Study on Hydrocracking of VGO Derived from Kazakhstan-Russian Mixed Crude

1 Introduction With the successful completion of the construction of the China-Kazakhstan oil pipeline the refinery at Dushanzi Pet- rochemical Company will process the Kazakhstan-Russian mixed crude at full steam starting 2007. The high sulfur, nitro- gen and heavy metals contents in the Kazakhstan-Russian mixed crude would have a serious impact on the secondary processing units of the Dushanzi refinery, in particular on the distillate hydrocracking unit, which mainly operates on vacuum g…     

声波测井换能器激发响应实验研究

声波测井换能器的激发响应由换能器振动时所表现出来的动态阻抗和激发电路参数决定。而换能器的动态（阻抗）参数随压电晶体及其装配方式（力学边界条件）改变。为了测量换能器动态参数的影响，采用声波测井仪器常用的压电晶体和升压变压器，通过改变激发脉冲宽度和直流电压进行了实验，结果发现：在换能器两端的瞬态响应中，一共有三个二阶网络响应，分别对应于不同的频率。最低的一个影响声波测井波形的基线、与换能器主频接近的一个决定激发效率以及电路与压电晶体之间的匹配关系，是激发电路设计中比较关键的，其参数可以通过导纳圆测量仪器得到。     

新设备技术在催化裂化装置上的应用

文章介绍了近年来在催化裂化装置上应用的新设备、新技术,如BY型旋风分离器、BSX型旋分式三级旋风分离器、上下拱型三级旋风分离器、下拱型三级旋风分离器、SHS“自蔓延”技术、SWY外取热器、BWJ型喷嘴、自流浇注料、Actehem高耐磨衬里、弓形钢丝纤维、侧拉环锚固钉、分体可拆人孔等的结构特点及实际应用情况。     

新会计准则对会计准则质量的影响

年初,国家财政部发布了新的会计准则,这是中国会计准则建设史上的重大事件。新会计准则体现出会计准则质量的几个重要标准,提高了中国会计准则的质量。同时,分析新会计准则质量方面仍存在的一些不足。     

循环流化床固-固换热系统传热规律

在自制的循环流化床固-固换热设备中,以催化裂化平衡催化剂[平均粒径60μm,堆密度980 kg/m3,比热1.01 kJ/(kg.K),临界流化速度0.002 1 m/s]为原料,对系统的循环特性及传热规律进行了研究,考察了床层密度、提升风量、床层温度、催化剂粒径等因素对传热的影响。结果表明,随着提升风量增加,表观气速增大,床层密度下降,传热系数下降;提高床层温度,减小催化剂的粒径,传热系数增加。     

应用API 581对输气站场进行定量风险评价

目前专门针对输气站场的风险评价方法还不多，现有的手段也只是根据国家法律法规得出定性的评价结果，然后按照评价结果对照得出整改方案。为此，对输气站场的定量风险评价工作提出了一套新方法，得到了定量的和更加客观的风险排序，为管道站场的完整性管理工作提供了有力的支持；并以陕京输气管道榆林压气站为例，应用美国石油学会标准API 581（基于风险检测的基本源文件）对站内设施进行了风险评价，计算了站内设备和管线的失效后果、失效概率，得到了定量风险值，进而分析了风险值产生差异的原因。最后，针对我国输气管道风险评估工作提出了看法和建议。     

TUD-DNS3脱硝助剂在催化裂化装置的工业应用

TUD-DNS3脱硝助剂在中韩（武汉）石油化工有限公司1号催化裂化装置上进行了工业应用。结果表明：针对两段再生工艺，当系统中助剂占总催化剂藏量的质量分数为2.6%时，烟气脱硫装置外排污水中的氨氮质量浓度由加剂前的100 mg/L下降至40 mg/L以内；助剂的加入降低了CO焚烧炉的炉膛温度，有利于烟气的合格排放，并对装置操作、产品分布及汽油、柴油产品质量无不良影响。     

On the Feasibility of Growing Pb[(Zn1/3Nb2/3)0.91Ti0.09]O3 Single Crystals

Pb[(Zn_1/3Nb_2/3)_0.91Ti_0.09]O₃ (PZNT91/9) single crystals were grown by two methods: from solution using PbO as a self‐fluxing agent (SC method) and directly from the melt without fluxing (MC method). In both growth methods, an allomeric Pb[(Mg_1/3‐Nb_2/3)_0.69Ti_0.31]O₃ (PMNT69/31) single crystal was used as a seed. X‐ray diffraction patterns of ground crystals showed that phase‐pure perovskite PZNT91/9 single crystals were successfully fabricated by the above two methods. The composition of the crystals obtained by both the SC and MC methods was analyzed using X‐ray fluorescence, which confirmed that the crystal composition is close to the nominal value, although volatilization of PbO and segregation during crystal growth are inevitable. The MC PZNT91/9 crystals exhibit excellent piezoelectric properties, with the piezoelectric constant, d₃₃, in the range of 1800–2200 pC N^–1. This value is comparable to that of the SC crystals. However, the MC crystals show an abnormal dielectric behavior. In contrast with the SC crystals, in the MC crystals a much broader dielectric peak appears in the dielectric response curves, accompanied by a much lower peak temperature of around 105 °C. Furthermore, frequency dispersion is apparent over a much wider temperature range (even more apparent than in pure relaxors), where a large, i.e., about 70 °C, full width at half maximum (FWHM) for the dielectric peaks is observed in the dielectric response. It is speculated that such an unusual phenomenon correlates with defects, microinhomogeneities, and polar regions in the as‐grown MC crystals. The origins of this abnormality have not been interpreted in detail until now. However, optical observation of the domain structure confirms that both the SC and MC crystals possess complex structural states.     

连续波半主动雷达制导空空导弹截获跟踪距离计算

分析了连续波半主动雷达制导导弹导引头工作电磁环境和对武器系统攻击区的影响，建立了热噪声和杂波干扰环境下导引头截获距离方程，分析推导了直波泄漏干扰，地杂波干扰的计算公式，并在此基础上给出了导弹允许攻击区计算公式。     

Thermo-Sensitive Ba0.64Sr0.36TiO3 Thin Film Capacitors for Dielectric Type Uncooled Infrared Sensors

Ba_0.64Sr_0.36TiO₃ (BST) thin films are prepared on Pt/Ti/SiO₂/Si₃N₄/SiO₂/Si substrates by a sol-gel method. Thermo-sensitive BST thin film capacitors with a Metal-Ferroelectrics-Metal (M-F(BST)-M) structure are fabricated as the active elements of dielectric type uncooled infrared sensors. XRD are employed to analyze the crystallographic structures of the films. AFM observations reveal a smooth and dense surface of the films with an average grain size of about 35 nm. Rapid temperature annealing (RTA) process is a very efficient way to improve crystallization quality. The preferable annealing temperature is 800°C for 1 min. The butterfly shaped C-V curves of the capacitors indicate the films have a ferroelectric nature. The dielectric constant and dielectric loss of the films at 100 kHz are 450 and 0.038, respectively. At 25°C, where the thermo-sensitive capacitors work, the temperature coefficient of dielectric constant (TCD) is about 5.9 %/°C. These results indicate that the capacitors with sol-gel derived BST thin films are promising to develop dielectric type uncooled infrared sensors.