Modified method for transformer magnetizing characteristic computation and point-on-wave control switching for inrush current mitigation

This paper proposes a new model for the low-frequency transient analysis of a transformer, with a modified equation for calculation of the flux-current characteristic representing the saturation inductance of the transformer. The model is based on the V-I (voltage-current) no-load curves and uses the no-load reactive power losses. To validate the model, it was used to simulate the no-load magnetizing current in steady-state condition, as well as the transient inrush current at network frequency. Evaluation was done both by comparing the simulation results obtained with the proposed model and those available in the relevant literature, and by practical measurements. The experimental results presented in this paper were obtained via a laboratory setup and a data acquisition system based on the dSPACE board 1104. Moreover, a control switching to mitigate the transient inrush current in a transformer was developed and applied experimentally in the laboratory and also in the simulations. This control strategy was performed by taking into account the residual flux at the opening instant of the related circuit breaker. A comparative study was carried out showing the validity of the proposed model and the mitigation technique.     

Chemical composition and antimicrobial activity of the essential oils from four Ruta species growing in Algeria

Antimicrobial properties of plants essential oils have been investigated in order to suggest them as potential tools to overcome the microbial drug resistance and the increasing incidence of food borne diseases problems. The aim of this research is to study the antibacterial and antifungal effects of four traditional plants essential oils, Ruta angustifolia, Ruta chalepensis, Ruta graveolens and Ruta tuberculata, against standard bacterial and fungal strains. The chemical compounds of the oils were examined by GC/MS. Results revealed a powerful antifungal activity against filamentous fungi. Aspergillus fumigatus and Cladosporium herbarum are the most sensitive strains to these oils with MIC values less than 3.5 μg ml⁻¹ for certain oils, reaching 7.8 μg ml⁻¹ for other. GC/MS essay exhibited ketones as the most abundant constituent of these oils except for R. tuberculata essential oil which has a completely different composition, monoterpenes alcohols being the most abundant. These compositions explain their potential antifungal activity.     

A piecewise switched linear approach for traffic flow modeling

Traffic modeling is a key step in several intelligent transportation systems (ITS) applications. This paper regards the traffic modeling through the enhancement of the cell transmission model. It considers the traffic flow as a hybrid dynamic system and proposes a piecewise switched linear traffic model. The latter allows an accurate modeling of the traffic flow in a given section by considering its geometry. On the other hand, the piecewise switched linear traffic model handles more than one congestion wave and has the advantage to be modular. The measurements at upstream and downstream boundaries are also used in this model in order to decouple the traffic flow dynamics of successive road portions. Finally, real magnetic sensor data, provided by the performance measurement system on a portion of the Californian SR60-E highway are used to validate the proposed model.     

Heat transfer coefficient and thermal losses of solar collector and Nusselt number correlation for rectangular solar air heater duct with longitudinal fins hold under the absorber plate

An experimental investigation has been carried out for a series of system and operating parameters in order to analyze the effect of mass flow rate on heat transfer and Nusselt number characteristics in solar air heater. Experiments are performed at different air mass flow rates; varying from 0.012 to 0.016 kg/s, about hot summer days of Mai 2012. Hourly values of global solar radiation and some meteorological data (temperature, wind speed, relative humidities, etc.) for measuring days are obtained from the Biskra city of Algeria. The experiments encompassed the flow Reynolds number in the range 965.48–1301.4. Longitudinal fins were used inferior the absorber plate for an increase the heat exchange and render the flow fluid in the channel uniform. The effects of mass flow rate of air on the outlet temperature, Nusselt Number, Reynolds Number, Prandtl Number, the heat transfer in the thickness and length of the solar air collector were studied. For this effect was have created a new correlation correspondent of solar air collector with using fins it was written Nu = κ₀Re^1.36Pr^?0.68exp(0.342m)h ^[?0.018Pr].     

Modeling and design of printed antennas using neural networks

A single neural network is developed to model the resonant frequency of rectangular patch printed on uniaxially anisotropic substrate with air gap using effective parameters in conjunction with spectral dyadic Green's function. Also, the strength of ANN models in antenna design is demonstrated by considering two case studies: the design of circular patch antenna and planar inverted‐F antenna. Results show good agreement with literature. © 2011 Wiley Periodicals, Inc. Int J RF and Microwave CAE, 2011.     

Parameter identification of ZnO surge arrester models based on genetic algorithms

The correct and adequate modelling of ZnO surge arresters characteristics is very important for insulation coordination studies and systems reliability. In this context many researchers addressed considerable efforts to the development of surge arresters models to reproduce the dynamic characteristics observed in their behaviour when subjected to fast front impulse currents. The difficulties with these models reside essentially in the calculation and the adjustment of their parameters.     

Increasing end‐to‐end fairness over IEEE 802.11e‐based wireless mesh networks

In this paper, we discuss the issue of fairness in the IEEE802.11e over wireless mesh networks. Fairness is an important factor that we have to achieve before talking about QoS. Inspired by social networks approximations, and to achieve fairness and provide QoS by regulating heterogeneous traffic, we extended the original IEEE802.11e protocol by introducing a new algorithm based on the ‘token bucket’ concept. We also treat the problem of exposed/hidden nodes. Simulation results show that the proposed approach offers better performance than the IEEE802.11e one. Copyright © 2011 John Wiley & Sons, Ltd.     

Prediction of the theoretical and semi-empirical model of ambient temperature

It is well known that the ambient temperature is a sensitive parameter which has a great effect on biology, technology, geology and even on human behavior. A prediction is a statement about an uncertain event. It is often, but not always, based upon experience or knowledge. Although guaranteed accurate information about the future is in many cases impossible, prediction can be useful to assist in making plans about possible developments. As a result, temperature profiles can be developed which accurately represent the expected ambient temperature exposure that this environment experiences during measurement. The ambient temperature over time is modeled based on the previous T _min and T _max data and using a Lagrange interpolation. To observe the comprehensive variation of ambient temperature the profile must be determined numerically. The model proposed in this paper can provide an acceptable way to measure the change in ambient temperature.     

Hydrocyclone Performance with Complex Oil‐Water Emulsions in the Feed

Separation performance of an oil‐water hydrocyclone depends very much on the physical properties of the feed emulsion or dispersion. These properties can be influenced by numerous factors, particularly water cut and the type of emulsion.In this exploratory work, the effects of water cut and flowrate on de‐watering capabilities of a hydrocyclone with a complex emulsion in the feed line are investigated. Two flow rates of 25 and 35L/min were studied and the water cut was varied from about 8 to 65%. For each case separation, efficiency was measured, the emulsion characterized and its stability checked for the three hydrocyclone streams. Drop size distribution was also examined. Comparison of performance with a simple emulsion was also made.