尼龙1010的流变性能研究

用XLY-Ⅱ重型毛细管流变仪研究了尼龙1010的流变特性。实验结果表明,尼龙1010为假塑性流体;在210～250℃范围内,其非牛顿指数π为0.63～0.71;恒γw＇下的粘流活化能随γw＇的增大而减小。     

High voltage (>1kV) and high current gain (32) 4H-SiC power BJTs using Al-free ohmic contact to the base

This letter reports the design and fabrication of 4H-SiC bipolar junction transistors with both high voltage (>1kV) and high dc current gain (/spl beta/=32) at a collector current level of I/sub c/=3.83A (J/sub c/=319 A/cm/sup 2/). An Al-free base ohmic contact has been used which, when compared with BJTs fabricated with Al-based base contact, shows clearly improved blocking voltage. A specific on-resistance of 17 m/spl Omega//spl middot/cm/sup 2/ has been achieved for collector current densities up to 289 A/cm/sup 2/.     

Fabrication and characteristics of high-speed implant-confined index-guided lateral-current 850-nm vertical cavity surface-emitting lasers

Process technology of high-speed implant-apertured index-guide lateral-current-injection top dielectric-mirror quantum-well 850-nm vertical cavity surface-emitting lasers (VCSELs) has been developed. Oxygen and helium implantation for aperture definition and extrinsic capacitance reduction, dielectric mirror formation, p- and n-ohmic contact formation, VCSEL resistance, and thermal analysis were investigated. Employing this technology, GaAs/AlGaAs-based 850-nm VCSELs with small signal modulation bandwidths up to 11.5 Gb/s and an eye diagram generated at 12 Gb/s by a pseudorandom bit sequence of 2/sup 31/-1 were achieved. The bit-error rates were below 10/sup -13/. The threshold current is as low as 0.8 mA for 7-/spl mu/m-diameter current apertures and typical slope efficiencies of 0.45-0.5 mA/mW were obtained.     

用屏蔽暂堵技术封堵水平井裂缝性漏层

克拉玛依油田HW702水平井的大斜度段和水平段,将穿越纵向裂缝发育的二叠系佳木河组储层。为安全钻进和保护油层,用超细碳酸钙和磺化沥青复配后加入复合离子钻井液中成屏蔽暂堵的堵漏钻井液。室内用岩心试验,屏蔽暂堵后渗透率可降为0,暂堵深度小于3cm,可用酸化和射孔解堵。现场使用效果也很好,使HW702水平井顺利完钻,并获得工业油气流。     

冲击回波法检测隧洞混凝土衬砌厚度

冲击回波法是通过接收、分析在混凝土中传播的回波信号，判断结构混凝土厚度和内部质量的新型无损检测技术。室内试验和工程应用研究表明，该方法为隧洞混凝土衬砌厚度检测提供了一个有效的测试手段。     

Service Load Effective Compression Flange Width in Fiber Reinforced Polymer Deck Systems Acting Compositely with Steel Stringers

This paper reports on the field study of a steel stringer-fiber reinforced polymer (FRP) deck composite bridge in Pennsylvania. The objective of the study is to assess the effective compression flange width in the FRP deck and floor systems when they act compositely with underlying steel girders at service conditions. The research results reported herein support the notion of employing a design approach, for both interior and exterior girders of a composite floor system, that is philosophically consistent with current practice related to steel girders acting compositely with concrete decking. It appears from the results presented herein that FRP decks and floors acting compositely with underlying steel girders exhibit an effective width that is close to the actual girder spacing for interior beams, and approximately one-half this value for exterior beams.     

Power levels and packet lengths in random multiple access with multiple-packet reception capability

This paper extends our earlier results. We assume that the receiver has the capability of capturing multiple packets so long as the signal-to-interference-plus-noise ratio (SINR) of each packet is above a designed threshold T throughout its transmission period. We prove that, compared with a multiple-power-level system, the single-power-level system in which all nodes transmit at the maximum allowable power level achieves optimal throughput, under a condition that T exceeds the value 3.33. Given a minimum throughput requirement, under the same condition on T, the single-power-level system also achieves the maximum average packet capture probability as well as the optimum energy usage efficiency. If the multiple-power-level systems are constrained such that higher power levels always have shorter packet lengths, then the above results hold for T greater than 2.