Experimental analysis of the influence of the voltage waveform on ozone generation efficiency

Although the dielectric barrier discharge (DBD) has been widely considered and studied for ozone generation, only a few studies have examined the influence of the alternating voltage waveform on the ozone rate production. This paper analyses the influence of the voltage shape on the ozone concentration and the energy efficiency of a DBD cylindrical ozone generator. Three voltage signals were studied using a high-voltage amplifier: sinusoidal, triangular and rectangular signals with voltage values up to 8 kV and frequencies up to 1.1 kHz. The obtained results showed that the efficiency of the ozone generator depends strongly on the type of the voltage waveform. The maximum values of the energy efficiency and the ozone concentration were obtained with the triangular voltage signal. This wave shape configuration has been successfully used for discolouration of water contaminated by textile dye.     

Performance analysis of opportunistic nonregenerative relaying

Opportunistic relaying in cooperative communication depends on careful relay selection. However, the traditional centralized method used for opportunistic amplify‐and‐forward protocols requires precise measurements of channel state information at the destination. In this paper, we adopt the max–min criterion as a relay selection framework for opportunistic amplify‐and‐forward cooperative communications, which was exhaustively used for the decode‐and‐forward protocol, and offer an accurate performance analysis based on exact statistics of the local signal‐to‐noise ratios of the best relay. Furthermore, we evaluate the asymptotical performance and deduce the diversity order of our proposed scheme. Finally, we validate our analysis by showing that performance simulation results coincide with our analytical results over Rayleigh fading channels, and we compare the max–min relay selection with their centralized channel state information‐based and partial relay selection counterparts. Copyright © 2013 John Wiley & Sons, Ltd.     

Performance analysis of an opportunistic multi‐user cognitive network with multiple primary users

Consider a multi‐user underlay cognitive network where multiple cognitive users concurrently share the spectrum with a primary network with multiple users. The channel between the secondary network is assumed to have independent but not identical Nakagami‐m fading. The interference channel between the secondary users (SUs) and the primary users is assumed to have Rayleigh fading. A power allocation based on the instantaneous channel state information is derived when a peak interference power constraint is imposed on the secondary network in addition to the limited peak transmit power of each SU. The uplink scenario is considered where a single SU is selected for transmission. This opportunistic selection depends on the transmission channel power gain and the interference channel power gain as well as the power allocation policy adopted at the users. Exact closed form expressions for the moment‐generating function, outage performance, symbol error rate performance, and the ergodic capacity are derived. Numerical results corroborate the derived analytical results. The performance is also studied in the asymptotic regimes, and the generalized diversity gain of this scheduling scheme is derived. It is shown that when the interference channel is deeply faded and the peak transmit power constraint is relaxed, the scheduling scheme achieves full diversity and that increasing the number of primary users does not impact the diversity order. Copyright © 2014 John Wiley & Sons, Ltd.     

Application of nanostructured titanium dioxide pigments in paper coating: a comparison between prepared and commercially available ones

Nano-TiO₂ pigments in pure crystallographic anatase and rutile phases have been successfully prepared by hydrothermal at 120°C and hydrolysis methods, respectively. The laboratory-prepared pigments were characterized parallel to two commercial pigments of the same crystal structure. All pigments were applied in paper coating mixtures, and their influence on coated paper properties was systematically investigated. X-ray diffraction investigation showed that the laboratory-prepared pigments using the hydrothermal method at 120°C were pure anatase, whereas hydrolysis method produced pure rutile phase pigment. The application of the prepared nanopigments and the corresponding commercial TiO₂ phases in paper coating revealed that clay/rutile nano-TiO₂ pigments in paper coating mixture decreased coated paper roughness more than blending clay with anatase nano-TiO₂ pigments. Commercial nano-TiO₂ pigments increased porosity of coated paper at both the 30% and 50% addition of nano-TiO₂ pigments to clay, while laboratory-prepared nano-TiO₂ pigments highly decreased it at 30% addition of nano-TiO₂ to clay, compared to clay only. Blending of clay/nano-TiO₂ pigments improved both brightness and opacity of the coated paper where commercial pigments are more effective. Burst, tensile strength, stretching, and TEA were improved in the case of all pigments. The 50% addition of the prepared and commercial nanopigments in conjunction with clay improved the mechanical coated paper properties more than 30% addition (except the cases of stretching and TEA of the commercial pigments). The coated paper samples were offset printed. It was found that blending of clay/nano-TiO₂ pigments improved print density. Commercial nano-TiO₂ pigments improved print gloss more than the laboratory-prepared ones. This result was found consistent with the results of coated paper roughness.     

Fatty acids,sterols, and tocopherols composition in seed oil extracts from four moroccan ecotypes of Ceratonia siliqua L.

Morphological characterization was investigated by agro-morphological criteria related to carob seed size in four different moroccan regions collected in 2018 and 2019. There was no significant difference (p ≤ 0.05) on the seeds lengths and widths. However, a significant difference between seeds thickness and total seeds weight per pod (p ≤ 0.05) were observed between these four populations. The fatty acid, sterol, tocopherol, hydrocarbon, and the unoxygenated composition of carob seed extracts (Ceratonia siliqua L.) were studied. The mean fat yield of the seeds obtained is 1.53%–2.17%, 2.14%–2.15%, 1.61%–1.62%, 1.71%–1.75% for, respectively, the P1 (Meknes), P2 (Fez), P3 (Khemisset), and P4 (Marrakech) in 2018 and 2019. The seed oil was extracted with hexane and the analysis of the fatty fraction was performed by gas chromatography–mass spectrometry (GC–MS). Results show that the major fatty acids for 2018 and 2019 are linoleic acid (61.48%–61.52%, 52.12%–52.14%, 57.76%–58.15%, 61.33%–61.52%), palmitic acid (15.78%–15.81%, 16.44%–16.45%, 19.11%–18.37%, 20.24%–20.32%), oleic acid (11.03%–11.04%, 8.72%–8.82%, 8.51%–8.61%, 8.41%–8.53%), stearic acid (4.35%–3.14%, 5.40%–5.43%, 3.12%–3.13%, 0.96%–1.56%), and cerotic acid (0.62%–0.53%, 4.51%–4.52%, 4.03%–4.06%, 3.84%–3.87%). The unsaturated fatty acids (69.39% in 2018 and 69.68% in 2019) are the most dominant in the four seed extracts compared to the saturated fatty acids. In addition, the oil carob seeds analysis revealed the presence of γ-tocopherol, α-tocopherol and four sterols that included campesterol, stigmasterol, and β-sitosterol. Moreover, the determination of hydrocarbon and un-oxygenated compounds confirmed the existence of major compounds such as heptadecane, 2-methyltriacontane, 1-iodo hexadecane and 1-iodo octadecane. The hierarchical analysis based on the morphological and chromatographic characterization of the seeds allowed the identification of three groups. Consequently, the first group consisted of populations from Marrakesh (P4) and Khemisset (P3), the second group consisted of the P1 from Meknes, and the P2 from Fez constituted the third group.     

Quartz Ore Beneficiation by Reverse Flotation for Silicon Production

Silicon - In this work the reverse flotation as beneficiation process for high-purity silica valorization from Draissa quartz deposits (Algeria) is studied as a potential raw material for...     

Characterization of rheological and thermophysical properties of HDPE–wood composite

The objective of this study is to develop a new biocomposite material with high deformation ability. In this regard, the thermal, rheological, and thermophysical properties of this new composite were characterized as a function of temperature and filler concentration. High density polyethylene (HDPE) was the matrix of this new composite which was reinforced with six sawdust concentrations 0%, 20%, 30%, 40%, 50%, and 60%. Maleic anhydride grafted polyethylene (PE‐g‐MA) was used as coupling agent. Addition of sawdust with PE‐g‐MA increased significantly the complex viscosity, the storage modulus (G′), and loss modulus (G″) of the matrix. The superposition of the complex viscosity curves using temperature dependent shift factor, allowed the construction of a viscosity master curve covering a wide range of temperatures. Arrhenius law was used for the relationship of the shift factor to temperature. Furthermore, method of Van Gurp and Palmen (tan delta vs. G*) is also used to control the time–temperature superposition. The experimental results can be well fitted with the cross rheological model which allowed the prediction of the thermorheological properties of the composites over a broad frequency range. By increasing wood concentration, both the activation energy and relaxation time for the biocomposites determined using, respectively, the Arrhenius law and the cole–cole rule increased. By contrast, specific heat of the matrix decreased with sawdust addition while its dimensional stability improved. © 2014 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2014 , 131, 40495.