Identification of the adverse effect of nitrate on the phosphate release rate and improvement of EBPR process models.

The adverse effect of nitrate on the phosphate release rate in the anaerobic phase was observed and was hardly explainable with conventional EBPR process models. Four possible mechanisms were proposed including substrate competition, reduced fermentation, parallel reaction and sequential reaction. Batch experiments were designed and conducted to identify the dominant mechanism. Results showed that the sequential reaction was the only possible mechanism where only denitrification occurred if any nitrate existed in the anaerobic phase. Then the phosphate release following after the nitrate was completely removed. Nitrate inhibition effect was added into the PHA storage rate to incorporate the sequential reaction in the conventional ASM3 plus EAWAG bio-P module (ASM3 + P). Nitrate inhibition coefficient, K(I,NO,PAO) was found to be as low as 0.05 mg/L. This correlated well with experimental observation where no also meant that the anaerobic compartment of a continuous flow reactor could be seriously affected by the residual nitrate contained in the sludge recycle flow. This phenomenon caused overestimation of the phosphate uptake rate and consequently underestimation of PO4(3-) -P concentration. This problem was resolved by incorporation of a nitrate inhibition term in the ASM3 + P for more accurate simulation of the EBPR process.     

Multiple Scan Chain Design for Two-Pattern Testing

Non-standard fault models often require the application of two-pattern testing. A fully-automated approach for generating a multiple scan chain-based architecture is presented so that two-pattern test sets generated for the combinational core can be applied to the sequential circuit. Test time and area overhead constraints are considered.     

A Least Squares Approach to Escalator Algorithms for Adaptive Filtering

In this paper, we introduce an escalator (ESC) algorithm based on the least squares (LS) criterion. The proposed algorithm is relatively insensitive to the eigenvalue spread ratio (ESR) of an input signal and has a faster convergence speed than the conventional ESC algorithms. This algorithm exploits the fast adaptation ability of least squares methods and the orthogonalization property of the ESC structure. From the simulation results, the proposed algorithm shows superior convergence performance.     

Effects of surface charge, micro-bubble size and particle size on removal efficiency of electro-flotation.

Flotation is a water treatment alternative to sedimentation, and uses small bubbles to remove low-density particles from potable water and wastewater. The effect of zeta potential, bubble size and particle size on removal efficiency of the electro-flotation process was investigated because previous model-simulations indicated that these attributes are critical for high collision efficiency between micro-bubbles and particles. Solutions containing Al3+ as the metal ion were subjected to various conditions. The zeta potentials of bubbles and particles were similar under identical conditions, and their charges were influenced by metal ion concentration and pH. Maximum removal efficiency was 98 and 12% in the presence and absence of flocculation, respectively. Removal efficiency was higher when particle size was similar to bubble size. These results agree with modelling simulations and indicate that collision efficiency is greater when the zeta potential of one is negative and that of the other is positive and when their sizes are similar.     

Optimal Block Design for Asynchronous Wake-Up Schedules and Its Applications in Multihop Wireless Networks

In this paper, we consider the problem of designing optimal asynchronous wake-up schedules to facilitate distributed power management and neighbor discovery in multihop wireless networks. We first formulate it as a block design problem and derive the fundamental trade-offs between wake-up latency and the average duty cycle of a node. After the theoretical foundation is laid, we then devise a neighbor discovery and schedule bookkeeping protocol that can operate on the optimal wake-up schedule derived. To demonstrate the usefulness of asynchronous wake-up, we investigate the efficiency of neighbor discovery and the application of on-demand power management, which overlays a desirable communication schedule over the wake-up schedule mandated by the asynchronous wake-up mechanism. Simulation studies demonstrate that the proposed asynchronous wake-up protocol has short discovery time which scales with the density of the network; it can accommodate various traffic characteristics and loads to achieve an energy savings that can be as high as 70 percent, while the packet delivery ratio is comparable to that without power management.     

Synthesis of amphiphilic magnetic microspheres by dispersion copolymerization of styrene and poly(ethylene oxide) macromonomer

Amphiphilic magnetic microspheres ranging in diameter from 5 to 100 µm were prepared by dispersion copolymerization of styrene and poly(ethylene oxide) vinylbenzyl (PEO‐VB) macromonomer (MPEO) in the presence of Fe₃O₄ magnetic fluid. The effects of various polymerization parameters on the average particle size were systematically investigated. The average particle size was found to increase with increasing styrene concentration and initiator concentration. It also increased with decreasing stabilizer concentration and molecular weight of MPEO. The content of the hydroxyl groups localized in the microspheres ranged from 0.01 to 0.2 mmol g^?1. © 2003 Society of Chemical Industry     

结构优化分子筛的制备及其催化裂化性能Ⅱ.结构优化分子筛的催化裂化性能

利用结构优化改性前后的分子筛作为活性组元制备出一系列催化剂,并通过重油微反及ACE-Model R+固定流化床评价其催化裂化性能,并进行了比较.结果表明,采用气相超稳制备的分子筛再经稀土离子优化改性后,用其制成的催化剂的催化裂化反应的转化率显著提高,重油裂化能力明显增强,汽油中烯烃的含量大幅度降低.     

Study on Laboratory Method for Refining of SR Diesel Fuel

The method for refining the straight-run diesel fuel was studied in laboratory scale in order to make the acid number of diesel fraction comply with the standard while removing the naphthenic acids contained in diesel without causing environmental pollution. After comparing the effect of refining using three solvents, the isopropyl alcohol-HOA was specified as the best solvent. Meanwhile, the relationship between the acid number of diesel fraction and the amount of solvent used and the relationship between the concentration of solvent and temperature and the stability of diesel in terms of its acid number were also investigated. Experimental results had shown that when the mass fraction of the HOA-IPA solvent was 20% at a dosage of 17 mL of the solvent and a temperature of 30℃, the acid number of the refined diesel fraction was 0.015 mg KOH/g with a good stability of acidity in the diesel fraction,     

MIMO技术在超宽带通信中的应用

多带UWB通信技术是目前超宽带通信技术中较为热的研究领域,本文引入了一种基于干扰抑制OFDM系统的UWB系统[4],在此基础至上和MIMO技术结合起来,引入一种实际可行的自适应调制算法,算法通过建立各子信道的能量增量表,来实现信息比特和功率的最优分配[1].通过仿真试验可以发现,这种MIMO系统的结合可以改善系统的BER.     

An MPEG‐4 Compliant Interactive Multimedia Streaming Platform Using Overlay Networks

This paper presents a multimedia streaming platform for efficiently transmitting MPEG‐4 content over IP networks. The platform includes an MPEG‐4 compliant streaming server and client, supporting object‐based representation of multimedia scenes, interactivity, and advanced encoding profiles defined by the ISO standard. For scalability purposes, we employ an application‐layer multicast scheme for media transmission using overlay networks. The overlay network, governed by the central entity of the network distribution manager, is dynamically deployed according to a set of pre‐defined criteria. The overlay network supports both broadcast delivery and video‐on‐demand content. The multimedia streaming platform is standards‐compliant and utilizes widespread multimedia protocols such as MPEG‐4, real‐time transport protocol, real‐time transport control protocol, and real‐time streaming protocol. The design of the overlay network was architected with the goal of transparency to both the streaming server and the client. As a result, many commercial implementations that use industry‐standard protocols can be plugged into the architecture relatively painlessly and can enjoy the benefits of the platform.