Vertical pneumatic conveying: An experimental study with particles in the intermediate and turbulent flow regimes

Vertical pneumatic conveying was studied in a 3-inch diameter riser 30 feet in length using solids ranging in particle Reynolds number from 100 to 3500. Particle to gas mass flow ratios varied from 0 to 8 and pipeline conditions extended from dilute flow down into the choking region. Average particle hold-up was determined by means of a series of quick-closing valves and particle slip velocity was often found to be greater than the calculated terminal velocity. The reasons for this are examined. Frictional pressure losses in the riser were also determined and compared with literature data. The phenomenon of choking is considered briefly.     

Preparation of zinc ferrite in the presence of carbon material and its application to hot-gas cleaning

In order to develop an efficient absorbent of H₂S in coal gasification, zinc ferrite (ZnFe₂O₄) was prepared in the presence of carbon materials such as activated carbon (AC), activated carbon fiber (ACF), and Yallourn coal (YL). The absorption behavior of absorbents for H₂S was examined using a fixed-bed flow type reactor equipped with a quadrupole mass spectrometer.Carbon material-supported ZnFe₂O₄ exhibited larger desulfurization capacity for H₂S than unsupported ferrites. They could efficiently remove H₂S from 4000 ppm levels in a simulated coal gasification gas to less than 1 ppm at 500 °C. The absorption capacity of H₂S with ZnFe₂O₄/AC, ZnFe₂O₄/ACF, and ZnFe₂O₄/YL exhibited nearly 100% of stoichiometric amount of loaded metal species. They could be regenerated by an air oxidation in O₂-Ar (50 vol%) at 450 °C for 30 min. The regenerated ferrite can be used for repeated absorption of H₂S with a very slight decrease in the absorption capacity.     

Efficient usage of highly dispersed Pt on carbon nanotubes for electrode catalysts of polymer electrolyte fuel cells

A Pt-deposited carbon nanotube (CNT) shows higher performance than a commercial Pt-deposited carbon black (CB) with reducing 60% Pt load per electrode area in polymer electrolyte fuel cells (PEFCs) below 500 mA/cm². K₂PtCl₄ and H₂PtCl₆·6(H₂O) are used for the Pt deposition onto multi-walled CNTs (MWCNTs), which are produced by the catalytic decomposition of hydrocarbons. The electric power densities produced using the Pt/CNT electrodes are greater than that of the Pt/CB by a factor of two to four on the basis of the Pt load per power. CNTs are thus found to be a good support of Pt particles for PEFC electrodes. TEM images show 2–4-nm Pt nanoparticles dispersed on the CNT surfaces. These high performances are considered to be due to the efficient formation of the triple-phase boundaries of gas–electrode–electrolyte. The mechanisms of Pt deposition are discussed for these Pt-deposited CNTs.     

High-Resolution Electron Microscopy Observations of Stacking Faults in β-SiC

Structural images of the stacking faults in β-SiC were obtained with a high-resolution electron microscope. Stacking faults initially present in β-SiC powder particles were eliminated as grain growth proceeded at elevated temperatures.     

Effects of 6-anilino-1,3,5-triazine-2,4-dithiol,zinc stearate,and barium stearate on the thermal stabilization of PVC

Individual action and synergistic effect in the combination of 6-anilino-1,3,5-triazine-2,4-dithiol (AF), zinc stearate, and barium stearate on the color stabilization of PVC were investigated. In this system, AF selectively reacts with allylic chlorine atoms in PVC. Consequently, unstable allylic chlorine units were converted to thermally stable allylic structures, thus retarding the development of polyene sequences. Zinc stearate accelerated the reaction of AF with allylic chlorine atoms in PVC, forming the zinc salts of AF (AFZ_nSt, St?C₁–H₃₅COO? ) by reacting with AF. Barium stearate reacted with ZnCl₂ which is formed in the above reaction to give St₂Zn and BaCl₂. Consequently, barium stearate led to the selective reaction of AF with allylic chlorine atoms in PVC and the remarkable retarding effect of discoloration of PVC.     

Formation and Properties of Ln-Si-O-N Glasses (Ln = Lanthanides or Y)

Homogeneous Y-Si-O-N glasses containing 15 or 20 eq% nitrogen (N) were prepared from compositions with Y/Si ratios in the vicinity of that of the lowest eutectic point on the Y₂O₃–SiO₂ phase diagram. The liquidus on the phase diagram shifted toward lower temperatures by incorporation of N. The density, the elastic moduli, and the glass transition temperature of the Y-Si-O-N glasses increased with incorporation of N. This is due to the closer packing of atoms in the glasses by the substitution of N, which is in three-fold coordination with Si, for O which is in two-fold coordination, and the stronger covalent nature of the Si–N bond compared with the Si–O bond. The coefficient of thermal expansion of the Y-Si-O-N glasses increased with increasing Y content, because the discontinuity of the glass network developed with increasing nonbridging anions by the introduction of Y. In contrast, the glass transition temperature and the elastic moduli increased with Y content due to the high coordination of Y for O, and the relatively high cationic field strength of Y. Furthermore, the effect of cationic field strength on properties of Ln-Si-O-N glasses (Ln = lanthanides or Y) is discussed.     

Antitumor activity of synthetic alkylphospholipids with or without PAF activity

1-O-Octadecyl-2-O-methyl-sn-glycero-3-phosphocholine (ET-18-OMe) has been reported to possess definite antitumor activity in vivo. Twenty-two alkyl lysophospholipid analogs were chemically synthesized, and their antitumor activity against mouse experimental tumors (Sarcoma 180, MM46, P388) was examined. Among them, 1-O-octadecyl-2-O-acetoacetyl-rac-glycerol-3-phosphocholine was found to show antitumor activity similar to ET-18-OMe with less acute toxicity. Intravenous injection of the ET-18-OMe withsn-3 configuration retarded the subcutaneous growth of Sarcoma 180 cells effectively, while the growth inhibition by thesn-1 isomer was much less effective. This stereospecificity was similar to that observed in their activities as platelet-activating factor (PAF) agonists. The acetoacetyl compound, another PAF agonist, showed similar stereospecific antitumor action in vivo. These findings suggest that some alkyl lysophospholipids may activate host cells to a cytostatic stage against tumor cells in vivo through binding to a PAF receptor. Our preliminary results indicated that the responsible cells under these conditions might be primarily immature macrophages present in the bone marrow. No appreciable or even adverse stereospecificity was observed in the different sets of experiments where the activity of ET-18-OMe against MM46 tumor cells in vivo or the direct cytotoxicity against human promyelocytic leukemia HL-60 cells in vitro was examined. Under, some conditions, the antitumor activity of ET-18-OMe in vivo may be revealed through direct cytotoxicity and/or modulation of the host defense system by “nonspecific” mechanisms. Some alkylphospholipids without PAF activity may also show antitumor activity through similar, “nonspecific” mechanisms.     

Upper critical solution temperature lubricants for CPVC

Chlorinated polyvinyl chloride (CPVC) is often used in injection molding for products that demand high heat resistance. However, proper control of its flow properties is difficult. To improve flow behavior some internal lubricants are usually used, but they reduce heat resistance of the products. Upper critical solution temperature (UCST) lubricants were found to enhance its flow properties, and also high heat resistance was retained. They act as internal lubricants during processing, improving flow and phase separation during cooling. Therefore they are present essentially as inert filler and thus have little effect on heat distortion temperature.     

Stabilization of β-Bi2O3 by Sb2O3 Doping

The metastable β form of bismuth sesquioxide was obtained by doping antimony oxide. The solubility of antimony was 4 to 10 at. %in β specimens, where more than 75% of the antimony atoms were valenced at 5+.