Single Nanoparticle Magnetic Spin Memristor

There is an increasing demand for the development of a simple Si‐based universal memory device at the nanoscale that operates at high frequencies. Spin‐electronics (spintronics) can, in principle, increase the efficiency of devices and allow them to operate at high frequencies. A primary challenge for reducing the dimensions of spintronic devices is the requirement for high spin currents. To overcome this problem, a new approach is presented that uses helical chiral molecules exhibiting spin‐selective electron transport, which is called the chiral‐induced spin selectivity (CISS) effect. Using the CISS effect, the active memory device is miniaturized for the first time from the micrometer scale to 30 nm in size, and this device presents memristor‐like nonlinear logic operation at low voltages under ambient conditions and room temperature. A single nanoparticle, along with Au contacts and chiral molecules, is sufficient to function as a memory device. A single ferromagnetic nanoplatelet is used as a fixed hard magnet combined with Au contacts in which the gold contacts act as soft magnets due to the adsorbed chiral molecules.     

Colloidal Quantum Dot Infrared Lasers Featuring Sub-Single-Exciton Threshold and Very High Gain

The use of colloidal quantum dots (CQDs) as a gain medium in infrared laser devices has been underpinned by the need for high pumping intensities, very short gain lifetimes, and low gain coefficients. Here, PbS/PbSSe core/alloyed-shell CQDs are employed as an infrared gain medium that results in highly suppressed Auger recombination with a lifetime of 485 ps, lowering the amplified spontaneous emission (ASE) threshold down to 300 µJ cm⁻², and showing a record high net modal gain coefficient of 2180 cm⁻¹. By doping these engineered core/shell CQDs up to nearly filling the first excited state, a significant reduction of optical gain threshold is demonstrated, measured by transient absorption, to an average-exciton population-per-dot 〈N^th〉_g of 0.45 due to bleaching of the ground state absorption. This in turn have led to a fivefold reduction in ASE threshold at 〈N^th〉_ASE = 0.70 excitons-per-dot, associated with a gain lifetime of 280 ps. Finally, these heterostructured QDs are used to achieve near-infrared lasing at 1670 nm at a pump fluences corresponding to sub-single-exciton-per-dot threshold (〈N^th〉_Las = 0.87). This work brings infrared CQD lasing thresholds on par to their visible counterparts, and paves the way toward solution-processed infrared laser diodes.     

Inferring global pereeptual contours from local features

We address the problem of contour inference from partial data, as obtained from state-of-the-art edge detectors.We argue that in order to obtain more pereeptually salient contours, it is necessary to impose generic constraints such as continuity and co-curvilinearity.The implementation is in the form of a convolution with a mask which encodes both the orientation and the strength of the possible continuations. We first show how the mask, called the Extension field is derived, then how the contributions from different sites are collected to produce a saliency map.We show that the scheme can handle a variety of input data, from dot patterns to oriented edgels in a unified manner, and demonstrate results on a variety of input stimuli.We also present a similar approach to the problem of inferring contours formed by end points. In both cases, the scheme is non-linear, non iterative, and unified in the sense that all types of input tokens are handled in the same manner.This research was supported by the Advanced Research Projects Agency of the Department of Defense and was monitored by the Air Force Office of Scientific Research under Contract No. F49620-90-C-0078, and by a NSF Grant under award No. IRI-9024369. The United States Government is authorized to reproduce and distribute reprints for governmental purposes notwithstanding any copyright notation hereon.     

Reducing control selection errors associated with underground bolting equipment

Selecting the incorrect control during the operation of underground bolting and drilling equipment causes serious injuries. Shape coding and the layout of dual control banks are two aspects of control design which require further examination. The aims of this research were: (i) to determine whether arbitrary shape coding was effective in reducing selection error rates in a virtual analogy of roof-bolting; and (ii) to determine whether any advantages exist for mirror or place layouts for dual control situations in this situation. Two experiments were conducted to address these questions. No benefits of arbitrary shape coding were evident while control location remained constant. When control location was altered, shape coding did provide a significant reduction in selection error rate. No differences between mirror or place arrangements were detected and this question remains open.     

Simulation of rotating stall in a whole stage of an axial compressor

Aerodynamic instabilities that naturally occur in compression systems, such as surge and rotating stall, largely reduce the life duration and performance of system components. The prediction of the compressor operating range is thus a key parameter for the design of gas turbines. This paper investigates the ability of an unsteady flow solver to simulate the rotating stall phenomenon in the full annulus of an axial compressor stage. A comparison with experimental data indicates that the simulation correctly estimates the stability limit. However the rotating stall flow patterns are different. While measurements show only one full span rotating stall cell (40 Hz), the simulation shows first a part span stall with 10 cells (790 Hz) that evolves then towards a full span stall with three cells (170 Hz). A spectral analysis based on numerical results underlines the role of rotor-stator interactions in the development of rotating stall. The effects of downstream volumes and inlet distortions are also discussed, showing the necessity to consider the whole geometry to correctly predict the rotating stall frequency.     

Evolving trees for the retrieval of mass spectrometry-based bacteria fingerprints

In this paper, we investigate the application of Evolving Trees (ET) for the analysis of mass spectrometric data of bacteria. Evolving Trees are extensions of self-organizing maps (SOMs) developed for hierarchical classification systems. Therefore, they are well suited for taxonomic problems such as the identification of bacteria. Here, we focus on three topics, an appropriate pre-processing and encoding of the spectra, an adequate data model by means of a hierarchical Evolving Tree and an interpretable visualization. First, the high dimensionality of the data is reduced by a compact representation. Here, we employ sparse coding, specifically tailored for the processing of mass spectra. In the second step, the topographic information which is expected in the fingerprints is used for advanced tree evaluation and analysis. We adapted the original topographic product for SOMs for ET to achieve a judgment of topography. Additionally we transferred the concept of U-matrix for evaluation of the separability of SOMs to their analog in ET. We demonstrate these extensions for two mass spectrometric data sets of bacteria fingerprints and show their classification and evaluation capabilities in comparison to state of the art techniques.     

Exploring sociality and engagement in play through game-control distribution

This study explores how distributing the controls of a video game among multiple players affects the sociality and engagement experienced in game play. A video game was developed in which the distribution of game controls among the players could be varied, thereby affecting the abilities of the individual players to control the game. An experiment was set up in which eight groups of three players were asked to play the video game while the distribution of the game controls was increased in three steps. After each playing session, the players’ experiences of sociality and engagement were assessed using questionnaires. The results showed that distributing game control among the players increased the level of experienced sociality and reduced the level of experienced control. The game in which the controls were partly distributed led to the highest levels of experienced engagement, because the game allowed social play while still giving the players a sense of autonomy. The implications for interaction design are discussed.     

Transmission power and data rate aware routing on wireless networks

Wireless networks can vary both the transmission power and modulation of links. Existing routing protocols do not take transmission power control (TPC) and modulation adaptation (also known as rate adaptation – RA) into account at the same time, even though the performance of wireless networks can be significantly improved when routing algorithms use link characteristics to build their routes. This article proposes and evaluates extensions to routing protocols to cope with TPC and RA. The enhancements can be applied to any link state or distance vector routing protocols. An evaluation considering node density, node mobility and link error show that TPC- and RA-aware routing algorithms improve the average latency and the end-to-end throughput, while consuming less energy than traditional protocols.