The Impact of Zeta Potential and Physicochemical Properties of TiO2‐Based Nanocomposites on Their Biological Activity

The aim of this research was to observe the relationship between zeta potential, morphology, surface area, porosity, chemical composition, and ecotoxicity of nanocomposite powders such as Au/TiO₂, Ag₂O/TiO₂, PdO/TiO₂, Ag/TiO₂/SiO₂, Ag/N(C)TiO₂, and SiO₂/TiO₂ from which Ag₂O/TiO₂, Ag/N(C)/TiO_2, and Ag/TiO₂/SiO₂ were exhibiting good antimicrobial properties. It was observed, that nanomaterials characterized by similar morphology and zeta potential revealed the similar toxic behavior. The samples of higher agglomeration and higher zeta potential, especially Ag/TiO₂/SiO₂ xerogel and TiO₂/SiO₂ aerogel were generally less ecotoxic to water organisms and plants. They were also not genotoxic in concentrations up to 500 and 250 mg/L, respectively.     

Influence of Nb5+ ions on phase transitions and polar disorder above TC in PbZrO3 studied by Raman spectroscopy

Micro-Raman light scattering experiments on PbZrO₃ (PZO) single crystal doped with Nb⁵⁺ have been investigated. Special attention was paid to the paraelectric (PE) phase in which nominally forbidden first-order Raman spectra were detected at temperatures far above the phase transition T_C. Complex Raman spectra were observed in the vicinity of three structural phase transitions. These results mainly from the coexistence of phases with different symmetries in a wide temperature range below T_C. The Raman measurements have been compared with dielectric and optical observations and proved that polar nanoregions in a centrosymmetric lattice appear well above T_C. It was shown that doping ABO₃ perovskites with heterovalent ions like Nb⁵⁺ unbalances charge neutrality of the lattice and strongly extends the temperature range of polar regions. The investigations performed point out that in the PE matrix the interaction between electrons and lattice vibrations, as recently suggested for pure PZO, plays an important role.     

Novel Positive Allosteric Modulators of µ Opioid Receptor—Insight from In Silico and In Vivo Studies

Opioids are the drugs of choice in severe pain management. Unfortunately, their use involves serious, potentially lethal side effects. Therefore, efforts in opioid drug design turn toward safer and more effective mechanisms, including allosteric modulation. In this study, molecular dynamics simulations in silico and ‘writhing’ tests in vivo were used to characterize potential allosteric mechanism of two previously reported compounds. The results suggest that investigated compounds bind to μ opioid receptor in an allosteric site, augmenting action of morphine at subeffective doses, and exerting antinociceptive effect alone at higher doses. Detailed analysis of in silico calculations suggests that first of the compounds behaves more like allosteric agonist, while the second compound acts mainly as a positive allosteric modulator.     

Genetic Carriers and Genomic Distribution of cadA6—A Novel Variant of a Cadmium Resistance Determinant Identified in Listeria spp.

Listeria monocytogenes is a pathogen responsible for severe cases of food poisoning. Listeria spp. strains occurring in soil and water environments may serve as a reservoir of resistance determinants for pathogenic L. monocytogenes strains. A large collection of Listeria spp. strains (155) isolated from natural, agricultural, and urban areas was screened for resistance to heavy metals and metalloids, and the presence of resistance determinants and extrachromosomal replicons. Of the tested strains, 35% were resistant to cadmium and 17% to arsenic. Sequence analysis of resistance plasmids isolated from strains of Listeria seeligeri and Listeria ivanovii, and the chromosome of L. seeligeri strain Sr73, identified a novel variant of the cadAC cadmium resistance efflux system, cadA6, that was functional in L. monocytogenes cells. The cadA6 cassette was detected in four Listeria species, including strains of L. monocytogenes, isolated from various countries and sources—environmental, food-associated, and clinical samples. This resistance cassette is harbored by four novel composite or non-composite transposons, which increases its potential for horizontal transmission. Since some cadAC cassettes may influence virulence and biofilm formation, it is important to monitor their presence in Listeria spp. strains inhabiting different environments.     

Fabrication and properties of multistage gradient doping Yb:YAG laser ceramics

In order to fully pump and smoothen the temperature gradient of the gain medium, multistage gradient doping Yb:YAG laser ceramics were designed. The composite green bodies were fabricated by tape casting, and multistage gradient doping Yb:YAG ceramics with high optical quality were prepared by vacuum sintering and hot isostatic pressing. For samples pre-sintered at 1740°C for 30 h and then HIP-ed at 1700°C for 3 h in argon at 200 MPa, the in-line transmission values at 1100 nm of YAG, 0.6 at.%Yb:YAG, and 1.5 at.%Yb:YAG ceramics were found to be 83.9%, 84.1%, and 83.3%, respectively. Finally, the 940 nm laser diode was used as the pump source to realize the 1030 nm laser output of multistage gradient doping Yb:YAG ceramic slab with a total energy of 3.43 J. The corresponding optical-to-optical conversion and slope efficiencies were 30% and 45%.     

Influence of calcium concentration on formation of tetravalent chromium doped Y3Al5O12 ceramics

Yttrium Aluminium Garnet (YAG) ceramics doped with chromium were prepared by solid-state reactive sintering in a vacuum. The influence of the charge compensator Ca²⁺ concentration on microstructure, optical properties and efficacy of Cr³⁺ oxidation to Cr⁴⁺ under air annealing was investigated. A non-monotonic dependence of these features on the amount of CaO as an additive was found. The changes in ceramic transparency and microstructure were explained considering the interaction between CaO and Cr₂O₃ at the ceramic grain boundaries, which leads to a different pore evolution in distinct samples during sintering. The efficacy of the oxidation of Cr³⁺ to Cr⁴⁺ strongly depends on the concentration of Ca dissolved in the YAG. The calcium solubility decreases due to the higher oxygen partial pressure of the extra phases on the grain boundaries that decreases the amount of generated Cr⁴⁺ ions. Such phenomenon explains the lower concentration of Cr⁴⁺ ions in the sample with 0.8% of Ca against the one with 0.5%. The experiment shows that the ceramic with 0.5% of Ca has a better in-line transmission and a higher concentration of Cr⁴⁺ ions in comparison with samples with a different Ca concentration.     

Formation Mechanism of AlN–SiC Solid Solution by Combustion Nitridation in Si3N4–Si-Al-C System

The synthesis of solid solutions of AlN–SiC was investigated through the combustion reaction between Si₃N₄, aluminum, and carbon powders and nitrogen gas at pressures ranging from 0.1 to 6.0 MPa. The combustion reaction was initiated locally and then the wave front propagated spontaneously, passing through the cylindrical bed containing the loose powder. In the presence of Si₃N₄ as a reactant, it was feasible to synthesize solid solutions at an ambient pressure (0.1 MPa). The relationship between nitrogen pressure and full-width at half-maximum of the (110) peak of the product showed that lower pressures produced more-homogeneous solid solutions. Some aspects of formation of the AlN–SiC solid solutions were discussed with special emphasis on the influence of nitrogen pressure and reactant stoichiometry.     

Sorption Properties of Vacuum-Dried Strawberries

This work demonstrates the influence of changes in parameters of vacuum drying (temperature and pressure) on the sorption properties of dried strawberries. Fruits were dried at 50 and 70°C under pressures of 4 and 16 kPa. Vacuum drying was also conducted during the first 4 h at 70°C and then the temperature was decreased to 50°C at a pressure of 4 kPa. The other combination included increasing the pressure after the first 4 h from 4 to 16 kPa at a drying temperature of 70°C. Sorption isotherms were determined in the dried strawberries. It was shown that with increasing drying temperatures, there was a notable deterioration in the capacity for absorbing water vapor by the vacuum-dried fruit. On the other hand, the pressure at which vacuum drying proceeded did not significantly affect water vapor absorption. Changing the parameters of vacuum drying—that is, temperature in the range of 50–70°C and pressure in the range of 4–16 kPa—affected the shape and structure of the resultant dried strawberries. The combination of vacuum drying with convective drying also influenced the shape and structure of the dried fruit.