Three-dimensional CMOS NAND with three stacked channels

A process-inherent NAND2 device is presented for a three-dimensional CMOS integration with epitaxial lateral overgrowth and chemo-mechanical polishing. The required 'OR' function of the two PMOS transistors is achieved by one silicon volume, which is controlled by a back gate and a conventional front gate. Almost symmetrical characteristics are measured for the front and the back gates.<>     

1.3 μm InAsyP1-y-InPstrained-layer quantum-well laser diodes grown by metalorganic chemicalvapor deposition

The authors have fabricated 1.3-μm InAsP-InP separate-confinement-heterostructure (SCH) strained-layer double-quantum-well (SL-DQW) laser diodes (LDs) by metalorganic chemical vapor deposition (MOCVD). A low threshold current density of 410 A/cm ² was obtained. The CW threshold current was as low as 1.8 mA at 20°C, and maximum CW operating temperature of 120°C was obtained. These characteristics are almost the same as those of well-designed GaInAsP-InP SL-QW LDs. Further improvement of the characteristics of InAsP-InP LDs is expected by optimizing the device structure     

PERCHLOROETHYLENE EXTRACTION DESULFURIZATION OF LOW SULFATE COALS

The perchloroethylene coal refining process utilizes perchloroethylene (PCE) as its solvent in all phases of the precombustion desulfurization process, including wet grinding, organic sulfur removal, gravitational separation of pyrites and mineral matter, and recovery of elemental sulfur (S₈). The Process is capable of producing compliance coal which emits less than 1.2 lb SO_X/MBTU when burnt, starting from 5 mass percent sulfur Midwestern and Eastern U.S. coals. However, the process efficiency was found to be very strongly dependent upon the degree of weathering or the level of coal oxidation. In this paper, perchloroethylene extraction data of fresh, low-sulfate coals are summarized and critically assessed. The extraction efficiency of the organic sulfur removal ranged from 5 to 30 percent for fresh coals, while that for weathered coals ranged from 30 to 60 percent. This study provides a valuable insight into the chemical reaction mechanism of perchloroethylene desulfurization process.     

The correlation of texture and magnetic properties in Co-Cr films

This investigation focuses on the correlation between the crystallographic orientation of grains with respect to magnetic properties in Co-Cr films. Based on a distribution measured for the (0002) crystallographic pole densities, modified formulae describing the texture were used to calculate the coercivity Hc, the squareness ratio Rs (Mr⊥/TMs) and the anisotropy field Ha for Co-Cr films. In general, calculated values for the coercive force He agreed well with the measured values. The calculated Rs⊥. values were much larger than the measured ones, however, indicating that the influence of the demagnetizing field and the magnetostriction on the orientation of the magnetization cannot be neglected. On leave from Institute of Computing Technology, Academia Sinica, P.O.Box 2704-6, Beijing, P.R. China.     

An analytic expression of fmax for HBTs

An analytic expression of f_max is derived based on a practical HBT circuit model where collector junction capacitance is split up into internal and external parts. It shows that for advanced HBTs, f_max is well characterized by the product of the base resistance and internal collector capacitance. In other words, the external collector capacitance has only a small impact on the determination of f_max. Good agreement between experimental results and numerical circuit simulation confirms the validity of the HBT circuit model. The influence of the external collector capacitance on maximum available gain is also described     

A hybrid spreading/despreading function with good SNR performancefor band-limited DS-CDMA

Code-division multiple-access (CDMA) implemented with direct-sequence spread spectrum (DS/SS) signaling is a promising multiplexing technique for cellular telecommunications services. The efficiency of a direct-sequence spread-spectrum code-division multiple-access (DS-CDMA) system depends heavily on the shape of the spectrum of the spread signal. Maximum efficiency is obtained with an ideal brick-wall bandpass spectrum. There are two approaches toward achieving such a spectrum. One is to use a simple spreader that produces a broad spectrum and then follow it with a precise, high order filter to band limit the spectrum. A second approach, which is the approach taken in this paper, is to use a spreader that produces a spectrum close to the ideal spectrum and then employ a simple filter to control the out-of-band power. The proposed spreader/despreader is based on a simple hybrid function and can be easily implemented. An analysis provides a compact expression for the signal-to-noise ratio (SNR) of a RAKE receiver. The expression includes the effects of baseband, intermediate frequency (IF) and RF filtering as well as the effects of the spectral densities of the spreading/despreading functions. The analysis shows that the proposed spreader/despreader yields superior performance over a conventional pseudo noise (PN) spreading/despreading mechanism     

Étude du refroidissement avec solidification d'un fluide pseudoplastique thermodépendant

Heat transfer of highly consistent shear-thinning fluids flowing in a horizontal cylindrical channel has been investigated numerically and experimentally when the outer channel wall is subjected to a constant convective heat exchange. The case considered being cooling, a possible ice deposit must be taken into account. The variation of the rheological properties with temperature must be considered as well.     

Electrical and optical properties of semi-insulating polycrystalline silicon thin films: the role of microstructure and doping

We have investigated the relationship between microstructure and electrical conductivity in semi-insulating polycrystalline silicon (SIPOS) with oxygen concentrations in the 2–35 at.% range and the effect of doping with boron, phosphorus, arsenic and erbium by ion implantation. SIPOS thin films are mixtures of silicon and silicon oxide phases. The chemical and morphological evolution of these phases upon annealing is emphasized. Electrical conductivity measurements are interpreted in terms of a physical model containing few free parameters related to the material microstructure. A direct extension of this model explains also the conductivity increase in SIPOS doped with elements of the third or the fifth group. In the last part of the paper, data of electroluminescence at 1.54 μm in Er-implanted SIPOS due to intra-4f transitions of the Er³⁺ ion are shown and discussed.     

Shear horizontal wave propagation in periodically layeredcomposites

The transverse resonance approach to guided wave analysis is applied to shear horizontal (SH) wave propagation in periodically layered composites. It is found for SH waves that at high values of the guided wavevector β, the wave energy is trapped in the slower of the two media and propagates accordingly at the slower wavespeed. At low values of β, however, the modes demonstrate a clustering behavior, indicative of the underlying Floquet wave structure. The number of modes in a cluster is observed to correlate with the number of unit cells in the layered plate. New physical insights into the behavior of these systems are obtained by analyzing the partial waves of the guided SH modes in terms of Floquet waves. We show that the fast and slow shear waves in the periodically layered composite play an analogous role to the longitudinal and shear partial waves comprising Lamb waves in a homogeneous plate     

Technology-transfer analysis of the materials research program “Matfo”

The commercial success of the German Federal Ministry's materials research program “Mafto” (1985–1994) was recently evaluated to determine the effectiveness of the direct-funding model in supporting innovative industrial research. Based on the results of a questionnaire, where a 97% return rate was achieved, it was found that the results obtained in 27% of the projects have already been commercialized to some degree, for 26% of the projects a commercialization of the results is planned but has not yet taken place, and for 54% of the projects no commercialization is planned. This study included only projects where at least four years had elapsed since project completion. The reasons why scientifically and technically successfully projects were not commercialized were also surveyed.