The influence of packaging materials on RF performance

At frequencies beyond 1 GHz, every component of the IC package contributes to the RF performance, whether required or not. In this work, we study the effects of packaging materials namely, the substrate and the globtop/underfill material on RF performance. We have measured interconnects on two area-array CSPs, the ball grid array and the polymer stud grid array using IMEC’s MCM-D technology. The measurements on the package interconnect show that the losses in the package substrate material account for about 50% of the total losses at 1.8 GHz and this drops to less than 20% at 5.2 GHz. The losses due to impedance mismatch dominate the losses especially below 10 GHz and considerable improvement in performance cannot be obtained by using an improved/expensive substrate. The other study is about the influence of globtop/underfill materials on wirebonds (through 3D EM simulations) as well as on standard 50 Ω MCM-D transmission lines (through experiments). While a higher value of dielectric constant of the globtop/underfill material is better on wirebonds, the influence of loss tangent is felt only above values of 0.1. The influence of seven different globtop/undefill materials on 50 Ω transmission lines has been used to extract their dielectric constant and loss tangent values at 30 GHz. These results are very valuable since one can hardly find the properties of globtop/underfill materials beyond 1 GHz.     

土质边坡稳定分析中条分法与有限元法的比较

对比分析了土质边坡稳定性计算中条分法和有限元法的特点，讨论了在有限元法中边坡稳定系数的计算方法，并针对铜钟水电站库区左岸滑坡分别采用条分法和有限元法研究其稳定性，计算结果表明两种计算方法得到的滑坡稳定系数规律相同，但条分法计算值一般大于有限元值，反映出条分法中部分基本假设与实际情况存在一定差异。     

New insights into the relation between channel hot carrier degradation and oxide breakdown short channel nMOSFETs

In this letter, we report new findings in the relation between channel hot-carrier (CHC) degradation and gate-oxide breakdown (BD) in short-channel nMOSFETS biased at V/sub G/>V/sub D/. We observe that the time-to-BD is strongly reduced in the hot carrier regime and that although the channel hot-electron injection into the oxide occurs mainly at the drain side, stress-induced leakage current (SILC) generation and oxide BD always occur at the source side. The results of these measurements indicate that not solely the energy of the injected electrons but also the oxide electric field is determinant in the oxide BD process.     

Insulin-like growth factor I activates the invasion suppressor function of E-cadherin in MCF-7 human mammary carcinoma cells in vitro

The calcium-dependent cell-cell adhesion molecule E-cadherin has been shown to counteract invasion of epithelial neoplastic cells. Using three monoclonal antibodies, we have demonstrated the presence of E-cadherin at the surface of human MCF-7/6 mammary carcinoma cells by indirect immunofluorescence coupled to flow cytometry and by immunocytochemistry. Nevertheless, MCF-7/6 cells failed to aggregate in a medium containing 1.25 mM CaCl2, and they were invasive after confrontation with embryonic chick heart fragments in organ culture. Treatment of MCF-7/6 cells with 0.5 microgram ml-1 insulin-like growth factor I (IGF-I) led to homotypic aggregation within 5 to 10 min and inhibited invasion in vitro during at least 8 days. The effect of IGF-I on cellular aggregation was insensitive to cycloheximide. However, monoclonal antibodies that interfered with the function of either the IGF-I receptor (alpha IR3) or E-cadherin (HECD-1, MB2) blocked the effect of IGF-I on aggregation. The effects of IGF-I on aggregation and on invasion could be mimicked by 1 microgram ml-1 insulin, but not by 0.5 microgram ml-1 IGF-II. The insulin effects were presumably not mediated by the IGF-I receptor, since they could not be blocked by an antibody against this receptor (alpha IR3). Our results indicate that IGF-I activates the invasion suppressor role of E-cadherin in MCF-7/6 cells.     

Cimaterol and clenbuterol residue analysis by HPLC-HPTLC in liver.

A method has been developed for the analysis of cimaterol and clenbuterol residues in liver, with detection limits of 0.25 micrograms/kg and 0.5 micrograms/kg, respectively. The recovery varied from 55% to 60%. After extraction, a clean-up procedure with Baker-spe C-18 columns was performed. The two chemical compounds of interest were eluted with methanol. Cimaterol and clenbuterol were quantitatively determined by high-performance liquid chromatography (HPLC) using an RP-Select B (5 microns) column and a post-column reaction procedure. The positive results were confirmed by high-performance thin-layer chromatography (HPTLC) as this technique reaches the same level of sensitivity as the HPLC method.     

Very low surface recombination velocities on p-type silicon wafers passivated with a dielectric with fixed negative charge

Surface recombination velocities as low as 10 cm/s have been obtained by treated atomic layer deposition (ALD) of Al₂O₃ layers on p-type CZ silicon wafers. Low surface recombination is achieved by means of field induced surface passivation due to a high density of negative charges stored at the interface. In comparison to a diffused back surface field, an external field source allows for higher band bending, that is, a better performance. While this process yields state of the art results, it is not suited for large-scale production. Preliminary results on an industrially viable, alternative process based on a pseudo-binary system containing Al₂O₃ are presented, too. With this process, surface recombination velocities of 500–1000 cm/s have been attained on mc-Si wafers.     

Comments on “Multiphase systolic algorithms for spectraldecomposition” [and reply]

Comments that the paper by Liu and Yao (see ibid., vol.40, no.1, p.190, 1992) presented an efficient algorithm for spectral decomposition, but the parallel algorithm and architecture for the Hessenberg reduction has a problem. The matrix obtained from the unitary similarity transformation is not necessarily a Hessenberg matrix. The authors reply that the Hessenberg reduction described is not in the Hessenberg form. Only the first column is in its proper form. There are many ways to overcome such a problem. One simple way is to use the multiphase rectangular systolic array