Nd2O3掺杂对BSTO/MgO复合陶瓷显微结构和性能的影响

当掺杂0.3mol% Nd2O3时,BSTO/MgO复合陶瓷材料的介电常数为88,损耗2.8×10-3(4.1GHz),介电常数可调为6.9%(2.0 kV/mm).利用电介质理论分析了Nd2O3对BSTO/MgO复合陶瓷材料介电性质的改性机理.     

钛酸锶钡(BST)铁电移相器材料的研究现状

钛酸锶钡(BST)材料被普遍认为是最有前途的铁电移相器材料。BST作为铁电移相器材料的研究已有多年,到目前为止取得了不少突破性的进展。综述了国内外研究人员在BST体材、厚膜以及薄膜方面所做的工作及获得的一些成果。     

鞍钢17Mn阻尼钢4 ~ 100 mm板的研制

鞍钢研制的 17Mn 阻尼钢(/% ：0.02C, 0.08Si, 17.53Mn, 0.014P, 0.002S, 0.005Als) 4 ~ 100 mm 板,其 屈服强度311 ~4O7 MPa,15~100 mm板-20°C. V型缺口冲击吸收能量113-144 J,焊接后焊接接头抗拉强度651 ~ 654 MPa,焊接后-20 °C V型缺口冲击吸收能量66~84JO 17Mn阻尼钢组织为残余奥氏体和e马氏体,使用动态机 械热分析仪检测其阻尼性能。在30 °C ,50 Hz双悬臂应变扫描条件下,不同厚度阻尼钢阻尼值均大于0.02;在100 Hz 下测试不同厚度阻尼钢阻尼值均大于0.05,阻尼值高于传统的低合金结构钢Q235、Q345(0.008和0.010 ~0.013)。     

Preparation and properties of crystallizable Glass/Al<Subscript>2</Subscript>O<Subscript>3</Subscript> composites for LTCC material

The investigated low temperature Co fired ceramics(LTCC) composite of 60wt% CaO-Al2O3-B2O3-SiO2 glass and 40wt% α-Al2O3 as a filler is a non-reactive system, which is a critical part of the low temperature Co fired ceramics process. Through a study on densification process, the phase transformation and microstructure can be revealed. Its composites typically consist of CaO-Al2O3-B2O3-SiO2 glass and α-Al2O3 powders of average particle size (D50=3.49 mm). The sintering behavior, phase evaluation, sintered morphology, and microwave dielectric properties were investigated. In the fire range of 800 to 900 ℃, the composites were crystallized after completion of densification. It is found that the composites start to densify at 825 ℃, simultaneously, the dielectric constant (εr) reaches its maximum. With increasing heat-treatment temperatures, due to the loose microstructure of the material, tanδ increases slightly. The last of the sintered samples were identified as partly Anorthite at 850 ℃. At that temperature it has εr of 7.9 and tanδ less than 1×10-3, and can be used as a promising LTCC material.     

Tape casting of borosilicate glass/Al2O3 composites for LTCC substrate with various relative molecular masses of PVB

The dispersion, stabilization and rheological properties of the slurry with various relative molecular masses of PVB were studied. The sintering properties, microstructure and dielectric properties of borosilicate glass/Al2O3 composites were also investigated. The intensities of the typical vibrating bands decrease with the decrease of the relative molecular mass of PVB, which demonstrates that the content of butyral groups in PVB binders decreases correspondingly, leading to a rapid decrease in the viscosity of the mixed slurry. The solid content of samples increases with the decrease of the relative molecular mass of PVB, and this further leads to the increase of tape thickness, bulk density and dried-shrinkage coefficient of tapes. The bulk density, relative density, three-point strength and dielectric constant of sintered samples increase with the increase of the solid content, and the shrinkage and dielectric loss decrease. By contrast, samples for PVB-5s exhibit better properties of a bulk density of 3.10g/cm3 , a relative density of 98.1%, a three-point strength of 208 MPa, a ε r value of 8.01, a tanδ value of 7.6×10-4 at 10 MHz and a well matching with Ag electrodes.     

聚四氟乙烯/陶瓷/玻璃纤维复合介质的性能研究

采用热压工艺制得聚四氟乙烯/陶瓷/玻璃纤维复合介质材料。复合介质材料的介电常数随着PTFE和玻璃纤维含量的增加而减小;当复合介质中不含玻璃纤维时,随着陶瓷粉料的质量分数从40%增加到65%时,材料的弹性模量先减小后增加;加入玻璃纤维可以增加材料的弹性模量,对于PTFE的质量分数为40%的复合介质,玻璃纤维加入的质量分数不应大于15%,聚四氟乙烯/陶瓷/玻璃纤维复合介质的微观结构致密、形成了完整的一体。     

CBS/SiO2体系玻璃陶瓷结构与性能研究

采用水淬法制备CBS玻璃,并使用液相参与的烧结机制制备了钙硅硼(CBS)玻璃陶瓷。研究了不同配比下的CBS/SiO2体系玻璃陶瓷的相组成、显微结构、介电性能及绝缘电阻率。结果表明,随着SiO2添加量增加,材料的介电常数有所下降。当w(SiO2)为15%时,其在850℃的低温烧结样品,10MHz的测试频率下,εr为6.01,tgδ为1.22×10–3,绝缘电阻率1.5×1012?.cm,样品中出现大量石英相,晶粒尺寸多在1μm以下。保温时间对介电性能影响不大。     

掺钛和锆改性的钙硼硅系微晶玻璃之性能

以TiO2、ZrO2为改性剂,制备CaO-B2O3-SiO2系微晶玻璃。对其烧结和介电性能进行了研究,并采用XRD,SEM对微观结构进行了探讨。结果表明:添加适量的TiO2或是混合添加TiO2、ZrO2均能改善CaBSi系微晶玻璃的性能。混合添加比单一添加TiO2更有效。结合材料的烧结性能、介电性能和微观结构,以840℃烧成的添加w(TiO2)为2%、w(ZrO2)为2%的试样性能最佳,其εr为7.1、tanδ为3×10–3,在20~400℃之间的热膨胀系数为7.8×10–6℃–1。