屏蔽电泵运行中存在问题的分析与改进

对屏蔽电泵在非设计流量下工作存在较大的轴向力不平衡，造成前端轴承磨损严重进行了分析。在不降低效率的情况下，在屏蔽电泵的泵头加入平衡盘使轴向力得到平衡，并取得了满意的效果。     

新抗冲型ACR的合成与研究

采用种子乳液聚合法制备了含有PBA＼PMMA＼PS三种组分的丙烯酸酯类抗冲型改性剂ACR，在ACR的幔层结构中引入接枝剂甲基丙烯酸烯丙酯（ALMA）来完善幔层结构，从而实现核一壳之间良好的结合，用红外光谱（FTIR）和差示扫描量热法（DSC）对ACR的组成和结构进行表征。研究结果表明：由PBA＼PMMA＼PS三组分构成的ACR在抗冲击性能上要略优于由简单的PBA＼PMMA构成的ACR，苯乙烯单体（St）最多可以取代大约1／3壳层的甲基丙烯酸甲酯（MMA），甲基丙烯酸烯丙酯（ALMA）的引入对幔层结构的完善起了显著的作用。     

55t/h锅炉技术改造成功经验

介绍了35t／h锅炉扩容改造为55t／h非标锅炉的技术成功经验。从增加锅炉的容积、受热面面积、燃烧器喷嘴改造三个方面介绍了对锅炉本体的改造，改造后实现了锅炉的水位、汽温及燃烧自动调节，提高了锅炉的热效率为以后的锅炉扩容改造提供了实践经验。     

An investigation of the relation between the temperature dependences of the initial unbalance and the output signal of resistance strain sensor bridge circuits

The relation between the initial unbalance and the output signal of bridge circuits when acted upon simultaneously by the physical factor being measured and the temperature of the surroundings when the bridge is supplied from a voltage or current source is investigated. Analytic relations are obtained which explain the temperature dependence of the useful output voltage under external physical action. __________ Translated from Izmeritel’naya Tekhnika, No. 1, pp. 48–49, 2007.     

Hydriding and Dehydriding Characteristics of Mechanically Alloyed LaMg_(17) Ni Composite Material

Magnesiumandmagnesiumalloyshavebeenin vestigatedashydrogenstoragematerialsforseveralde cadesbecausefarmorehydrogenbyweightcanbestoredinthemthaninmostoftheothercurrentlyknownhydrogenstoragealloys .Moreover ,thehighnaturalabundanceofMg ,itslightmassandenviron mentalcompatibilitypotentiallymakemagnesiumoneofthemostprospectivecandidatesforfuturehydrogenstoragematerials .Unfortunately ,thepracticalappli cationofMganditsalloyshasbeenlimitedonlytocertainstoragedevicebecauseoftheirpoorhydriding dehydr…     

Stages of surface erosion under ion irradiation

Initial stages of surface erosion have been studied for NaCl and LiF single crystals bombarded by Ar⁺ ions with 20 keV. For irradiation with doses D=10¹⁰-10¹¹ ions/cm², exoelectron emission has been used, whereas for higher doses, we have used electron microscopy. Two stages of initial surface erosion have been identified; for small doses, there is slow development of atomic-scale roughening, which reaches its peak when areas damaged by closest incident ions start to overlap, and then, beginning with D=10¹⁶ ions/cm², there is rapid etching, deep into the crystal, followed by the emergence of secondary microscopic structure, i.e. caverns, concentric closed steps and terraces. Ion-induced surface structure of alkali halide crystals has been shown to depend strongly on the presence of foreign particles on the surface, as well as on segregation. Topography of thin carbon films and some metals have been discussed.     

Hydrothermal synthesis of hexagonal ZnO clusters

Hydrothermal process was applied to synthesize zinc oxide nanocrystals. X-ray powder diffraction and scanning electron microscopy were used to analyze the crystal structure and surface morphology. XRD pattern analysis showed that the ZnO clusters are single hexagonal phase of wurtzite structure (space group P63 mc) with no impurity of Zn and Zn(OH)₂. Also, SEM images revealed that the size of a single ZnO crystal is between 200-500 nm in diameter and 2-5 μm in length. The influence of potassium iodide (KI) as a surfactant on the crystallinity of ZnO has been investigated.     

Formation of mushroom-like ZnO microcrystals through a solution calcination process

Mushroom-like ZnO microcrystals have been prepared via a solution calcination route, using Zn(NO₃)₂ as Zn source in the absence of any surfactants, templates or catalysts. This is the first example to prepare mushroom-like crystals as semiconductors, which are expected to show particular physical properties. The ZnO products were investigated by X-ray powder diffraction (XRD), scanning electron microscopy (SEM), Raman spectroscopy and photoluminescence (PL) spectrum measurements. A suitable concentration of Zn(NO₃)₂ solution was important for the growth of the mushroom-like products. The reported synthetic procedure is straightforward and inexpensive, and thus can be readily adopted to produce large quantities of mushroom-like ZnO microcrystals.     

Roles of minor additions in formation and properties of bulk metallic glasses

Bulk metallic glasses (BMGs) are of current interest worldwide in materials science and engineering because of their unique properties. Exploring BMGs materials becomes one of the hottest topics in the materials science field. To date, there is very active worldwide development of new BMGs, and extensive efforts have been carried out to understand and improve the glass-forming ability of metallic materials supported by large government and industry programs in North America, Asia, and Europe. Minor addition or microalloying technique, which has been widely used in other metallurgical fields, plays effective and important roles in formation, crystallization, thermal stability and property improvement of BMGs. This simple approach provides a powerful tool for the BMG-forming alloys development and design. In this paper, we present a comprehensive review of the history and the recent developments of this technique in the field of BMGs. The roles of the minor addition in the formation and the properties of the BMGs and the BMG-based composites will be discussed and summarized within the framework of thermodynamics, kinetics and microstructure. The empirical criteria, or the principles and guidelines for the applications of the technique in BMG field are outlined.