Engineering model of a passive planar air breathing fuel cell cathode

The behavior of an air breathing fuel cell (ABFC) operated on dry-hydrogen in dead-ended mode is studied using theoretical analysis. A one-dimensional, non-isothermal, combined heat and mass transport model is developed that captures the coupling between water generation, oxygen consumption, self-heating and natural convection at the air breathing cathode. The model is validated against planar ABFC experimental measurements over a range of ambient temperatures. The model confirms the strong effect of self-heating on the water balance within passive ABFCs. Model analysis provides several conclusions: (1) thermal runaway caused by inadequate heat rejection predominantly limits ABFC performance. (2) The natural convection boundary layer represents a significant barrier to cathode mass and heat transfer. (3) Because the mass and heat transport numbers associated with natural convection are small, even slight forced convection dramatically affects cell behavior. (4) Performance optimization requires maximizing heat rejection while minimizing flooding. Decoupling the latter two phenomena is challenging due to the exponential relationship between water vapor saturation and temperature.     

Prophylactic Greenfield filters: acute complications and long-term follow-up

The efficacy of prophylactic vena caval filters (VCF) in reducing morbidity and mortality from pulmonary embolism (PE) in high-risk trauma patients has been shown, but minimal follow-up data is currently available. VCFs were prophylactically placed in 110 patients between August 1991 and June 1995. There was an early VCF complication rate of 7%. Twenty-two patients died; the remaining 88 patients formed the basis for the follow-up study. Forty-five patients were located and interviewed by phone, and 30 of these patients (34%) returned for evaluation. The mean follow-up time was 18 months (range, 4-42 months). There was no incidence of caval thrombosis on follow-up. Eleven patients had physical findings, and duplex evidence consistent with postphlebitic syndrome. An additional three patients had evidence of old deep venous thrombosis (DVT) by duplex, but no significant symptomatology. VCF are effective in preventing PE related deaths and have few major complications. The long-term morbidity associated with posttraumatic venous thrombosis is significant. This morbidity is related not to PE or VCF, but to the underlying DVT. Improved strategies against DVT are necessary.     

Connectivity Based k-Hop Clustering in Wireless Networks

In this paper we describe several new clustering algorithms for nodes in a mobile ad hoc network. The main contribution is to generalize the cluster definition and formation algorithm so that a cluster contains all nodes that are at distance at most k hops from the clusterhead. We also describe algorithms for modifying cluster structure in the presence of topological changes. We also proposed an unified framework for most existing and new clustering algorithm where a properly defined weight at each node is the only difference in otherwise the same algorithm. This paper studied node connectivity and node ID as two particular weights, for k=1 and k=2. Finally, we propose a framework for generating random unit graphs with obstacles.     

Some aspects of the biology of Dermestes maculatus Degeer (Coleoptera,Dermestidae) in dried fish

The development of Dermestes maculatus Deg. in dried fish has been studied under uncontrolled laboratory conditions. Females laid eggs within 12 hr of copulation, and oviposition was improved by the presence of free water. Hatching occurred about 48 hr after oviposition. The characteristic appearance of the egg and the changes that occurred during incubation and hatching are described. Larval development was completed in 33·5 days during which seven moults occurred and a body length of 14 mm was attained. Larval life was prolonged by crowding. When intact pieces of fish were available, the last instar larva bored into one of them and pupated within the hardened larval skin, but when ground fish was provided, a quiescent prepupal stage was observed. The adult emerged about 11 days after the last instar larval stage, irrespective of the mode of pupation.     

Conduction in thin polymer films

Thin polymer films have been made from a variety of starting monomers and their electrical conduction has been studied.The films are produced both by ultraviolet surface photolysis and by a cold-cathode glow-discharge technique. The samples are made in the form of a capacitor sandwich on a glass substrate with aluminium electrodes. The whole sample is made in a high-vacuum system, without breaking vacuum, using out-of-contact masking techniques.Generally, depending on the starting monomer, the polymer films are short-free down to a thickness of about 100 Å, and electric fields up to 10⁷ V/cm may be sustained.The current/voltage characteristics of the films have been investigated as a function of temperature and thickness. One theory to account for the conduction in these materials is presented and compared with other approaches to the problem.     

An analytical model for snapback in n-channel SOI MOSFET's

An analytical snapback model for n-channel silicon-on-insulator (SOI) transistors with body either tied to the source or floating is been presented. The snapback is modeled as a nonlinear feedback system leading to negative transconductances from which the jump in current can occur at the point of instability. The crux of this model is based on the strong dependence of the transistor threshold voltage on the body potential when the body potential is above the transistor surface potential at strong inversion. No parasitic bipolar action is invoked to account for the snapback phenomena. The model correctly predicts the occurrence of hysteresis/latch phenomena and the conditions under which the current jump occurs despite some gross approximations in the electric field and the injection level. Results obtained from this model show good agreement with experimental data measured from SIMOX devices fabricated on 0.3-μm epi film     

Fast multiplication in VLSI using wave pipelining techniques

Wave pipelining is a design methodology that can increase the clock frequency of digital systems. Also known asmaximum-rate pipelining, it has long been considered a technique for approaching the physical speed limit of a digital circuit. Unlike conventional pipelining, wave pipelining does not require internal clocked elements to increase throughput. The synchronization of internal computations is achieved by balancing inherent RC delays of combinational logic elements, thus allowing circuits to be pipelined at a very fine-grain level. In this article, we describe the design of a 16×16 wave-pipelined multiplier using a 1.0 μm CMOS process. The multiplier is designed using a conventional static CMOS technology. Simulation results show a speedup of about 7× over a nonpipeline implementation.     

Organic Phenolic Configurationally Locked Polyene Single Crystals for Electro‐optic and Terahertz Wave Applications

We investigate a configurationally locked polyene (CLP) crystal 2‐(3‐(4‐hydroxystyryl)‐5,5‐dimethylcyclohex‐2‐enylidene)malononitrile (OH1) containing a phenolic electron donor, which also acts as a hydrogen bond donor. The OH1 crystals with orthorhombic space group Pna2₁ (point group mm2) exhibit large second‐order nonlinear optical figures of merit, high thermal stability and very favorable crystal growth characteristics. Higher solubility in methanol and a larger temperature difference between the melting temperature and the decomposition temperature of OH1 compared to analogous CLP crystals, are of advantage for solution and melt crystal growth, respectively. Acentric bulk OH1 crystals of large sizes with side lengths of up to 1 cm with excellent optical quality have been successfully grown from methanol solution. The microscopic and macroscopic nonlinearities of the OH1 crystals are investigated theoretically and experimentally. The OH1 crystals exhibit a large macroscopic nonlinearity with four times larger powder second harmonic generation efficiency than that of analogous CLP crystals containing dimethylamino electron donor. A very high potential of OH1 crystals for broadband THz wave emitters in the full frequency range of 0.1–3 THz by optical rectification of 160 fs pulses has been demonstrated.     

Grout‐Verbindungen von Monopile‐Gründungsstrukturen – Trag‐ und Ermüdungsverhalten

Grouted Joint Connections of Monopile Support Structures – Structural and Fatigue Behaviour. This paper summarises the state of the art for grouted connections of support structures of Offshore Wind Energy Converters (OWECs). Results of numerical and experimental investigations of small and large scale tests of grouted joints which have been carried out within the research project “ForWind – TP V: Fatigue Assessment of Support Structures of Offshore Wind Energy Conversion Systems” at the Institute for Steel Construction, Leibniz Universität Hannover are presented. Furthermore the results of the numerical and experimental investigations are used for an exemplary calculation of a grouted joint connection of an OWEC located in the Baltic Sea. Besides the analysis of grouted joints with plain pipes the effects of an increased mechanical interlock due to shear keys on the fatigue design of grouted connections is demonstrated and fatigue classes for shear keys are presented.     

Bioinspired Design of Lysolytic Triterpenoid–Peptide Conjugates that Kill African Trypanosomes

Humans have evolved a natural immunity against Trypanosoma brucei infections, which is executed by two serum (lipo)protein complexes known as trypanolytic factors (TLF). The active TLF ingredient is the primate-specific apolipoprotein L1 (APOL1). The protein has a pore-forming activity that kills parasites by lysosomal and mitochondrial membrane fenestration. Of the many trypanosome subspecies, only two are able to counteract the activity of APOL1; this illustrates its evolutionarily optimized design and trypanocidal potency. Herein, we ask whether a synthetic (syn) TLF can be synthesized by using the design principles of the natural TLF complexes but with different chemical building blocks. We demonstrate the stepwise development of triterpenoid–peptide conjugates, in which the triterpenoids act as a cell-binding, uptake and lysosomal-transport modules and the synthetic peptide GALA acts as a pH-sensitive, pore-forming lysolytic toxin. As designed, the conjugate kills infective-stage African trypanosomes through lysosomal lysis thus demonstrating a proof-of-principle for the bioinspired, forward-design of a synTLF.