Cyclic oxidation response of multiphase niobium-based alloys

Cyclic oxidation tests were performed on multiphase Nb-based alloys containing silicide, Laves, and Nb solid solution phases. In particular, the oxidation resistance of six alloys with various compositions (Nb, Ti, Hf, Cr, Ge, and Si) and microstructures was characterized by thermal cycling from ambient temperature to a peak temperature that ranges from 900 °C to 1400 °C. Weight change data were obtained and the corresponding spalled oxides were collected and identified by X-ray diffraction. The results indicated that Nb-based alloys formed a mixture of CrNbO₄, Nb₂O₅, and Nb₂O₅ · TiO₂, with possibly small amounts of SiO₂ or GeO₂. The oxidation resistance was improved when CrNbO₄ formed instead of Nb₂O₅ and Nb₂O₅ · TiO₂. These results were used to assess the influence of microstructure and composition on the oxidation resistance of multiphase Nb-based alloys.     

一种基于bit位的运动补偿方法

本文讨论了等离子体显示屏所特有的在显示运动画面时出现的伪轮廓线现象，对产生的原因进行了分析并给出了软件模拟的结果。在此基础上，提出了一种基于bit位的运动补偿方法来改善运动图像的画面质量，同时根据人眼的视觉特征对补偿方法做了进一步的优化。最后对基于bit位的运动补偿方法进行了比较和验证，结果表明基于bit位的运动补偿方法可以基本消除运动画面的伪轮廓线现象。     

Ice-slurry production using direct contact heat transfer

An ice slurry generation system was developed using direct contact heat transfer between water and the coolant, Fluroinert FC-84. The location of the coolant nozzle is an important design consideration to avoid clogging due to freezing of water. An ice fraction of up to about 40 percent was obtained with the nozzle located at the bottom of the ice slurry tank and the jet directed upwards into the water. Two simplified model were developed to extract the heat transfer coefficient between the coolant drops and the water. The first model requires as input the average drop diameter and the residence time while the second model uses the measured drop diameter distribution. The estimated heat transfer coefficients are much smaller than those computed using single-sphere correlations.     

芳烃抽提装置技术改造

由于中国石化锦西石化分公司600kt／a连续重整装置的建设，芳烃抽提装置的原料由原来的脱戊烷油变为Ce组分。为此，对抽余油水洗塔和芳烃分离部分的苯塔塔盘，以及苯塔塔顶和塔底抽出部分进行了改造，更换部分机泵和增加变频泵，并将常规仪表改为DCS控制。改造后装置实现一次开车成功，生产出合格产品。抽余油中总芳烃含量小于0．1％，苯回收率达到99%以上。     

Model of Primary Austenite Dendrite Structure in Hypoeutectic Cast Iron

Ｉｔｗａｓｒｅｐｏｒｔｅｄ[1] ｔｈａｔｔｈｅｍｉｃｒｏ ｓｔｅｒｅｏｓｔｒｕｃｔｕｒｅｏｆｐｒｉｍａｒｙａｕｓｔｅｎｉｔｅｉｎｃａｓｔｉｒｏｎｃｏｎｓｉｓｔｓｏｆｐｒｉｍａｒｙｓｔｅｍｓａｎｄｓｅｃｏｎｄａｒｙａｒｍｓｔｈａｔ ｇｒｏｗａｃｃｏｒｄｉｎｇｔｏｄｅｎｄｒｉｔｅｃｒｙｓｔａｌｓｂｒａｎｃｈｒｕｌｅ ,ａｎｄｓｏｍｅｏｆｐｒｉｍａｒｙａｕｓｔｅｎｉｔｅｅｖｅｎｈａｖｅｔｈｉｒｄａｒｍｓ .ＭｉｙａｋｅＨｅｔａｌ[2 ]ｐｒｏｐｏｓｅｄａｃｏｎｃｅｐｔｏｆｒｅｇｉｏｎｍｏｄｅｌｂｙｓｔｕｄｙｉｎｇ…     

Ozonation of CI Reactive Black 5 using rotating packed bed and stirred tank reactor

This study investigates the ozonation of CI Reactive Black 5 (RB5) by using the rotating packed bed (RPB) and completely stirred tank reactor (CSTR) as ozone contactors. The RPB, which provides high gravitational force by adjusting the rotational speed, was employed as a novel ozone contactor. The same ozone dosage was separately introduced into either the RPB or the CSTR for the investigation, while the experimental solution was continuously circulated within the apparatus consisting of the RPB and CSTR. The decolorization and mineralization efficiencies of RB5 in the course of ozonation are compared for these two methods. Moreover, the dissolved and off‐gas ozone concentrations were simultaneously monitored for the further analysis. As a result, the ozone mass transfer rate per unit volume of the RPB was significantly higher because of its higher mass transfer coefficient and gas–liquid concentration driving force. Furthermore, ozonation kinetics was found to be independent of the gravitational magnitude of an ozone gas–liquid contactor. Therefore, the results suggest employing RPBs as ozone‐contacting devices with the advantage of volume reduction. The experimental results, which can be used for further modeling of the ozonation process in the RPB, also show the requirement of correct design for the RPB. Consequently, the present study is useful for the understanding of practical application of RPBs. Copyright © 2004 Society of Chemical Industry     

新型超微晶软磁合金FePCCuMoSi微观结构缺陷的正电子湮没研究

用正电子湮没方法研究了新型超微晶软磁合金的微观结构缺陷，样品选用的是在不同温度下退火的Ｆｅ８１Ｐ１２Ｃ３Ｃｕ１Ｍｏ０．５Ｓｉ２．５合金，结果表明，合金的微观结构构陷大小，密度随退火温度有规律地变化，这种现象可能与非晶的晶化过程有关。