositions is discussed. We suggest that both the Al and Ti contents are determining factors for the production of bulk amorphous samples and these are believed to reduce the driving force for, and hence the rate of, crystallisation. These amorphous alloys have been found to display high thermal stability and can be annealed for several minutes in the supercooled liquid region. They are ductile at room temperature and have a high value of yield stress.