GDDS与SDDS的差异及其实施对策研究

本文在分析GDDS与SDDS的差异和我国政府统计现状的基础上,提出了我国政府统计应该向SDDS过渡的思想,并具体分析了我国实施SDDS的好处,给出了具体的过渡建议.     

基于"替换法"的汉字加、解密实现技术

文章讨论的基于“替换法”的汉字信息加、解密实现技术,改变了传统的汉字加密结果,使加密后的密文仍是可以识别和再利用的汉字,发送者可以在任何可编辑汉字的通讯设备上发送和接收密文,确保中文信息传输过程中的安全性。加、解密算法实现的代码语言为VFP6.0。     

间苯二酚溶剂萃取液液相平衡研究

测定了“醋酸正丁酯-间苯二酚(溶质)-盐水(含0.2质量分率NaCl)”三元系在24℃、101.33kPa下的液液相平衡数据并给出了三角相图,用Hand公式对相平衡数据进行了关联,获得了可供工业连续萃取过程设计使用的关联式。本研究将醋酸正丁酯和正丁醇作为溶剂萃取间苯二酚进行了对比,并指出:醋酸正丁酯优于正丁醇。     

冷41-平14"L"型水平井轨迹优化与控制技术

冷41-平14井受地面条件的限制,靶前位移小,为保证中间套管和完井管柱的顺利下入,剖面设计为“反向造斜-稳斜-降斜-正向造斜-水平段”的“L”型。简要介绍了冷41-平14“L”型水平井的设计概况,详细介绍了该井井眼轨道优化设计原则和设计结果,以及实钻井眼轨迹连续控制技术。该井精确命中A、B靶,两靶处的井斜角、方位角和垂深等达到了设计要求,在A靶实现了软着陆。该井井眼轨道优化设计和井眼轨迹控制技术为类似水平井的井眼轨道设计和轨迹控制提供了有益的借鉴。     

YAG：Ce Phosphors for WLED via Nano-Pesudoboehmite Sol-Gel Route

The sub-micron sized YAG ： Ce phosphors were synthesized via a modified sol-gel method by peptizing nano-pesudoboehmite particulate. It is found that YAG phase from the dried gel powders appears at 1000 ℃ then the pure YAG phase exists at a relatively lower sintering temperature of 1400 ℃. The smaller sizes of phosphors in the ranges of 1 - 3 μm are obtained due to the contribution of seeding effects of nano-sized alumina particles to strengthen each step of the processes. Both the excitation and emission spectra of photoluminescence of the phosphor obtained at 1400 ℃ meet well with the spectroscopic requirements of the WLED phosphors.     

NUMERICAL SIMULATION OF TIP-CLEARANCE FLOW IN CASCADE

1 .　ＩＮＴＲＯＤＵＣＴＩＯＮＴｉｐ ｃｌｅａｒａｎｃｅｆｌｏｗｓｏｃｃｕｒｉｎｖａｒｉｏｕｓｅｎｇｉｎｅｅｒ ｉｎｇａｐｐｌｉｃａｔｉｏｎｓｓｕｃｈａｓａｘｉａｌ ｆｌｏｗ ｐｕｍｐｓａｎｄｄｕｃｔ ｅｄｐｒｏｐｅｌｌｅｒｓ .Ｔｈｅｉｎｅｒｔｉａｌｆｏｒｃｅｓａｃｔｉｎｇｕｐｏｎｔｈｅｆｌｕｉｄｉｎｔｈｅｎａｒｒｏｗ ｇａｐｂｅｔｗｅｅｎｂｌａｄｅｔｉｐａｎｄｔｈｅｓｕｒｒｏｕｎｄｉｎｇｗａｌｌａｒｅｓｕｆｆｉｃｉｅｎｔｔｏ ｇｅｎｅｒａｔｅａｔｉｐｌｅａｋａｇｅｖｏｒｔｅｘｏｎｔｈｅｓｕｃｔｉｏｎｓ…     

Photo-bleaching induced electro-optic polymer modulators with dual driving electrodes operating at 1.55 /spl mu/m wavelength

Electro-optic (EO) polymeric Mach-Zehnder (MZ) modulators with photo-bleaching (PB) induced waveguides and dual driving electrodes operating at 1.55 /spl mu/m wavelength have been demonstrated. The half-wave voltage of the integrated polymeric modulator was 4.5 V in a push-pull configuration with a 1.5 cm interaction length. The extinction ratio was greater than 20 dB, and the fibre-to-fibre insertion loss was 8 dB for the TM polarisation. The achieved fibre-to-fibre insertion loss and driving voltage are the best, to the authors knowledge, in the reported PB induced MZ EO polymeric modulators.     

Flammability and thermal stability studies of ABS/Montmorillonite nanocomposite

Acrylonitrile–butadiene–styrene (ABS)/montmorillonite nanocomposites have been prepared using a direct melt intercalation technique by blending ABS and organophilic clay of two different particle sizes: OMTa (5 µm) and OMTb (38 µm). Their structure and flammability properties were characterized by X‐ray diffraction, high resolution electronic microscopy (HREM), thermogravimetric analysis (TGA) and cone calorimeter experiments. The results of HREM showed that ABS/5 wt% OMTa nanocomposite was a kind of intercalated–delaminated structure, while ABS/5 wt% OMTb nanocomposite was mainly an intercalated structure. The nanocomposites showed a lower heat release rate peak and higher thermal stability than the original ABS by TGA and cone calorimeter experiments. Also, the intercalated nanocomposite was more effective than an exfoliated–intercalated nanocomposite in fire retardancy. Copyright © 2003 Society of Chemical Industry     

宣汉——达县地区飞仙关组储层预测方法研究

在宣汉-达县地区,以往仅依据地震属性来预测飞仙关组储层分布,钻探结果与实际情况不符,为此本文提出量化分析预测结合主参数分析的新方法和新思路。在量化分析中首先对飞仙关组储层进行高分辨率反演,获得储能系数图;然后结合主振幅剖面和主频率剖面分析,对储层进行预测。在研究区,本方法的预测结果与实钻情况相吻合。