Emittance from stagnation temperature study

Variation of stagnation temperature of various coatings kept in an insulated one glass cover box is theoreticall analysed. This shows that it is possible to make an approximate estimate of thermal emittance of the coating of known absorptance from the knowledge of stagnation temperature, ambient temperature and solar insolation. Such estimate of emittance for several black painted, black chrome and structured nickel coated samples are compared with their emittance values obtained from reflectance data.     

Influence of different process parameters on physical properties of fluorine dopes indium oxide thin films

Fluorine-doped indium oxide films were prepared by the spray pyrolysis technique. The physical properties of these films were investigated with respect to various process parameters, namely variation of dopant concentration (in the solution), deposition temperature (T _s), carrier gas (air) flow rate and the thickness of the film. The best films had a Hall mobility of the order of 28 cm²V^–1 s^–1 and a carrier density of 2.7 × 10²⁰ cm^–3. These films were deposited at T _s=425 °C at an air flow rate of 71 min^–1 for an atomic ratio of fluorine to indium of 72%. The electrical resistivity of these films was of the order of 10^–4 cm and the average transmission in the visible range was found to be 80–90%. The films were polycrystalline, n-type semiconductors with [400] as a preferred orientation. The preferred orientation changes from [400] to [222] depending upon the process parameters.     

Preparation of highly conductive p-type μc-Si:H window layer using lower concentration of hydrogen in the rf glow discharge plasma

Boron doped p-type hydrogenated microcrystalline silicon (μc-Si:H) films have been prepared by radio-frequency glow discharge method. Highly conductive p-type μc-Si:H films can be obtained even with lower concentration of hydrogen in the rf glow discharge plasma if chamber pressure is low. Effects of increase in hydrogen (H₂) flow rate and chamber pressure have been studied. The structural properties of the films have been studied by X-ray diffractometry. The electrical and optical characterization have been done by dark conductivity, Hall measurements and optical absorption measurements respectively. Film with conductivity 0.1(Ω-cm)⁻¹ with band gap 2.1 eV has been obtained.     

A longitudinal study of bacterial vaginosis during pregnancy

OBJECTIVE: To determine the longitudinal changes in the incidence of vaginosis in pregnancy. DESIGN: A prospective study of women during pregnancy. SETTING: A District General Hospital in North-West London. SUBJECTS: Seven hundred and eighteen pregnant women attending antenatal clinics. At their first attendance and subsequently, Gram-stained vaginal smears were examined and Mycoplasma hominis and Gardnerella vaginalis were sought by culture. RESULTS: Initially, 87 (12%) women had bacterial vaginosis diagnosed on Gram-stained reading of the vaginal smears. Examination of further smears, obtained from 176 women at 36 weeks of gestation, showed that those whose vaginal flora was normal initially, and who went to term, rarely developed vaginosis (three of 127, 2.4%). Samples were obtained at 36 weeks gestation from 32 women who had bacterial vaginosis initially, and went to term. In almost 50% (15 of 32) of these a normal lactobacillus-dominated flora had regenerated. Thirty-five women (5%) had initial vaginal smears graded as intermediate. From this group, six of the 17 (35%) women from whom samples were obtained at 36 weeks gestation still had flora of an intermediate pattern; 10(59%) now had normal flora and only one (6%) had developed bacterial vaginosis. Women with bacterial vaginosis were more likely to be culture-positive for M. hominis than those with normal flora (34/78 versus 10/563, odds ratio 42.73 (18.9 to 102.3) P < 0.001), or to be culture-positive for G. vaginalis than those with normal flora (35/78 versus 21/563, odds ratio 21.0 (10.75 to 41.2) P < 0.001). CONCLUSION: Pregnant women do not commonly develop bacterial vaginosis after 16 weeks gestation, and if present, it remits spontaneously in approximately half of those who reach term. As bacterial vaginosis is associated with increased rates of second trimester miscarriage and preterm delivery, any treatment aimed at its eradication in pregnancy should be given no later than the beginning of the second trimester of pregnancy.     

Factors affecting emissions from diesel fuel and water-in-diesel emulsion

The purpose of this research is to investigate the effect of addition of surfactant and water in diesel and to make an emulsified fuel considering the needs for vehicle performance and its cleanest possible operation. The total surfactant concentration in each of the diesel-water emulsion samples studied (span 20, span 80, tween 20, tween 80) is fixed at 1% w/w. The water content is variable at 5–15% w/w and the diesel content is varied from 84 to 94% w/w. Among all the tested nonionic surfactants, tween 80 is found to prominently reduce the carbon monoxide (CO), hydrocarbon (HC), and nitrogen oxide (NOx) emissions. Tween 20 reduced the NOx emission to a greater extent. Diesel emulsion with a fixed ratio of span 80 and tween 80 (1:1) efficiently reduced the overall emissions as compared to diesel alone. The developed diesel emulsion employed with nonionic surfactants clearly reduced the harmful engine emissions such as CO, HC, and NOx, signifying them as a future potential emulsifier in diesel fuel emulsion.     

Routing Mechanisms Employing Adaptive Weight Functions for Shortest Path Routing in Optical WDM Networks

Optical dense wavelength division multiplexed (DWDM) networks are an attractive candidate for the next generation Internet and beyond. In this paper, we consider routing and wavelength assignment in a wide area wavelength routed backbone network that employs circuit-switching. When a session request is received by the network, the routing and wavelength assignment (RWA) task is to establish a lightpath between the source and destination. That is, determine a suitable path and assign a set of wavelengths for the links on this path. We consider a link state protocol approach and use Dijkstras shortest path algorithm, suitably modified for DWDM networks, for computing the shortest paths. In [1] we proposed WDM aware weight functions that included factors such as available wavelengths per link, total wavelengths per link. In this paper, we present new weight functions that exploit the strong correlation between blocking probability and number of hops involved in connection setup to increase the performance of the network. We also consider alternate path routing that computes the alternate paths based on WDM aware weight functions. The impact of the weight functions on the blocking probability and delay is studied through discrete event simulation. The system parameters varied include number of network nodes, wavelengths, degree of wavelength conversion, and load. The results show that the weight function that incorporates both hop count and available wavelength provides the best performance in terms of blocking probability.     

Preparation of Crosslinked Starch Beads as a Medium for Gel Filtration

Potato starch is dispersed in sodiumhydroxide and fine emulsion is obtained by stirring in liquid paraffin at 80°C. The emulsion is crosslinked with epichlorohydrin in presence of sodium borohydride to obtain thermostable beads. Beads of uniform size were obtained by sedimentation under gravity. Mixtures of proteins such as bovine serum albumin (BSA) and cytochrome c can be separated on columns (Ø 2.5 × 25.0 cm) packed with these beads. The elution profiles are similar to that of Sephadex G-100.