Effects of soaking soybeans in dilute acids on biologically active components

Soaking soybeans in dilute acids affected activities of lipoxygenase, trypsin inhibitor and urease. Effects of soaking time, acid concentration and soaking temperature were investigated. Lipoxygenase activity was completely eliminated by soaking in 0.3 M HC1 at either 23°C or 40°C for 8 hr. Less than 50% trypsin inhibitor remained and urease was inactivated to an acceptable level (0.04 ΔpH).     

光气生产技术及光气化产品开发进展

综述了光气生产工艺技术、安全措施及主要光气下游产品种类。介绍了国内外光气生产及应用现状，涉及一氧化碳制备、氯气干燥、光气合成、废气处理和安全生产等技术。简述了光气化产品开发研究方向，提出重点开发IPDI(异佛尔酮二异氰酸酯)、NDI(1，5-萘二异氰酸酯)、氯磺酰异氰酸酯和较大分子量的氯代甲酸酯等光气化产品。     

《动态网站开发》课程教学改革探索

《动态网站开发》课程是中职学校计算机专业的核心课程,传统的授课方式以讲授理论为主,实际操作较少,这种方式很难适应现在中职学校的教学,必须打破传统的教学理念,对《动态网站开发》课程进行改革。     

橡胶对HIPS树脂落锤指标的影响

通过对高抗冲聚苯乙烯树脂出现产品落锤指标偏低问题的分析，从橡胶配量及其粒径大小上进行了改进，同时改进了工艺操作，采取了提高反应釜搅拌速度、降低乙苯浓度等措施。结果产品合格率达到９９％以上，优级品率达到９８％以上。     

Comparison of microwave and thermal cure of epoxy resins

Stoichiometric mixtures of DGEBA (diglycidyl ether of bisphenol A)/DDS (diaminodiphenyl sulfone) and DGEBA/mPDA (meta phenylene diamine) have been isothermally cured by electromagnetic radiation and conventional heating using thin film sample configurations. Fourier transform infrared spectroscopy (FTIR) was used to measure the extent of cure. Thermal mechanical analysis (TMA) was used to determine the glass transition temperatures directly from the cured thin film samples. Well-defined glass transitions were observed in the TMA thermograph for both thermal and microwave cured samples. Significant increases in the reaction rates have been observed in the microwave cured DGEBA/DDS samples. Only slight increases in the reaction rates have been observed in the microwave cured DGEBA/mPDA samples. Higher glass transition temperatures were obtained in microwave cured samples compared to those of thermally cured ones after gelation. The magnitude of increases of glass transition temperature is much larger for the DGEBA/DDS system than DGEBA/mPDA system. The microwave radiation effect was much more significant in DGEBA/DDS system than in DGEBA/mPDA system. DiBenedetto's model was used to fit the experimental T_g data of both thermal and microwave cured epoxy resins.     

Nanocrystalline CeO2 in SBA-15: Performance of Pt/CeO2/SBA-15 Catalyst for Water-gas-shift Reaction

CeO₂ particles confined within the pores of an SBA-15 mesoporous silica host were prepared by incipient wetness impregnation (IMP) and deposition precipitation (DP) methods. The materials were characterized by XRD, N₂-adsorption and temperature programmed reduction (TPR) to evaluate the structure, texture, and redox properties. The preparation procedure had significant impact on the assembling mode of CeO₂ inside the SBA-15 mesopores. A high dispersion of CeO₂ particles was achieved via DP, whereas the dispersion of CeO₂ prepared by IMP was found to be inhomogeneous and CeO₂ partially blocked the pores. The CO conversion in the water-gas-shift reaction was enhanced over 1 wt% Pt supported on CeO₂-modified SBA-15 obtained by DP.     

High temperature swelling of coal/tetralin mixtures in a high pressure microdilatometer

High pressure microdilatometer experiments were performed on a subbituminous (Wyodak) and a bituminous (Illinois no. 6) coal in helium and hydrogen atmospheres with and without added tetralin. Wyodak coal samples showed no swelling but contractions ranging between 24 and 40 vol% upon heating at 20 and 100 °C min^{− 1} under helium or hydrogen pressures between 150 and 1000 psig (˜1.0–6.9 MPa). Under the same conditions, Illinois no. 6 coals displayed contractions (25–60 vol%) prior to swelling up to 117 vol%. Upon tetralin addition (at 35–190 wt% of the coal), Wyodak coal samples did not swell but showed an increasing contraction with increasing helium or hydrogen pressure due to a slight softening and fusion of the coal particles. In contrast, addition of tetralin at much lower concentrations (5–35 wt%) had a marked effect on the contraction and swelling behaviour of Illinois no. 6. A maximum swelling of 200 vol% was obtained at a tetralin addition of 30 wt%. The increased swelling results from more extensive softening and fusion of coal particles in the presence of tetralin. Both coals showed a decreasing char yield with increasing tetralin concentration. The substantially lower extent of interaction observed between Wyodak coal samples and tetralin compared to Illinois no. 6 coal can be attributed to the differences in pore structure and/or chemical constitution of the two coal samples. Examination of the resultant solids by optical microscopy revealed the microstructural changes produced by thermal treatment in dilatometer experiments.     

高职院校软件教学体系研究

本文在概述软件教学体系及其理论的基础上,结合软件教学的特点,阐述了软件教学体系的结构、应用环境以及在教学中将遇到的问题和解决对策,并描述了＂软件教学资源网系统＂建立的目的、设计方案、功能及开发环境。     

Study of different effect on foaming process of biodegradable bionolle in supercritical carbon dioxide

Microcellular foaming of biodegradable Bionolle in supercritical CO₂ has been produced. The effects of a series of variable factors, such as saturation temperature, saturation pressure, and depressurization time and step on the foam structures and density, were studied through measurement of density and SEM observation. The experimental results show that higher saturation temperatures lead to an increase in bulk densities; and different depressurization time and step result in different product cell morphology. In addition, at some saturation temperature, the orientation of the cells can be found in the product morphology. XRD experimental results show that the foaming treatment with SC CO₂ increased the crystallinity of Bionolle. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 100: 2901–2906, 2006