Data sharing mechanism of various mineral resources based on blockchain

Basins with various mineral resources coexisting and enriching often occupy an important strategic position. The exploration of various mineral resources is repetitive at present due to unshared data and imperfect management mechanism. This situation greatly increases the cost of energy exploitation in the country. Traditional data-sharing mode has several disadvantages, such as high cost, difficulty in confirming the right of data, and lack of incentive mechanism, which make achieving real data sharing difficult. In this paper, we propose a data-sharing mechanism based on blockchain and provide implementation suggestions and technical key points. Compared with traditional data-sharing methods, the proposed data-sharing mechanism can realize data sharing, ensure data quality, and protect intellectual property. Moreover, key points in the construction are stated in the case study section to verify the feasibility of the data-sharing system based on blockchain proposed in this paper.     

信永中和"登云股份IPO审计失败"探究

本文以证监会发布的针对信永中和及两名签字注册会计师的行政处罚决定书为切入点,结合深圳证券交易所、天眼查、巨潮资讯等网站公布的相关信息,从信永中和的具体审计过程,分析登云股份IPO审计失败的原因,原因主要在于基于业务需要未充分了解公司及其经营环境,贸然接受委托,缺乏应有的执业审慎,缺少了必要的审计程序,复核制度流于形式丧失了发现错误的最后机会。     

Three‐dimensional color prediction modeling of single‐ and double‐layered woven fabrics

In this research, the three‐dimensional structural and colorimetric modeling of three‐dimensional woven fabrics was conducted for accurate color predictions. One‐hundred forty single‐ and double‐layered woven samples in a wide range of colors were produced. With the consideration of their three‐dimensional structural parameters, three‐dimensional color prediction models, K/S‐, R‐, and L*a*b*‐based models, were developed through the optimization of previous two‐dimensional models which have been reported to be the three most accurate models for single‐layered woven structures. The accuracy of the new three‐dimensional models was evaluated by calculating the color differences ΔL*, ΔC*, Δh°, and ΔE_CMC(2:1) between the measured and the predicted colors of the samples, and then the error values were compared to those of the two‐dimensional models. As a result, there has been an overall improvement in color predictions of all models with a decrease in ΔE_CMC(2:1) from 10.30 to 5.25 units on average after the three‐dimensional modeling.     

基于振动实测的非均质地层钻头失效分析与对策

四川盆地作为国内页岩气开发的重点区域,通过近几年的不断攻关和实践,机械钻速得到了提高,但由于受地层复杂、可钻性差、非均质性强等地质因素的影响,导致井下钻柱系统不良振动剧烈,容易出现钻头损坏严重、钻速较低等问题,严重影响了钻井时效。为了解决上述难题,以该盆地涪陵工区上二叠统龙潭组—中二叠统茅口组为例,采用井下振动高频测量工具的实测手段,测量了钻头—钻柱系统的动态振动加速度参数,结合地层的岩性和矿物组分分析,研究钻头失效原因与对策,并开展了现场试验。研究结果表明:①在非均质地层中钻进的钻头—钻柱系统产生了大于40 m/s~2的高幅值瞬时冲击振动,高幅值的瞬时冲击是导致钻头先期失效的主要原因;②提出了抑制高幅值的瞬时冲击振动采用"减振+增压"工具组合和避免井下工具共振的钻井参数;③采用钻井新参数的试验井比邻井的高幅值瞬时振动降低了17%,单只钻头进尺增加24%,钻头工作环境得到了较大的改善,钻头使用数量减少。结论认为,该研究成果能够有效地改善钻头—钻柱系统的振动状态,有利于达成延长钻头使用寿命的目标。     

0Cr20Mn21Ni2N奥氏体不锈钢锻件组织性能研究

研究了无磁钻铤用0Cr20Mn21Ni2N奥氏体不锈钢圆棒锻件横截面的室温强度、硬度和韧性等力学性能,并从微观角度进行了分析。在圆棒表层区域观察到了锻造变形态晶粒组织,而直径四分之一区域为再结晶组织,平均晶粒尺寸为80μm,芯部再结晶晶粒尺寸粗化为150μm,这些差异是由不同的变形温度和降温速度造成的。这种组织差异导致的室温拉伸性能和冲击韧性也有相应的变化趋势。研究结果表明,在900、1000℃以0.5 s-1的应变速率压缩的0Cr20Mn21Ni2N试验钢样品,其应力应变曲线具有一定的加工硬化特征,其芯部硬度比应变速率为0.1 s-1的样品分别提升了28、15 HB。在700、800℃以20%以上的变形量进行压缩时,峰值抗力显著提高,而在900、1000℃以10%~50%的变形量进行压缩时,峰值抗力均无明显提高,可保证顺利的变形过程。     

煤气化废水处理工艺探讨

煤气化废水的特点是温度高、硬度高、NH3-N高、有机物含量相对不足。针对这些特点引起的运行不稳定,逐一提出解决方案,并形成一套完整的针对煤气化废水的处理工艺。     

构皮滩水电站泄洪洞优化设计

构皮滩水电站为满足2008年12月工程提前发电的需要,结合现有泄洪洞地质情况和施工情况对泄洪洞布置进行了专题研究,结果表明利用降低进口高程为550 m的泄洪洞和坝身放空底孔联合参与后期导流,可缓解2007年导流隧洞下闸封堵后大坝在2008年汛期施工的压力,为大坝施工增加了2个月左右的工期。     

On the performance of band-limited asynchronous DS-CDMA over nakagami-m channels

In this paper we investigated the BER performance of DS-CDMA using various chip-waveforms, which include three time-limited chip-waveforms and two band-limited chip-waveforms. Closed-form formulae were derived for evaluating the achievable bit-error rate performance with the aid of the standard Gaussian approximation, when communicating over a Nakagami-m channel. The time-limited waveforms impose a low implementational complexity, since they maybe over sampled and read from a look-up table. However, they are outperformed by the frequency-domain raised-cosine waveform as well as the optimum waveform specifically designed by Cho and Lehnert for achieving the lowest possible bit error rate