Cu基络合物催化甲醇液相氧化羰化反应

针对甲醇液相氧化羰基化法合成碳酸二甲酯(DMC)工艺,开发了新型Cu基络合催化剂(CuB rnLm)。对CuB rnLm催化剂的活性及其稳定性进行了研究。实验结果表明,采用该催化剂,甲醇转化率和DMC选择性较高;元素价态和物质结构分析表明,CuB rnLm催化剂循环使用5次后仍保持较好的稳定性。采用正交设计和中心响应曲面法设计实验,并使用S tatistica软件进行统计分析,寻求出反应的主要影响因素,并得到优化的工艺条件:反应温度100~110℃、反应压力3.0~3.5M Pa、反应时间4~6h、CuB rnLm催化剂质量浓度(以甲醇的体积计)0.15~0.20g/mL。在此工艺条件下,甲醇转化率可达23%以上,DMC的选择性为96%~98%。     

Injection-locked Fabry-Pe/spl acute/rot laser with electronic feedback for clock recovery from high-speed OTDM signals

We demonstrate the use of an injection-locked Fabry-Pe/spl acute/rot laser diode with electronic feedback for base-rate clock recovery in N/spl times/10 Gb/s optical time-division-multiplexing (OTDM) systems. Injection-locking enhances the resonance frequency of the laser and the electrical feedback achieves strong resonance at the base-rate frequency of the injected data streams, enabling ultrastable electrical clock signal generation at the base rate of 10 GHz. Experimental demonstrations for clock recovery at 10 GHz from 40-Gb/s OTDM data streams and 4-1 demultiplexing of the data using the extracted clock after fiber transmission is presented. The timing jitter measured in the recovered electrical clock is less than 0.25 ps.     

蜕变——中国气象局华风影视大楼

华风气象影视大楼总面积4万平方米，根据空间功能不同分为办公大楼和商务写字楼两部分，办公大楼是集演播室、制作机房、办公室为一体的九层综合性建筑。设计师杨宇在刚接触到这个项目的时候，面对的是一个既成事实的建筑。     

基于实际井眼轨迹的抽油杆柱API设计方法

目前的抽油杆柱设计方法大都基于设计井眼轨迹或经验公式，因此设计的抽油杆柱与井眼的匹配性并没有达到最优，结果可能影响了抽油杆柱的受力特性和寿命。概述了目前现有的抽油杆柱设计方法，提出了基于实际井眼轨迹的抽油杆柱API设计方法，即考虑到在三维空间中井下粘滞阻力及动载的影响，利用微单元分析方法计算出轴向载荷与轴向应力，然后在此基础上进行杆柱组合设计，并给出了设计流程。以江苏油田永21-3井为例，对几种设计方法的设计结果进行了对比分析，结果表明，江苏油田目前采用的抽油杆柱设计方法包含了人为经验因素，并不是最优的杆柱设计结果，有待进一步改进。     

膨胀套管的弹塑性理论分析

分析认为，膨胀套管在膨胀过程中先进入弹性阶段，然后进入弹塑性阶段，最后进入塑性流动阶段。采用弹塑性分析方法，对膨胀套管膨胀过程中套管内壁的受力与变形进行了研究，模拟了其成形的过程，并建立了解析解，为膨胀套管膨胀操作过程中确定关键操作参数提供了理论支持。根据推导出的力学模型，计算出了外径107．9mm、钢级为J55的膨胀套管膨胀到直径139．7mm时膨胀芯头拉头处的轴向力为195．94kN。     

High Power Fiber Bundle Array Coupled LDA Module

1 Introduction High power laser diode arrays (LDA) have many advan- tages such as small volume, long working life, high slope efficiency and high optical density, so they have many applications in medical treatment, material pro- cessing, and for the pumping source of solid laser and etc. But unfortunately, the LDA can not be easy to use directly in these fields because of their poor beam quality and extremely asymmetric divergent beams (!x≈ 5°～10°and !y≈20°～35°, for example), so it …     

Laterally coupled buried heterostructure high-Q ring resonators

All-buried InP-InGaAsP ring resonators laterally coupled to bus waveguides are demonstrated. The buried configurations offer a lower built-in refractive index step along the resonator periphery, which affords enhanced optical coupling coefficients between the waveguides and reduced scattering losses caused by the resonator sidewall imperfections. Very low optical intensity attenuations of 0.4 cm/sup -1/ and coupling-limited quality factors of greater than 10/sup 5/ are observed from 200-/spl mu/m-radii ring resonators. The measured spectral linewidth is as narrow as 0.0145 nm.     

软锰矿氧化硫化钡制高纯碳酸锰和氢氧化钡工艺研究

软锰矿同硫化钡溶液在较低温度下进行氧化还原反应，当硫化钡含量控制在26-75g／L范围内，软锰矿与硫化钡的物质的量比为2．5-3，反应时间50-60min，软锰矿被硫化钡还原为MnO，其还原率可达93．5％以上；还原后的锰用硫酸浸取，溶液经除杂后，与碳酸铵反应而制成高纯碳酸锰。硫化钡则被氧化为氢氧化钡，经蒸发、结晶而制得入水氢氧化钡，其回收利用率高速95％。     

CHAOTIC HYDRODYNAMICS IN HORIZONTAL GAS-LIQUID BUBBLY FLOW

ＮＯＭＥＮＣＬＡＴＵＲＥｄ———ｅｍｂｅｄｄｉｎｇｄｉｍｅｎｓｉｏｎ ,ｄｉｍｅｎｓｉｏｎｌｅｓｓＣｄ(ｒ)———ｃｏｒｒｅｌａｔｉｏｎｓｕｍ ,ｄｉｍｅｎｓｉｏｎｌｅｓｓＮ———ｎｕｍｂｅｒｏｆｐａｉｒｓｏｆｐｏｉｎｔｓｏｎｔｈｅｒｅｃｏｎ ｓｔｒｕｃｔｅｄａｔｔｒａｃｔｏｒ,ｄｉｍｅｎｓｉｏｎｌｅｓｓｒ———ｓｃａｌｉｎｇｄｉｓｔａｎｃｅ ,ｄｉｍｅｎｓｉｏｎｌｅｓｓＤｃ ———ｃｏｒｒｅｌａｔｉｏｎｄｉｍｅｎｓｉｏｎ ,ｄｉｍｅｎｓｉｏｎｌｅｓｓＫ———Ｋｏｌｍｏｇｏｒｏｖｅｎｔｒｏｐｙ ,ｂｉｔｓ/ｓＲ…     

Antenna-array pattern nulling using a differential evolution algorithm

A new method based on the differential evolution (DE) algorithm is proposed for antenna-array pattern synthesis with prescribed nulls. The array excitation amplitudes are the only controlling parameters, and the objectives are to synthesize array patterns with nulls imposed on directions of interferences while keeping the sidelobe levels (SLLs) below prescribed levels. Many factors such as the excitation dynamic range ratio, null depth level, null width, and SLLs are taken into account in the synthesis. Simulation results of several typical problems are compared with published results to illustrate the effectiveness of the proposed method. © 2003 Wiley Periodicals, Inc. Int J RF and Microwave CAE 14: 57–63, 2004.