Coating of hydroxyapatite on metal plates using thermal dissociation of calcium-EDTA chelate in phosphate solutions under hydrothermal conditions

Coating of hydroxyapatite on various metal plates was carried out by a homogeneous precipitation technique using hydrothermal reactions in Ca(edta)^2-–NaH₂PO₄ at 140–200°C and pH 3.4–10.0. Hydroxyapatite films were formed on the surface of the iron plates in solutions at an initial pH above 4.7, whereas aggregates consisting of needle-like hydroxyapatite crystal radiating from a point in the form of flower deposited as islands on the surface of aluminum, copper and titanium plates. The upper part of the film formed on the surface of the iron plates consisted of needle-like hydroxyapatite particles whereas the bottom of the film consisted of spherical hydroxyapatite particles. The length of the needle-like hydroxyapatite particles increased with decreasing concentration of Ca(edta)^2-.     

A 1.5-V full-swing BiCMOS logic circuit

A BiCMOS logic circuit applicable to sub-2-V digital circuits has been developed. A transiently saturated full-swing BiCMOS (TS-FS-BiCMOS) logic circuit operates twice as fast as CMOS at 1.5-V supply. A newly developed transient-saturation technique, with which bipolar transistors saturate only during switching periods, is the key to sub-2-V operation because a high-speed full-swing operation is achieved to remove the voltage loss due to the base-emitter turn-on voltage. Both small load dependence and small fan-in dependence of gate delay time are attained with this technique. A two-input gate fabricated with 0.3-μm BiCMOS technology verifies the performance advantage of TS-FS-BiCMOS over other BiCMOS circuits and CMOS at sub 2-V supply     

Phenol novolac/poly(4- hydroxyphenylmaleimide) blend hardeners for DGEBA-type epoxy resin

Phenol novolac/poly (4-hydroxyphenylmaleimide) (PHPMI) blends were used as an epoxy resin hardener. The curing behavior of the above system and the thermal and mechanical properties of the cured epoxy resin were studied. It was not necessary to use a curing accelerator for this system, because PHPMI caused acceleration of the curing reaction. The curing mechanism of this system was investigated by using model compounds. Test pieces from the neat resins and the glass fiber reinforced resins were evaluated in terms of thermal and mechanical properties, respectively. It was found that heat resistance and mechanical properties were improved by increasing the amount of PHPMI in the hardener.     

The cranial MRI in severe cerebral palsy: a comparative study with clinical data

The magnetic resonance examination was performed in 38 patients with severe cerebral palsy (CP; 15 males and 23 females) who had both motor delay (unable to move anywhere) and mental retardation (I. Q or D. Q below 30). Neuroimaging findings were compared with the CP type, etiology, and grade of understanding of language. Cranial magnetic resonance imagings (MRI) in CP were divided into five types. Type 1 : nine predominantly showed cyst-liked ventricles and periventricular hyperintensity on T2-weighted imaging (PVH) and only scarred basal ganglia and thalamus were visible. All suffered from neonatal asphyxia and the clinical type was rigospastic tetraplegia (RST). Type 2: eleven predominantly showed PVH and hyperintensity on T2-weighted (HT2) in basal ganglia and thalamus. All suffered from neonatal asphyxia and the clinical type was RST or rigospastic diplegia. Type 3: five showed PVH and three had cortical atrophy. All suffered from neonatal asphyxia and the clinical type was spastic diplegia. Type 4: four predominantly showed HT 2 in putamen and thalamus. Three had cortical atrophy. All suffered from neonatal asphyxia. The clinical type was athetotic CP (ATH). Type 5: nine predominantly showed HT 2 in globus pallidus. Four had cortical atrophy and two had hippocampal atrophy. All suffered from neonatal jaundice and the clinical type was ATH. All patients who suffered from neonatal asphyxia and spastic CP had MRI in PVH. All patients who suffered from neonatal asphyxia and ATH showed HT 2 in putamen and thalamus. Almost patients who suffered neonatal jaundice and ATH showed HT 2 in globus pallidus. With athetotic CP, cases with atrophy of the cerebral cortex or/and hippocampus were lower grade of understanding of language than no atrophy of both. The result of studies of MRI are in agreement with neuropathological findings.     

Photonic transport network OAM technologies

The optical path concept was proposed to realize ubiquitous B-ISDN. It can make quantum leaps in both transmission capacity and cross-connect throughput simultaneously by exploiting WDM (wavelength division multiplexing) transmission and the wavelength routing capabilities of paths. Since the optical path is a new concept, new operation and management (OAM) systems and related technologies need to be developed before it can be fully utilized. This article discusses some of the key OAM-related issues and identifies the technical points necessary for future developments. The issues include optical path realization technologies, optical path accommodation design problems, a newly proposed optical transport network layer architecture, and the optical transport module for the network node interface     

A case of macrocystic cervical neurinoma diagnosed by MRI with Gd-DTPA

The authors report a rare case of a large cystic cervical neurinoma. A 45-year-old female was admitted to our clinic because of motor weakness of the right upper extremity, numbness of the right fingers and right posterior cervical pain. Metrizamide CT myelography demonstrated the outline of a low density mass. MRI showed a mass revealing low signal intensity on T1-weighted image, high signal intensity on T2-weighted image and marginal enhancement on contrast image with Gd-DTPA. The mass which was diagnosed as cystic tumor, was located in the intradural extramedullary space between C4 to C5 segments. After C4 through C5 laminectomy, the tumor was found to originate from the C5 anterior motor root. The tumor consisted mostly of a cystic part with a very thin solid compartment beneath the capsule. Postoperative course of the patient was uneventful. Although spinal neurinoma is one of the most common spinal tumors, an almost completely degenerated large cystic spinal neurinoma is extremely rare. MRI with Gd-DTPA was useful for the diagnosis of the cystic neurinoma by clearly enhancing the margin of the tumor.     

Beam test of the CsI(Tl) calorimeter for the BELLE detector at the KEK-B factory

We studied the performance of a prototype electromagnetic calorimeter for the BELLE detector at the KEK proton synchrotron for an energy range of 0.25–3.5 GeV. The prototype consisted of an array of 6 × 5 CsI(Tl) crystals with 30 cm length (16.2 radiation lengths) and about 6 cm × 6 cm cross section. The scintillation light of each CsI(Tl) crystal was read out by two large-area PIN photodiodes and charge-sensitive preamplifiers attached at the rear face of the crystal. We measured the energy and position resolution for electrons and the e/π separation for two sets of matrix configurations: one corresponded to the center and the other to the edge of the barrel calorimeter. The overall performance measured by the test proves that the prototype calorimeter is satisfactory for the use in the BELLE detector.     

Elastic, anelastic, and piezoelectric coefficients of langasite: resonance ultrasound spectroscopy with laser-Doppler interferometry

This paper presents advanced techniques to determine all independent elastic-stiffness coefficients C/sub ij/, the associated internal friction Q/sub ij//sup -1/, and piezoelectric coefficients e/sub ij/ of monocrystal langasite (La/sub 3/Ga/sub 5/SiO/sub 14/) using a single rectangular parallelepiped specimen. Langasite's crystal structure belongs to the trigonal system with point group 32, and thus possesses six independent C/sub ij/, two e/sub ij/, and two dielectric coefficients /spl epsiv//sub ij/. All of the elastic and piezoelectric coefficients affect the mechanical resonance frequencies of the solid specimen, and measuring them very accurately permits one to determine the C/sub ij/ and e/sub ij/ with known density, dimensions, and e/sub ij/. We developed a piezoelectric tripod to support the specimen upward and measured the free-vibration resonance frequencies with minimum load from its own weight. This weak and stable acoustic coupling ensures accuracy of the frequency measurement better than 10/sup -5/, enough to determine the coefficients reliably. Our C/sub ij/ fall in the range of results measured with previous (conventional) methods. Our e/sub 11/ is smaller than the reported values by 1.2-13%, and e/sub 14/ is larger by 44-97%. For the internal friction measurement, we used a solenoid coil to vibrate the specimen without any contact. The longitudinal-wave internal friction considerably exceeds the shear-wave internal friction, which can be explained by phonon-phonon interactions.     

Preparation and photoconduction of rapidly quenched films in the Bi2O31bM2O5 system (M=V,Nb and Ta)

The Bi₂O₃1bM₂O₅ films (M=V, Nb and Ta) were prepared by a rapid quenching technique using a twin-roller type equipment. Quenched film of pure Bi₂O₃ partially precipitated a tetragonal phase which differs from well-known β-Bi₂O₃ in structure. In every (Bi₂O₃)_0.975 (M₂O₅)_0.025 composition (2.5% M₂O₅), the tetragonal phase was obtained as single phase, and the tetragonality became greater than that of the pure Bi₂O₃. Beyond this composition, the tetragonality decreased to form δ-phase with a fcc structure with increasing the M₂O₅ content. The lowest V₂O₅ content forming a δ-phase was 5%, while a slight tetragonality still remained in the samples containing 10% Nb₂O₅ and 10% Ta₂O₅, respectively. From the measurement of the photoconductivities of the quenched films, it was proved that a photoconduction appeared in the tetragonal phase while no photoconductivity was observed in the cubic phase. The characteristic of the photoconduction was that a remarkable decrease in the resistivity was observed when a light of ca. 500 nm in wave length was irradiated on the films.