PERCHLOROETHYLENE EXTRACTION DESULFURIZATION OF LOW SULFATE COALS

The perchloroethylene coal refining process utilizes perchloroethylene (PCE) as its solvent in all phases of the precombustion desulfurization process, including wet grinding, organic sulfur removal, gravitational separation of pyrites and mineral matter, and recovery of elemental sulfur (S₈). The Process is capable of producing compliance coal which emits less than 1.2 lb SO_X/MBTU when burnt, starting from 5 mass percent sulfur Midwestern and Eastern U.S. coals. However, the process efficiency was found to be very strongly dependent upon the degree of weathering or the level of coal oxidation. In this paper, perchloroethylene extraction data of fresh, low-sulfate coals are summarized and critically assessed. The extraction efficiency of the organic sulfur removal ranged from 5 to 30 percent for fresh coals, while that for weathered coals ranged from 30 to 60 percent. This study provides a valuable insight into the chemical reaction mechanism of perchloroethylene desulfurization process.     

Improved Yen-Joye's authenticated multiple-key agreement protocol

An authenticated multiple-key agreement protocol is proposed. The protocol is not only secure against the unknown-key attack but also more efficient than other protocols.     

Flicker noise in gate overlapped polycrystalline silicon thin-filmtransistors

A study of the noise performance of gate overlapped polycrystalline silicon thin-film transistors (TFTs) is presented. Low-frequency noise measurements were carried out on n- and p-type samples fabricated by excimer laser crystallization. It is shown that the carrier number fluctuation model applies not only to n-type but also to p-type devices. The density of oxide traps was extracted from the noise measurements and was of the order of 10¹⁸-10¹⁹ eV^-1 cm^-3     

The effect of topical corticosteroids on refractive outcome and corneal haze after photorefractive keratectomy

BACKGROUND: The effect of topical corticosteroids after excimer laser photorefractive keratectomy (PRK) remains a matter of some controversy. Refractive effects may be different according to the amount of myopia and timing of instillation. METHODS: Two groups of patients were studied: Study A consisted of 215 eyes (128 patients) with PRK (mean baseline myopia, -6.53 +/- 2.22 D) that received no corticosteroids (No Corticosteroid Group) unless significant regression or corneal haze appeared (Delayed Corticosteroid Group), and in Study B, we randomly assigned eyes to the Initial Corticosteroid Group (mean baseline myopia, -6.39 +/- 1.84 D) or the No/delayed Corticosteroid Group (mean baseline myopia -5.78 +/- 2.02 D). Clinical results after PRK for low-to-moderate and high myopia were compared. RESULTS: In the first group, 70.9% (73 eyes) of moderately myopic eyes (mean, -4.56 +/- 1.10 D) belonged to the No Corticosteroid Group that had a mean refraction of -5.39 +/- 1.77 D. Delayed Corticosteroid Group eyes were more myopic (mean, -7.52 +/- 2.10 D), and showed more severe haze than those in the No Corticosteroid Group. In study B, only in high myopes with more than -6.00 D (mean, -7.76 +/- 1.15 D) did refraction and corneal haze outcomes show significant difference between the Initial Corticosteroid Group and the No/delayed Corticosteroid Group. CONCLUSIONS: The effects of topical corticosteroids after PRK were less in moderate myopes compared to high myopes. Delayed instillation of corticosteroids did not reverse the regression or haze whereas initial instillation showed a beneficial effect on high myopes but not on moderate myopes.     

Recording of volume hologram using a beam pattern from taperedoptical fiber

A photorefractive volume hologram was recorded and probed using light diffracted from a tapered optical fiber as a reference beam. A single-mode fiber (SMF) was chemically etched and tapered to give a complicated beam pattern, and it is shown that the tapered optical fiber can be utilized to increase the storage density of the volume hologram. Spatial selectivity of the volume hologram with this method was increased by two times compared to the normal SMF referencing, which is due to the fact that the complicated beam pattern has little correlation with its shifted version     

Revised cutoff values of serum aminotransferase in detecting viral hepatitis among CAPD patients: experience from Taiwan, an endemic area for hepatitis B

BACKGROUND: To determine the best cutoff values of aspartate aminotransferase (AST) and alanine amino-transferase (ALT) in detecting viral hepatitis C infection among patients of continuous ambulatory peritoneal dialysis (CAPD). METHODS: 90 (44 male and 46 female) CAPD patients and 526 adult controls (266 male, 260 female) were enrolled. Serum AST and ALT were measured by an auto-analyser monthly. Serum HBsAg was examined using a RIA method and anti-HCV by an second-generation EIA method. The best cutoff values of AST and ALT for detecting viral hepatitis were obtained from the ROC (receiver-operating characteristic) curve. RESULTS: The prevalence of anti-HCV(+) was significantly higher in CAPD patients (16.7%) than in normal controls (4.9%), while that of HBsAg(+) was similar in both groups. CAPD patients had significantly lower levels of serum aminotransferases compared to normal controls. Mean AST were 23.8 IU/l in normal control and 18.8 IU/l in the CAPD patients (P < 0.001). Mean ALT were 21.9 IU/l in normal controls and 15.3 IU/l in the CAPD patients (P < 0.001). CAPD patients with HCV infection had higher serum AST and ALT levels than those without. However, HBV infection did not cause significant serum aminotransferase elevation in patients. The conventional cutoff values of AST (40 IU/l) and ALT (40 IU/l) for detecting viral hepatitis yielded only a sensitivity of 27.3 and 18.2% respectively; on the contrary, our revised cutoff values of AST (24 IU/l) and ALT (17 IU/l) had better sensitivities (AST, 72.7%; ALT, 63.6%). For serial aminotransferase values, the sensitivity of AST and ALT for detecting HCV were 36.4 and 27.3% by conventional criteria, and were both 81.8%, by our newly revised criteria. CONCLUSIONS: Serum aminotransferase cutoff values should be modified for screening viral hepatitis in a CAPD population. Our new cutoff criteria had important clinical implications in providing benefits of earlier detection and possible prevention from chronic hepatic deteriorations.     

Coronary bypass in vascular patients: a relatively high-risk procedure

A premise of cardiac risk stratification is that the added risk of coronary artery bypass grafting (CABG) is offset by the improved safety of subsequent vascular reconstruction (VR). We questioned if elective CABG is patients with severe peripheral vascular disease (PVD) is a relatively high-risk procedure. A cohort study of 680 elective CABG patients from January 1993 to December 1994 was performed using three mutually exclusive outcomes of complication-free survival, morbidity, and mortality. Patient characteristic, operative, and outcome data were prospectively collected. Retrospective review determined that 58 patients had either a standard indication for or a history of VR. Overall CABG mortality was 2.5%, with statistically similar but relatively higher rates for PVD as compared to non-PVD patients. In contrast, major morbidity occurred at rates 3.6-fold higher in PVD patients (39.7%) than in disease-free patients (16.7%) after adjustment for the effects of patient and operative variables (odds ratio [OR] 3.67, 95% confidence interval [CI] 1.93-6.99). CABG morbidity in the PVD patient was most likely in those patients with aortoiliac (OR 9.51, CI 3.20-28.27) and aortic aneurysmal (OR 5.24, CI 1.28-21.41) disease types. CABG in PVD patients is associated with significant major morbidity. Such morbidity may preclude or alter the timing of subsequent VR.     

Statistical synchronization among participants in real-time multimedia conferencing

In this paper, an algorithm to determine the set of packets generated continuously and periodically from different participants that are arriving at a node either for mixing at the master of a conference, or for simply playing back at a regular participant of a conference, is proposed. The essence of the algorithm is to estimate the expected packet arrival time (or reference time) for each participant. With the reference time at hand, the maximum jitter and the optimum waiting time for a mixer to wait packets from all participants can be determined. An enhancement to improve synchronization which deals with the estimation of the time offsets between the individual periods of the sources and the period of the receiver is also presented. The error of the proposed algorithm is enumerated by the Chernoff bound and demonstrated by simulation and is shown to be acceptable in practical application. The algorithm can also be employed when traffic sources operate with different periods.     

隧道挖掘中采用补偿灌浆的实例

在英国伦敦多克兰斯轻便铁路刘易舍姆延长线（DLR－LWE）双隧道掘进工程中，在敏感建筑物下进行了补偿灌浆，以防止隧道开挖引起的过度沉降。但是，过度灌浆也会对隧道下部施加超越。介绍了由隧道掘进承包商所编辑的关于地面和建筑物沉降以及由补偿灌浆引起的隧道衬砌变形的详细现场监测数据。     

Principle and applications of retroreflective vision sensing for discrete part-presentation

For flexible manufacturing of short production runs where a large variety of product sizes, component types, and surface reflectance characteristics are encountered, it is desirable to build flexible computer-controlled systems for feeding parts into machine tools or assembly processes that combine maximum flexibility and reliability with minimum cost and cycle-time. This is not a general bin-picking problem; the parts are assumed to be propositioned approximately in totes/pallets/kits with regularly spaced locations. This article presents a machine vision technique based on the principle of retroreflective vision sensing for part-presentation. Since retroreflective material has a distinctive surface reflectance that is not commonly found in natural or man-made objects, the use of retroreflective surfaces enables reliable high object-to-background contrast images to be obtained for a wide variety of objects. Unlike conventional machine vision techniques, which rely on the variance of the surface reflectance of the objects to generate detailed images, retroreflective vision sensing aims at generating a reliable two-dimensional digital object silhouettes so that the location and orientation of the part can be reliably determined. Two application examples, machine loading and assembly, are illustrated.