通用串行总线(USB)接口芯片USBN9602的应用

简要介绍了通用串行总线USB的特点,对USB接口芯片USBN9602的内部结构、引脚、寄存器组作了详细的论述,并介绍了其应用。     

A New Measure of Misfit for Covariance Structure Models

Various fit indices exist in structural equation models. Most of these indices are related to the noncentrality parameter (NCP) of the chi-square distribution that the involved test statistic is implicitly assumed to follow. Existing literature suggests that few statistics can be well approximated by chi-square distributions. The meaning of the NCP is not clear when the behavior of the statistic cannot be described by a chi-square distribution. In this paper we define a new measure of model misfit (MMM) as the difference between the expected values of a statistic under the alternative and null hypotheses. This definition does not need to assume that the population covariance matrix is in the vicinity of the proposed model, nor does it need for the test statistic to follow any distribution of a known form. The MMM does not necessarily equal the discrepancy between the model and the population covariance matrix as has been assumed in existing literature. Bootstrap approaches to estimating the MMM and a related quantity are developed. An algorithm for obtaining bootstrap confidence intervals of the MMM is constructed. Examples with practical data sets contrast several measures of model misfit. The quantile-quantile plot is used to illustrate the unrealistic nature of chi-square distribution assumptions under either the null or an alternative hypothesis in practice.

     

硫化氢吸收液的电化学分解条件研究

理想的脱硫工艺应满足体积小、费用低、净化度高、无二次污染等要求。在碱性溶液吸收微量硫化氢时同步进行电解，可有效减小设备体积，并将硫化氢转变为氢气和硫磺，不产生恶性气味。为此，实验研究了温度、浓度、电流密度、pH值等因素对电解阳极过程的影响，确定了适宜的电解条件，并在该条件下进行了吸收实验。结果表明，在最佳电解条件下，硫化钠溶液能充分吸收天然气中经变压吸附提浓的硫化氢（800 mg/m³），吸收率大于99.9％。     

Inhibition effect of carbon dioxide on the oxidation of hydrogen over a platinum foil catalyst

This paper investigates the catalytic ignition of the H₂/O₂/CO₂ mixture on platinum in a stagnation flow at atmospheric pressure experimentally and numerically. We measure the ignition temperatures of the gas mixtures flowing towards resistively heated platinum with various composition ratios and various diluent gases of N₂, Ar and CO₂. Compared with N₂ or Ar, the CO₂ dilution shows higher ignition temperature by about 50 K, even at the same composition ratio. The ignition temperature increase is proportional to the dilution ratio. Through the numerical simulation, it is illustrated that higher ignition temperature is caused by the adsorption of CO₂ and following dissociation on platinum surface, which was to date considered negligible in catalytic combustion.     

An adaptive p-persistent MAC scheme for multimedia WLAN

The letter proposes an adaptive p-persistent-based (APP) medium access control (MAC) scheme for the IEEE 802.11e distributed WLAN supporting multimedia services. The APP MAC scheme adaptively gives differentiated permission probabilities to transmission stations which are in different access category and with various waiting delay. Simulation results show that the APP MAC scheme can improve the performance of multimedia WLAN, such as small voice packet dropping probability, low delay variation, and high system throughput, compared to conventional MAC algorithms     

二氧化锡溅射工艺研究

SnO2 是最早使用也是目前使用最广泛的一种气敏材料 ,使用该材料设计制作的气敏传感器具有许多优点。在简要介绍溅射镀膜的成膜过程和特点的基础上 ,着重介绍了SnO2 膜的制备流程 ,分析了功率和温度变化对成膜质量的影响     

ESD protection design to overcome internal damage on interface circuits of a CMOS IC with multiple separated power pins

This paper reports a real case of electrostatic discharge (ESD) improvement on a complementary metal oxide semiconductor integrated circuit (IC) product with multiple separated power pins. After ESD stresses, the internal damage have been found to locate at the interface circuit connecting between different circuit blocks with different power supplies. Some ESD designs have been implemented to rescue this IC product to meet the required ESD specification. By adding only an extra ESD clamp N-channel metal oxide semiconductor with a channel width of 10 /spl mu/m between the interface node and the ground line, the human-body-model (HBM) ESD level of this IC product can be improved from the original 0.5 to 3 kV. By connecting the separated vertical sync signal (VSS) power lines through the ESD conduction circuit to a common VSS ESD bus realized by the seal ring, the HBM ESD level of the enhanced version IC product with 12 separated power supplies pairs can be significantly improved from original 1 kV up to > 5 kV, without the noise coupling issue.     

Using buried capacitor in LTCC-MLC balun

A novel chip-type ceramic balun designed in the 2.4 GHz ISM band frequency is presented. A buried capacitor is included in the balun, so that the length of the coupled transmission lines can be reduced and can be designed very easily. A meander or spiral broadside coupled-line is adopted to realise the proposed LTCC multi-layer balun. The measured performances of phase and amplitude balance for this LTCC-MLC balun show a good match with computer simulation     

绚丽多彩的楚汉丝织品（之二）──色彩与纹饰

湖南出土的楚汉丝织品，以马王堆一、三号汉墓所出为代表，其色彩反映了我国当时印染工艺技术所达到的高度水平，其纹饰则显示了鲜明的时代特征，表现了运动、气势和古拙的艺术风格，充满着神奇浪漫的色彩。