太钢4号高炉喷煤站应用MFD—Ⅲ型布袋除尘器的实践

太钢４号高炉喷煤站从１９９０年起采用ＭＦＤ－Ⅲ型脉动反吹式布袋除尘器。这种除尘器采用脉动式反吹清灰设施，合理布置布袋间距，布袋支撑骨架及选用针呢材质的布袋，过滤面积大，反吹清灰效果好，设备运行平稳，除尘效率高达９９．８％，排放浓度小于１０ｍｇ／ｍ＾３，故障率低。     

Analysis of thin walled structures using the boundary element method

In this article the direct boundary element formulations of stretching and bending plate problems are combined together to solve thin walled structures and other similar frames. The final system is obtained by assuming each individual plane structural element as a subregion. After the necessary transforms of these equations they can be combined together taking into account the displacement compatibility and equilibrium conditions.     

Experimental densities for compressed R134a

This paper reports densities of compressed R134a (1,1,1,2-tetrafluoroethane) determined by using a contiuously weighed pycnometer at 20 K intervals between 180 and 380 K at pressures from slightly greater than the vapour pressure to 70 MPa. The results are accurate to within ±0.1%. Saturated liquid densities derived by extrapolation from the experimental values agree with other reported values to within ±0.3%.     

Tc trend in high-Tc superconductors

In our previous works, we have shown that most existing ceramic superconductors can be considered to be built of superconductor-semiconductor composite and we have estimated the change in phonon spectrum of the intrinsic superconductor unit if a semiconductor unit is attached to it. Moreover, the proximity effect under the size quantization condition has been examined in the superconductor-semiconductor composite. Each of the stated effects by itself could causeT _c enhancement in general as more semiconductor blocks are added to the system. We extend our study in this paper to analyze the combined actions of phonon spectral change and proximity effect without size quantization condition onT _c variation in members of the Tl₁ series of high-T _c superconductors. Our results indicate that an optimumT _c is obtained if the stated effects are included in the idealized unit cells of the superconductors made up of a superconductor-semiconductor array.     

Depth of intergranular oxygen diffusion during environment-dependent fatigue crack growth in alloy 718

The elevated-temperture fatigue crack growth behavior in alloy 718, when subjected to a loading frequency lower than the transitional frequency of this alloy, is viewed as fully environment dependent. In this process, the crack growth increment per loading cycle is assumed to be equal to the intergranular oxygen diffusion depth at the crack tip during the cycle effective oxidation time. In order to identify the trend of this diffusion depth an experimental program was carried out on compact tension specimens made of alloy 718 at 650 °C in which fatigue crack growth measurements were made for cyclic load conditions with and without hold time periods at minimum load level. This work resulted in establishing a relationship correlating the intergranular oxygen diffusion depth and the value of the stress intensity factor range ΔK. This relationship, when integrated over the cycle effective oxidation time, results in a closed-form solution describing the environment-dependent fatigue crack growth rate. A comparison is made between the results of this solution when applied to different loading frequencies and the corresponding experimental results. This comparison shows good agreement between the two sets of results. Furthermore, by combining the parabolic rate law of diffusion and the equation for the intergranular oxygen diffusion depth, an explicit expression for the oxygen diffusivity of grain boundaries is derived. It is found that this diffusivity is both a ΔK- and a frequency-dependent parameter.     

最佳基数排序

基数排序由于其效率高而被广泛应用。通常,基数排序所用的基数是10,然而,如果求得一个基数r_(best),并且用r_(best)为基数进行基数排序使排序时间达到最小,则这将具有非常重要的意义。本文给出了求r_(best)的方法,分析了以r_(best)为基数进行基数排序的时间复杂度,提出了进一步提高效率的措施,并将以r_(best)为基数的基数排序速度与以10为基数的基数排序进行了比较。     

��Ȼ����������ϵͳ�ļ춨��У׼

当前我国管道天然气计量系以体积表示，就其计量器具而言，差压式流量计、容积式流量计和速变式流量计都有，但大流量计量大多仍采用标准孔板差压式流量计，其流量计量标准招待我国SY／T6143－1996《天然气流量的标准孔板计量方法》。文章介绍目前常用的三种流量计的优缺点比较；天然气标准孔板差压式流量计算机自动计量系统的检定，其中包括：标准孔板节流装置，静压、差压变送器、温度传感器、数据采集系统等组件的检定；以及计量器具的正确使用和维护。最后，文章指出目前流量计量的发展主要是二次仪表的发展，籍助应用计算机大大提高流量法的测量范围和准确度，但对用户来说，应选择性／价比合适的仪表，并要考虑所选用仪表要便于检定、维护，同时，计量检定部门则应跟上发展，为广大用户提供技术支持。     

我国车用汽油的发展概况及发展方向探讨

介绍了我国车用汽油的发展轨迹 ,通过与国外先进标准的对比分析了我国车用汽油存在的不足 .指出我国在加入WTO后 ,更应不断升级车用汽油质量标准 ,需要从标准制定、炼油技术等多方面追赶世界先进水平 ,积极研制生产清洁型无污染汽油 ,从根本上消除汽车尾气对环境的污染 .