山东省水利系统推行政务公开工作探讨

1水利部门政务公开的重要意义水是基础性的自然资源和战略性的经济资源,又是控制性的生态要素。水利工作事关全省经济社会发展大局,事关广大人民群众的根本利益。在全省水利系统推行政务公开,是实践"三个代表"重要思想,坚持治     

Strategy for olive mill wastewater treatment and reuse with a sewage plant in an arid region.

This study was conducted to evaluate the treatability of OMW (olive mill wastewater) with sewage and sewage sludge, which could supplement nutrients and microbes required for OMW treatment and reduce its possible toxicity. The amount of OMW added to an aeration tank was based on the loading difference between the designed and actual COD loads, while the amount added to anaerobic digestion for energy recovery was determined by CH4 production. The COD removal efficiencies were 70-85% for both systems. Compost of OMW with dried sewage sludge also showed a similar temperature profile without OMW addition. This strongly suggested that OMW can be treated at a sewage plant without pretreatment and the treated effluent can be reused in irrigation for an arid region.     

Possibility of sewage and combined sewer overflow reuse with biological aerated filters.

The secondary effluent from municipal plants in Korea generally represents higher BOD with lower SS. Therefore, more soluble forms of organics and NH4-N need to be removed to improve its effluent for reuse. In this study reuse possibility of secondary effluent and CSO (combined sewer overflow) using BAF (biological aerated filter) was evaluated. The tertiary application with 1.2 h EBCT, SS, BOD and COD showed stable concentrations less than 1.3, 1.3 and 6.2 mg/L, respectively. Nitrogen could be nitrified even at 7 degrees suggesting BAF can be used for a water reuse method as well as an effective add-on facility in cold regions. However, BAF was not stable with CSO application at increased flow rates suggesting CSO must be equalised prior to application. Disinfection was necessary even during normal weather conditions.     

B2O3/TiO2-ZrO2催化剂上环己酮肟的气相Beckmann重排反应

用共沉淀法制备了TiO2-ZrO2复合氧化物载体，BET，DTA，XRD表征结果表明，该复合载体具有较大的比表面和较好的热稳定性，对于环己酮肟气相Beckmann重排反应制己内酰胺，用复合载体制备的B2O3／TiO2-ZrO2催化剂，比分别以TiO2,ZrO2为载体所制备的B2O3/TiO2和B2O3／ZrO2催化剂具有更高的活性和选择性，实验表明，催化剂表面中等强度的酸位是环己酮肟气相Beckmann重排反应的有效活性中心。     

气相色谱在线分析变压吸附法制纯氢中的总碳

利用带镍加氢转化炉的气相色谱仪 ,在线分析变压吸附法制纯氢中的总碳。该法用变压吸附法制的纯氢作燃气 ,在检测器前端将氢气中的CO和CO2 转化为CH4,然后用氢火焰离子化检测器检测 ,直接以检测器的信号 (mV)进行定量。当氢气中总碳体积分数在 1 9～ 5 0 0 μl/L时 ,FID信号值与总碳体积分数有良好的线性关系。方法回收率为 99 90 %～ 10 1 9%,相对标准偏差 <1%。     

溶胶-凝胶法制备TEOS-DOS基SiO2疏水减反射膜:溶胶微结构对膜性能的影响

以乙醇为溶剂,正硅酸乙酯(TEOS,tetraethoxysilane)在氢氧化铵催化下水解缩聚为纳米尺度的无定型SiO2溶胶颗粒,二甲基二乙氧基硅烷(DDS,dimethyldiethoxysilane)在盐酸催化下水解缩聚为线状聚二甲基硅氧链.用混合溶胶在玻璃基片上旋转镀膜,然后于80℃空气气氛下热处理.实验证明通过DDS将疏水的双甲基链引入镀膜胶体,使膜兼具疏水性和减反射性能.利用激光散射粒度分析仪和电子显微镜研究了溶胶颗粒的粒度变化和聚集情况等溶胶微结构,用物理吸附仪研究了膜的孔结构,考察了热处理前后膜的疏水性和透射谱,得到了溶胶微结构与膜性能之间的关联.     

Casein Hydrolysate Fractions Act as Emulsifiers in Process Cheese

ABSTRACT: Degrees of hydrolysis and emulsifying activity of casein hydrolysates were the highest at 4 h hydrolysis. The oil-off values of the mixture of hydrolysate (H) or supernatant (S) and traditional emulsifier (T) were not significantly different from the control made with traditional emulsifier, except for S + T = 3:1. Two other samples made with hydrolysate or supernatant only (H or S) showed higher oil-off value than the others (p < 0.05). In flavor property, no difference was found between samples made with traditional emulsifier and those made with the mixture of hydrolysate or supernatant at the ratio of 3 to 1. Therefore, these results indicated that a mixture of the hydrolysate or supernatant and traditional emulsifier might replace a traditional emulsifier in process cheese manufacturing.     

碳掺杂β-FeSi2薄膜的电子显微学研究

本文利用透射电子显微镜对离子注入合成的β-FeSi2和β-Fe(C,Si)2薄膜进行了对比研究.电镜观察结果表明,选择C作为掺杂元素,能够得到界面平直、厚度均一的高质量β相薄膜,晶粒得到细化,β-FeSi2层稳定性提高.尤其在60kV、4×1017ions/cm2条件下注入直接形成非晶,在退火后会晶化为界面平滑、厚度均匀的β-FeSi2薄膜.因此从微结构角度考虑,引入C离子有益于提高β-FeSi2薄膜的质量.     

光纤专用网中基于DSP的Q值在线检测模块的设计

基于误码率与Q值的对应关系，本文介绍一种Q值在线检测方法，模块设计采用DSP技术，并讨论了该模块在光纤工业专用网（FIN）中的应用。     

Al-Cu-Fe系初生准晶相凝固过程的电子显微分析

采用包括金相（OM），粉末X射线衍射（XRD），扫描电子显微镜（SEM）观察和透射电子显微（TEM）分析等方法，研究了铸态Al592.Cu36.8Fe3.0Si1.0合金（700℃保温2．5h后水淬）的显微组织及相组成。发现铸锭中存在4种相：准晶I相，τ3相（或φ相），θ－Al2Cu相和η－AlCu相，凝固过程可描述为：初生晶是准晶Ⅰ相；在保温过程中发生包晶或共晶反应（L＋i→τ3(或φ）或L→τ3（或φ）＋i)形成的τ3相（或φ相），呈微畴结构；而剩余液体水淬形成θ－Al2Cu相和η－AlCu 相。