10 Gbit/s optical soliton transmission over 7200 km by using amonolithically integrated MQW-DFB-LD/MQW-EA modulator light source

The authors demonstrate 10 Gbit/s optical soliton transmission in a recirculating loop through the use of a monolithically integrated MQW-DFB-LD/MQW-EA modulator light source. The timing jitter due to the Gordon-Haus effect is successfully reduced by the optical bandpass filters conventionally used in the cascaded EDFAs to avoid the accumulation of amplified spontaneous emission. The transmission distance of 7200 km is achieved at a bit error rate of 10^-9     

a-Si alloy three-stacked solar cells with high stabilized-efficiency

a-Si alloy three-stacked solar cells have been studied to improve the stabilized efficiency of a-Si: H based solar cells. Based on the analysis by the individual characterization method of the component cells in stacked type cells, the a-Si :H middle cell was replaced with an a-SiGe :H cell. Furthermore, the optical confinement technology was improved to obtain a high-output current with thin i-layer thickness in the a-SiGe :H bottom cell. By this device design, the initial conversion efficiency was improved up to 12.4% and more than a 10% stabilized efficiency was obtained in a-SiC :H/a-SiGe :H/a-SiGe :H three-stacked cells. These cell characteristics were confirmed by measurements at the JQA Organization (the former JMI Institute).     

Biochemical identification of transmembrane segments of the Ca(2+)-ATPase of sarcoplasmic reticulum

The transmembrane segments of sarcoplasmic reticulum Ca(2+)-ATPase were determined by trypsinization of cytoplasmic side-out intact sarcoplasmic reticulum vesicles. The membrane portion of tryptic digest comprising the transmembrane fragments, joined by the intravesicular segments, was separated by sodium dodecyl sulfate-polyacrylamide gel electrophoresis after labeling with fluorescein 5-maleimide in the presence of sodium dodecyl sulfate. In this way, seven fluorescent bands of tryptic fragments below 11 kDa were observed which were derived from 4 pairs of membrane spanning segments and one hydrophobic sequence at the C-terminal end. Two peptides of 10.8 and 10.6 kDa had the identical N-terminal sequence beginning at Glu826, representing the transmembrane segments M7 and M8 and their connecting loop. A band at 8.1 kDa contained one peptide beginning at Tyr36 (M1/loop/M2). A 7.7-kDa peptide starting at Leu253 (M3/loop/M4) and a 7.3-kDa peptide beginning at Ala752 (M5/loop/M6) were also observed. A band at 6.7 kDa contained two peptides, one beginning at Ser48 (M1/loop/M2) and another beginning at Tyr763 (M5/loop/M6). In addition, a 4-kDa peptide beginning at Met925 was observed. The size of this peptide did not allow for a complete pair of transmembrane segments, but this peptide could have been derived from trypsinolysis between the last pair of membrane spanning segments. These data therefore provide biochemical evidence for at least 8 transmembrane segments and perhaps two more at the C-terminal end of the enzyme.     

Cloning and characterization of the Inc A/C plasmid RA1 replicon

The Inc A/C plasmids, like Inc P and Inc Q plasmids, have a broad host range. However, their maintenance functions remain to be studied. An autoreplicative region of 2.79 kb named RepA/C, able to replicate both in the family Enterobacteriaceae and in Pseudomonas spp., was isolated and sequenced. The stability, copy number, and incompatibility expression of this replicon were determined. RepA/C and a nonautoreplicative fragment of 16 kb of this replicon were used as probes and showed specific hybridizations with the Inc P3-A/C plasmids from Pseudomonas spp. and members of the Enterobacteriaceae. These probes could be used as tools for identification of the plasmids of this epidemiologically important Inc group.     

Predictive equation for acquisition of hepatitis B in hospital workers in a general hospital

A cross-sectional study was performed to obtain risk factors for hepatitis B disease, HBsAg carriers and immunised personnel, among 2470 workers in a general hospital in Madrid, Spain. The data obtained were analyzed with multiple logistic regression to obtain beta coefficients for variables. The results of the analysis show that being a nurse or being regularly exposed to blood are the most important risk factors for hepatitis B acquisition. The length of time working at the same job activity was also a risk factor. The resulting beta coefficients allow the construction for a hepatitis non-immunised, HBsAg carrier and immunised HBV status, which can select subjects for a hepatitis B vaccination program.     

Expression of laminin and nidogen genes during the postimplantation development of the mouse placenta

The expression patterns of laminin A, B1, B2, and nidogen genes were identified by in situ hybridization in postimplantation mouse extraembryonic tissues and maternal decidua during the period when the chorioallantoic placenta is established. Laminin and nidogen genes were not coordinately expressed either in the decidua or in trophoblast cells, indicating that these genes are regulated independently in these cell types during the establishment of the placenta. Laminin A mRNA was absent from the decidua except in the outer layer of cells adjacent to the myometrium and in the central decidual zone adjacent to the remnant of the uterine epithelium on Day 9. At this stage laminin B1, B2, and nidogen genes were strongly expressed in these cells and also in other regions of the decidua. Laminin B1 mRNA was present at higher levels in the decidua capsularis than in the decidua basalis, while nidogen mRNA showed highest expression in the decidua basalis. Laminin B2 mRNA was produced uniformly throughout the decidua at very high levels, suggesting that laminin B2 chains may be an important component of the decidual matrix. By Day 11, the nidogen gene was expressed only in endothelial cells lining the maternal blood spaces within the decidua. Laminin B1 and nidogen mRNAs were found at high levels within trophoblast giant cells at all stages, while laminin A mRNA was detected in trophoblast giant cells at later stages and laminin B2 mRNA was not produced in high levels by these cells. The patterns of gene expression show a very high degree of regional specialization, suggesting that the extracellular matrices in different regions of the decidua and extraembryonic membranes are likely to be composed of quite different ratios of laminin and nidogen polypeptides.(ABSTRACT TRUNCATED AT 250 WORDS)     

The evolution of custom microarray manufacture

Given the enormous size of the genome and that there are potentially many other types of measurements we need to do to understand it, it has become necessary to pick and choose one's targets to measure because it is still impossible to evaluate the entire genome all at once. What has emerged is a need to have rapidly customizable microarrays. There are two dominant methods to accomplish custom microarray synthesis, Affymetrix-like microarrays manufactured using light projection rather than semiconductor-like masks used by Affymetrix to mass manufacture their GeneChip/sup TM/ arrays now, or the ink-jet printing method employed by Agilent. The manufacture of these custom Affymetrix-like microarrays can now be done on a digital optical chemistry (DOC) machine developed at the University of Texas Southwestern Medical Center, and this method offers much higher feature numbers and feature density than is possible with ink-jet printed arrays. On a microarray, each feature contains a single genetic measurement. The initial DOC prototype has been described in several publications, but that has now led to a second-generation machine. This machine reliably produces a number of arrays daily, has been deployed against a number of biomedical questions, is being used in new ways and has also led to a number of spin-off technologies.     

Photoelectric properties of planar structures with double Schottky barrier treated in a high-vacuum microwave discharge

The state of the surface of n-GaAs crystals upon high-vacuum microwave plasmachemical (HVMWPC) etching in various gas mixtures and the influence of the semiconductor surface condition on the photoelectric characteristics of related metal-semiconductor-metal structures with double Schottky barrier (MSMDSB structures) are investigated. Dependence of the HVMWPC etching rate of the GaAs surface on the gas mixture composition and substrate temperature is determined. It is shown that the HVMWPC etching regime strongly influences the photoelectric properties of MSMDSB structures: the treatment can lead to either growth or drop in photosensitivity of the samples. Optimum etching regimes are established for which good semiconductor surface quality and high photosensitivity of the MSMDSB structures are retained at a high etching rate.