Corrosion failure of Zn–Al detonator housing

Some batches of detonator housings made up of Chromium plated Zn–Al alloy were found in an extensively cracked condition after few months of storage at room temperature. An analysis of the failure showed that the cracks were due to intergranular corrosion facilitated by segregation of lead at the grain boundaries. Improper chromium plating further aggravated the corrosion problem. This failure case emphasises the need for strict control of chemical composition for components made from Zn–Al alloy and the process of Cr plating of the components.     

Microarchitectures for Managing Chip Revenues under Process Variations

As transistor feature sizes continue to shrink intothe sub-90nm range and beyond, the effects of process variationson critical path delay and chip yields have amplified. A commonconcept to remedy the effects of variation is speed-binning, bywhich chips from a single batch are rated by a discrete range offrequencies and sold at different prices. In this paper, we discussstrategies to modify the number of chips in different bins andhence enhance the profits obtained from them. Particularly, wepropose a scheme that introduces a small Substitute Cacheassociated with each cache way to replicate the data elementsthat will be stored in the high latency lines. Assuming a fixedpricing model, this method increases the revenue by as much as13.8% without any impact on the performance of the chips.     

Synthesis and characterization of acidic properties of Al-SBA-15 materials with varying Si/Al ratios

Al-SBA-15 of varying Si/Al ratios in the range 11.4–78.4 was synthesized using tri-block copolymer P123. The calcined materials were examined by XRD, pore size distribution, surface area, ²⁷Al NMR spectroscopy. The acidity and acid strength distribution were studied using microcalorimetric adsorption of NH₃. The acidic properties were also examined by cumene cracking reaction as a function of Si/Al ratios. Systematic variation of acidity and activity was observed as a function of Si/Al ratio. The initial heats of NH₃ adsorption correlated well with activity indicate that acid sites with ΔH > 100 kJ/mole is responsible for cumene cracking activity. Linear correlations were obtained with total acidity and cumene cracking activities. The tetrahedral aluminum was found to be responsible for the observed acidities and catalytic activities.     

Flavor Fade in Peanuts During Short-term Storage

ABSTRACT: Flavor characteristics of roasted peanuts over short-term storage were explored through sensory and chemical analyses. The volatiles from freshly roasted peanuts were evaluated over short-time (21 d) storage using gas chromatography, chemosensory techniques, and a sensory panel to quantify and identify pyrazines and hexanal over a 21-d storage period. A significant decrease ( P < 0.05) was noted in 2,3-diethylpyrazine, 2-methoxypyrazine, 2,3-dimethylpyrazine, 2-ethyl-3-methylpyrazine, and 2,3,5-trimethylpyrazine concentrations over a 21-d period. No significant difference ( P > 0.05) was noted in the 2-methylpyrazine and 2-ethylpyrazine concentrations. The hexanal concentration significantly increased ( P < 0.05) over the 21-d period. The peroxide values and sensory analysis agreed with these results. A significant increase ( P < 0.05) in peroxide value was seen at days 14 and 21, and a significant decrease ( P < 0.05) in fresh roasted peanuty flavor from day 0 to 21 and significant increases ( P < 0.05) in painty, cardboardy, and bitter flavors from day 7 to 21 with the sensory analysis. The electronic nose successfully separated day 0 and 21 samples from day 7 and 14 samples, which were also separated but with some overlap.     

Optimal operation of a multibasin reservoir system

A simulation-optimization procedure is presented for evaluating the extent of interbasin transfer of water in the Peninsular Indian river system consisting of 15 reservoirs on four river basins. A system-dependent simulation model is developed incorporating the concept of reservoir zoning to facilitate releases and transfers. The simulation model generates a larger number of solutions which are then screened by the optimization model. The Box complex nonlinear programming algorithm is used for the optimization. The performance of the system is evaluated through simulation with the optimal reservoir zones with respect to four indices, reliability, resiliency, vulnerability and deficit ratio. The results indicate that by operating the system of 15 reservoirs as a single unit the existing utilization of water may be increased significantly.     

A unique method for reducing losses of bends in dielectric optical wave guide

The dielectric optical wave guide is finding growing attention at millimeter wave frequencies. However the dielectric optical waveguide radiates at bends and thus transmission loss increases. These radiations are in the outword direction of bends. This output radiation at output bends arises due to change in phase velocities of the propagating wave at the centre of the dielectric guide and the phase velocity at the outer surface of the dielectric guide. A unique methiod is suggested to avoid these radiation losses.Experimental results are also shown at microwave frequencies.     

Defensiveness, trait anxiety, and Epstein-Barr viral capsid antigen antibody titers in healthy college students.

Investigated the relationship of individual differences in repressive coping styles with differences in antibody titer to Epstein-Barr (EB) viral capsid antigen in a normal, healthy college population made up of people previously exposed to EB. Each of 54 1st-yr undergraduates completed a battery of physical-status questions and items pertaining to potential behavioral immunomodulatory confounds, along with the Taylor Manifest Anxiety Scale and the Marlowe-Crowne Social Desirability Scale. Ss reporting high and middle levels of anxiety had higher antibody titers to EB, suggesting poorer immune control over the latent virus, as compared with the low-anxious group. Similarly, high-defensive Ss had higher antibody titers than their low-defensive counterparts, and neither group differed from the middle group. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Proportional hazards modeling of time-dependent covariates usinglinear regression: a case study [mine power cable reliability]

In the proportional hazards model, the effect of a covariate is assumed to be time-invariant. In this paper a graphical method based on a linear regression model (LRM) is used to test whether this assumption is realistic. The variation in the effect of a covariate is plotted against time. The slope of this plot indicates the nature of the influence of a covariate over time. A covariate is time-dependent if a drastic change in the slope of the plot is found and the time-point, at which this drastic change occurs provides guideline in redefining a time-dependent covariate into two or more time-independent covariates. This method is applied to failure data of cables used for supplying power to electric mine loaders. The results obtained by applying only the proportional hazards model were misleading as the graphical method based on the LRM showed that one covariate was highly time-dependent. This graphical method should be used to supplement the proportional hazards model, not as a separate method. This avoids misinterpretation of the influence of a time-dependent covariate in the proportional hazards model. The proportional hazards model should be used to identify the most important covariates, while the LRM should be used as an explanatory tool to check the consistency of the influence of the covariates. The LRM involves matrix computations which can be quite time consuming for large data-sets. Also, tests for the statistically significant effect of a covariate are not yet well established in the model