Sn-9Zn-3Bi/Cu钎焊接头在170℃时效过程中的显微结构

采用ST50润湿实验仪完成了钎焊并研究分析了Sn-9Zn-3Bi/Cu接头在170℃下长期时效的显微结构变化.结果表明:Sn-9Zn-3Bi/Cn接头时效至200 h后在界面处形成单一连续的Cu5Zn8化合物层;时效至500 h和1000 h后,界面处形成了3层化合物层,从铜母材侧起,分别为Cu-Sn化合物层,Cu-Zn化合物层和Sn-Cu化合物层;随着时效时间的增加,整个金属化合物层变厚,而Cu-Zn化合物层减薄,表明Cu-Zn化合物层在时效过程中具有不稳定性.     

HIGH TEMPERATURE OXIDATION AND STRUCTURE OF SCALE AND WHISKERS FOR Fe-Ni-Cr SEALING ALLOYS

The oxidation rate,the growth,morphology and structure of oxide scale and whiskers forFe-Ni-Cr sealing alloys in H_2-H_2O atmosphere at high temperatures have been studied.The growth rate of scale is controlled by diffusion.The scale is composed of Cr_2O_3 andspinel(Fe,Mn)O·Cr_2O_3 and the oxide whisker,are spinel(Fe,Mn)O·Cr_2O_3.     

基于LM算法的宽板V型自由弯曲参数的实时识别

在弯曲成形智能化控制过程的4个要素中，材料性能参数的实时识别占有极其重要的地位。为提高实时识别的精度和效率，根据宽板V型自由弯曲成形的特点，建立了宽板V型自由弯曲成形智能化控制过程材料性能参数实时识别的LM神经网络模型。训练结果表明，与改进的BP网络模型比较，LM网络模型的收敛精度和收敛速度均有明显的提高，为实现弯曲成形过程的智能化控制奠定了基础。     

Nd_2(Fe_(0.9)Si_(0.1))_(14)B的中子衍射研究SCIEI

本文用中子衍射对Nd_2(Fe_(0.9)Si_(0.1))_(14)B在室温及77K进行了测量,用衍射峰的形状分析法进行了数据拟合。结果表明,在室温,Si择优占据4c,8j_1及16k_2晶位;Nd与Fe的磁矩平行于C轴排列。在77K,Si仍择优占据上述三个晶位。算得的Nd磁矩的方向偏离C轴37.8°。     

THEORETICAL CALCULATION OF POINT DEFECTS IN Ni_3Al

Equilibrium equation of point defects in Ll_2 type intermetallic compounds was established tocalculate the relations of the concentration of antisite defects and vacancies and bulk composi-tion in Ni_3Al.The examination of temperature effects on the point defects cleared up the mis.understanding of the properties of the“constitutional point defects”in Ni_3Al.     

ADSORPTION MECHANISMS OF HS-IONS ON SULPHIDE MINERAL SURFACES RELATED TO Na_2S-INDUCED FLOTATION

The adsorption mechanisms of HS~- ions existing in air-saturated alkaline solutions on sulphide minerals (including pyrite, arsenopyrite, chalcopyrite and galena) were investigated. The measurement of adsorption density, solvent extraction-chemical analysis of neutral sulphur at the surfaces, measurements of pulp potential and voltammogram, and flotation tests were done. Both the electrochemical and non-electrochemi cal adsorption models of HS~- ions were established. The former was observed and resulted in the formation of neutral sulphur (S°)when the pyrite and arsenopyrite were chosen, and hence renders the surfaces hy drophobic and induced the two minerals flotation. It is called Na_2S-induced flotation. On the other hand, the latter took place and did not produce S° when the chalcopyrite and galena were selected, and hence de presses the collectorless flotation of the two minerals. The adsorptions of HS~- ions were mainly influenced by potentials, pH and the electron structures of the mineral surfaces.     

弧焊机器人焊接系统的研制与应用

本文介绍弧焊机器人焊接系统的研制及应用。该系统与示教再现型机器人配套,适于CO_2焊接。它采用高性能晶闸管式弧焊电源和推拉丝式送丝机,通过接口盒与机器人控制器通讯,能检测多种故障和报警。经反复试验和生产现场使用,证明该系统性能优良,工作可靠,焊接质量高,成本低,可实现国产化,替代进口产品。     

PVDFѹ�籡Ĥ������������

 传感器采用的28 μm厚的4层结构PVDF压电薄膜制成，传感器表面电极形状的制作采用剪切加丙酮腐蚀的方法，保证了传感器有一定的非金属化的边缘。对于电极的引出是将传感器上、下电极面引脚错开，引出电极比较容易做到穿透式，采用压接端子压接和空心小铆钉铆接两种方法。     

弧焊逆变电源的发展趋势分析

本文针对弧焊逆变电源中的几个关键问题，如功率开关器件的性能特点，增大输出变压器的功率，逆变电源的智能控制等，评述了当前的技术水平及今后的发展趋势。     

Preparation of alumina-doped yttria-stabilized zirconia nanopowders by microwave-assisted peroxyl-complex coprecipitation

Alumina-doped yttria-stabilized zirconia （ADYSZ） nanopowders were prepared by microwave-assisted peroxyl-complex coprecipitation （MAPCC） using ZrOCl2-8H2O, Y2O3 and AICly6H2O as starting materials, NH2-H2O as precipitant and H2O2 as complexant. The effects of adding H2O2 and microwave drying on the preparation and properties of ADYSZ were investigated. The precursors and nanopowders were studied by EDX, XRD, SEM and TEM techniques. The results show that the uniformity of component distribution within ADYSZ nanopowders is improved by adding appropriate dosage of H2O2. Complexing reaction between H2O2 and Zr^4＋ ion restrains the hydrolyzation and precipitation of Zr^4＋ ion. With the addition of H2O2, Al^3＋, y^3＋ and Zr^4＋ ions can be precipitated synchronously in a relatively narrow range of pH value. H2O2 also improves the filterability of the wet precipitate. The highly hydrophilic precipitates can be quickly and effectively separated from aqueous solution. During microwave drying process, the moisture of wet precursors is selectively heated. Quick expansion of steam vapor within the wet colloidal particles causes the aggregations burst into numerous tiny lumps. Compared with oven drying, microwave drying can not only shorten drying time but also reduce aggregation intensity of the resultant ADYSZ nanopowders.