An improved Gaussian approximation for probability of bit-erroranalysis of asynchronous bandlimited DS-CDMA systems with BPSK spreading

This paper analyzes probability of bit-error (P_e) performance of asynchronous bandlimited direct-sequence code-division multiple-access systems with binary phase-shift keying spreading. The two present methods of P_e analysis under bandwidth-efficient pulse shaping: the often-cited standard Gaussian approximation and the characteristic function (CF) method suffer from either a low accuracy in regions of low P_e (< 10^-3) or a prohibitively large computational complexity. The paper presents an alternate method of P_e analysis with moderate computational complexity and high accuracy based on a key observation. A sequence of chip decision statistics (whose sum yields a bit statistic) forms a stationary, m-dependent sequence when conditioned on the chip delay and phase offset of each interfering signal. This observation permits the generalization of the improved Gaussian approximation previously derived for the rectangular pulse and the derivation of a numerically efficient approximation based on the CF method. Numerical examples of systems using the square-root raised-cosine and IS-95 pulses illustrate THE P _e performance, user capacity and the accuracy of the proposed method     

Measurements of single chain form factors by small-angle neutron scattering from polystyrene blends containing high concentrations of labelled molecules

A series of small angle neutron scattering measurements on blends of normal polystyrene (PSH) and labelled (deuterated) polystyrene (PSD) have been made with concentrations of PSD from 5 to 50 mol %. It is shown that the single chain form factor of the polymer in bulk can be obtained from a single concentration measurement for any concentration of labelled molecules, providing the molecular weights of the parent and labelled molecules are the same and the molecular weight distributions are narrow.     

On the reliability of computer predictions of the geomechanical behaviour of rock-salt

Geomechanical aspects of the storage of radioactive waste in salt formations have been studied extensively using finite element methods over the last 20 years. In consequence a range of computer programs and associated modelling techniques have been assembled. The paper is based on a benchmark exercise to compare the predictive abilities of a number of these programs and highlights the difficulties of making reliable a-priori estimates of long term behaviour.     

Wear in check valves due to flow induced motion

Experiments showing the frequency and amplitude of the flow induced motion of the gate for a 2- and a 4-in. swing check valve have been performed. The gate motion is due to turbulence in approach flow. We have found the dominant turbulent frequency of the approach flow is about half the natural frequency of the valves. The valves appear to be almost critically damped. Because of this, the valves respond almost as they would to a static force of the magnitude characteristic of the turbulent fluctuation in the flow. Both the dimensionless exciting force and the damping ratio have been found to be independent of valve size so the above statements are true for larger valves also. The recommended valve oscillation amplitudes and frequencies are used to calculate the wear at the shaft and at the stop. For an unpegged check valve, such as one of the 10-in. valves which was used at the San Onofre Nuclear Generation Station, it was found that shaft bearing wear would amount to 0.27 in.³/year and stop wear to 0.03 in.³/year.     

Influence of Lipid Composition on the Water and Fat Exudation and Gel Strength of Meat Batters

Blends of lard with eight separate fats or oils (70:30 w/w) were prepared and used as the fat component of meat batters. After cooking, the batters were analyzed for water and fat exudation and gel strength. None differed significantly from the control of 100% lard. Positive correlation coefficients, however, were significant between percent monounsaturated triglycerides and water exudation, polyunsaturated triglycerides and fat exudation and saturated triglycerides and gel strength. Addition of lecithin, cholesterol or methyl palmitate to the lard increased fat exudation and decreased gel strength. Sodium laurate had the opposite effect whether added to the lard or to the aqueous phase.     

A systematic techno-economic assessment of a WEC system installation for low-cost electrification of a habitable dwelling

This paper deals with the technical feasibility and economic viability of a grid connected wind-energy conversion system (WECS) used to cover the energy demand of an average habitable dwelling. The various parts of the wind-energy system are described and the useful electrical energy production is determined using a simulation program based on the Monte Carlo method. An economic analysis of the WEC system is performed using a computerized assessment tool. Important financial indices are calculated and financial scenarios investigated.     

Molecular correlations in sheared thermotropic copolyesters showing banded textures

Banded textures produced in a thermotropic liquid crystal polymer by shearing between glass slides are examined by using both transmission electron and polarized light microscopy. The periodic variation in director orientation about the shear axis, as measured by light microscopy, is shown to be distinctly different from that indicated by electron diffraction. Measurements of birefringence and observation of Zernicke phase contrast indicate periodic variations in optical properties of the polymer, in step with the bands. Such effects are accounted for in terms of a synchronous rotation of the planar aromatic groups about the molecular chain axes. Evidence for an out-of-plane component of molecular orientation is also presented.     

Soft-spring nonlinear vibrations of antisymmetrically laminated rectangular plates

This paper deals with the effects of initial geometric imperfections and in-plane boundary conditions on the large-amplitude vibration behavior of angle- and cross-ply rectangular thin plates. It is found that the presence of imperfection amplitudes of the order of only half the total laminated-plate thickness may significantly raise the vibration frequencies and change the large-amplitude vibration behavior from the well-known hard-spring to soft-spring behavior. The effects of fibre angles and bending-stretching coupling for angle-ply plates and Young's moduli ratios and number of layers for antisymmetric cross-ply plates are examined.