Experimental study of bubbly swirling flow in a vertical tube using ultrasonic velocity profiler (UVP) and wire mesh sensor (WMS)

Two-phase air-water bubbly swirling flow through a pipe is a complex turbulent flow and its prediction is still challenging. The present paper describes the experimental investigation of the air-water bubbly swirling flow in vertical co-current flow. Swirling flow is induced by a twisted tape in a 20 mm inner diameter pipe. The flow is investigated using Ultrasonic velocity profiler (UVP), which allows the measurement of liquid and gas velocities simultaneously. Furthermore, simultaneous measurement of void fraction is performed using Wire mesh sensor (WMS). The experimental results reveal that swirling flow has significant impact on bubbles’ distribution. In low liquid flow rate, the average bubble velocity is fairly uniform along the radial position and void fraction increases in the near wall region. However, increasing liquid flow rate at constant gas flow rate leads to increase in void fraction in the core region, this is mainly due to drift velocity which is affected by centrifugal force. Experimental findings and parametric trends based on the effects of swirling flow are summarized and discussed.     

The use of (green field) biomass pretreatment liquor for fermentative butanol production and the catalytic oxidation of biobutanol

In this study, pretreatment liquor of acid-stored green and yellowish barley silage was used for fermentative acetone–butanol–ethanol (ABE) production. Further, the catalytic oxidation of biobutanol over Pt catalysts was studied to investigate the behaviour of butanol as a fuel in the combustion engine. After the hydrothermal treatment of green and yellowish barley silage followed by enzymatic hydrolysis, approximately 88% and 100% of the available sugars were recovered, respectively. Batch fermentations of pretreatment barley silage liquor, supplemented with gelatinised barley grain, showed good fermentability with total ABE concentrations of 9.0 g/L and 10.9 g/L. Butanol yields of 0.20, 0.17 and ABE yields of 0.28, 0.26 (g/g monosaccharide) were obtained, respectively. In catalytic activity measurements, the conversion of biobutanol became appreciable in the 120–140 °C range, whereas conversions greater than 95% were obtained over 200 °C. Selectivities were also high, although formation of by-products, such as butyraldehyde, was observed.     

Intermittent Hypoxic Therapy Inhibits Allogenic Bone-Graft Resorption by Inhibition of Osteoclastogenesis in a Mouse Model

Systemic Intermittent Hypoxic Therapy (IHT) relies on the adaptive response to hypoxic stress. We investigated allogenic bone-graft resorption in the lumbar spine in 48 mice. The mice were exposed to IHT for 1 week before surgery or 1 week after surgery and compared with controls after 1 and 4 weeks. Complete graft resorption was observed in 33–36% of the animals in the control group, but none in the preoperative IHT group. Increased bone-graft volume was demonstrated by micro-computed tomography in the preoperative IHT group after 1 week (p = 0.03) while a non-significant difference was observed after 4 weeks (p = 0.12). There were no significant differences in the postoperative IHT group. Increased concentration of immune cells was localized in the graft area, and more positive tartrate-resistant acid phosphatase (TRAP) staining was found in controls compared with IHT allogenic bone grafts. Systemic IHT resulted in a significant increase of the major osteoclast inhibitor osteoprotegerin as well as osteogenic and angiogenic regulators Tgfbr3, Fst3l, Wisp1, and Vegfd. Inflammatory cytokines and receptor activator of nuclear factor kappa-B ligand (RANKL) stimulators IL-6, IL-17a, IL-17f, and IL-23r increased after 1 and 4 weeks, and serum RANKL expression remained constant while Ccl3 and Ccl5 decreased. We conclude that the adaptive response to IHT activates numerous pathways leading to inhibition of osteoclastic activity and inhibition of allogenic bone-graft resorption.     

Gaucher Disease Diagnosis Using Lyso-Gb1 on Dry Blood Spot Samples: Time to Change the Paradigm?

For years, the gold standard for diagnosing Gaucher disease (GD) has been detecting reduced β-glucocerebrosidase (GCase) activity in peripheral blood cells combined with GBA1 mutation analysis. The use of dried blood spot (DBS) specimens offers many advantages, including easy collection, the need for a small amount of blood, and simpler transportation. However, DBS has limitations for measuring GCase activity. In this paper, we recount our cross-sectional study and publish seven years of experience using DBS samples and levels of the deacylated form of glucocerebroside, glucosylsphingosine (lyso-Gb1), for GD diagnosis. Of 444 screened subjects, 99 (22.3%) were diagnosed with GD at a median (range) age of 21 (1–78) years. Lyso-Gb levels for genetically confirmed GD patients vs. subjects negative to GD diagnosis were 252 (9–1340) ng/mL and 5.4 (1.5–16) ng/mL, respectively. Patients diagnosed with GD1 and mild GBA1 variants had lower median (range) lyso-Gb1, 194 (9–1050), compared to GD1 and severe GBA1 variants, 447 (38–1340) ng/mL, and neuronopathic GD, 325 (116–1270) ng/mL (p = 0.001). Subjects with heterozygous GBA1 variants (carrier) had higher lyso-Gb1 levels, 5.8 (2.5–15.3) ng/mL, compared to wild-type GBA1, 4.9 (1.5–16), ng/mL (p = 0.001). Lyso-Gb1 levels, median (range), were 5 (2.7–10.7) in heterozygous GBA1 carriers with Parkinson’s disease (PD), similar to lyso-Gb1 levels in subjects without PD. We call for a paradigm change for the diagnosis of GD based on lyso-Gb1 measurements and confirmatory GBA1 mutation analyses in DBS. Lyso-Gb1 levels could not be used to differentiate between heterozygous GBA1 carriers and wild type.     

A rheo-optical apparatus for real time kinetic studies on shear-induced alignment of self-assembled soft matter with small sample volumes

In soft materials, self-assembled nanoscale structures can allow new functionalities but a general problem is to align such local structures aiming at monodomain overall order. In order to achieve shear alignment in a controlled manner, a novel type of rheo-optical apparatus has here been developed that allows small sample volumes and in situ monitoring of the alignment process during the shear. Both the amplitude and orientation angles of low level linear birefringence and dichroism are measured while the sample is subjected to large amplitude oscillatory shear flow. The apparatus is based on a commercial rheometer where we have constructed a flow cell that consists of two quartz teeth. The lower tooth can be set in oscillatory motion whereas the upper one is connected to the force transducers of the rheometer. A custom made cylindrical oven allows the operation of the flow cell at elevated temperatures up to 200 degrees C. Only a small sample volume is needed (from 9 to 25 mm(3)), which makes the apparatus suitable especially for studying new materials which are usually obtainable only in small quantities. Using this apparatus the flow alignment kinetics of a lamellar polystyrene-b-polyisoprene diblock copolymer is studied during shear under two different conditions which lead to parallel and perpendicular alignment of the lamellae. The open device geometry allows even combined optical/x-ray in situ characterization of the alignment process by combining small-angle x-ray scattering using concepts shown by Polushkin et al. [Macromolecules 36, 1421 (2003)].     

3‐Heterocycle‐Phenyl N‐Alkylcarbamates as FAAH Inhibitors: Design,Synthesis and 3D‐QSAR Studies

Carbamates are a well‐established class of fatty acid amide hydrolase (FAAH) inhibitors. Here we describe the synthesis of meta‐substituted phenolic N‐alkyl/aryl carbamates and their in vitro FAAH inhibitory activities. The most potent compound, 3‐(oxazol‐2yl)phenyl cyclohexylcarbamate ( 2 a ), inhibited FAAH with a sub‐nanomolar IC₅₀ value (IC₅₀=0.74 nM ). Additionally, we developed and validated three‐dimensional quantitative structure–activity relationships (QSAR) models of FAAH inhibition combining the newly disclosed carbamates with our previously published inhibitors to give a total set of 99 compounds. Prior to 3D‐QSAR modeling, the degree of correlation between FAAH inhibition and in silico reactivity was also established. Both 3D‐QSAR methods used, CoMSIA and GRID/GOLPE, produced statistically significant models with coefficient of correlation for external prediction (R²_PRED) values of 0.732 and 0.760, respectively. These models could be of high value in further FAAH inhibitor design.     

Search for Superconductivity in Lithium

We report on the results of a search for superconductivity in Li. We find no evidence for the predicted transition to superconductivity at any temperature down to 5 mK in magnetic fields down to 0.4 T. However, an unexpected Curie–Weiss temperature dependence in the magnetic susceptibility is observed. We discuss the possibility that this signal arises from the Li itself, the possibility that it arises from Kondo behavior, and the implications of the effect for the predicted T_c of Li.     

Disruption and phenotypic analysis of seven ORFs from the left arm of chromosome XV of Saccharomyces cerevisiae

We have disrupted seven open reading frames (ORFs) located in the left arm of chromosome XV of the yeast Saccharomyces cerevisiae. These ORFs, previously discovered by our laboratory during the programme of systematic sequencing of the yeast genome, are YOL152w, YOL151w, YOL149w, YOL130w, YOL128c, YOL125w and YOL124c. In most cases, the short flanking homology (SFH) replacement technique has been used. The mutants were analysed for different phenotypic tests. Disruption of YOL130w (also known as ALR1) produced a lethal phenotype, despite the presence of a highly similar gene in the yeast genome (ALR2/YFL050C). Disruption of YOL149w (also known as DCP1, and encoding an mRNA decapping enzyme) results in lethality in the FY1679 background, although it allows slow growth in the CEN.PK141 background. Disruption of the remaining ORFs did not result in readily detectable phenotypic changes.     

Does increased confidence among novice drivers imply a decrease in safety? The effects of skid training on slippery road accidents

Finnish driver training was renewed in 1990 with the inclusion of a compulsory skid training course in the curriculum. The study evaluated the renewal's effect on accidents in slippery road conditions. A questionnaire was sent by mail to 41000 novice drivers who were randomly selected from the official register of driving licences. It included questions on driving exposure and the accidents the drivers had been involved in during 6-18 months following licensing. The rate of return was 74.7%. Half of the drivers had received their licence in 1989 and had, therefore, not received any skid training. The other half had received their licence in 1990 after the introduction of the skid training course. The results showed no effects of the renewal on slippery road accidents for either male or female drivers. Another questionnaire was sent to 1300 old and new curriculum drivers immediately after licensing and a second time 1/2-1 year later, both with questions about skills, worries and perceived risks regarding driving in slippery conditions. The new curriculum drivers showed higher confidence in their skills and they were less afraid to drive in slippery conditions than the old curriculum drivers. This increase in confidence as a result of skid training is discussed. It is argued that high confidence in one's personal skills does not necessarily imply negative safety. The crucial factor is how these skills are used, and for what purpose.