水性氯化物介质中对甲基苯烷基硫醚萃取钯的研究

p-Methylphenylalkylsulfide of various alkyl chain length as extractant were synthesized and the extraction of palladium was examined in terms of equilibrium and kinetics. Distribution ratio of Pd was independent of alkyl chain length. For aqueous chloride media, there was a significant difference in distribution ratios for the solution of NaC1 and HC1. The results of loading test and the slope analysis suggest that the extractant and Pd (Ⅱ) form 2:1 complex. Furthermore, the extraction rate based on the volume of aqueous phase was obtained in a stirred vessel, and the rate equation was presented. Unfortunately, it was difficult to construct surfactant liquid membrane system by use of the present extractant.     

Reactive blending of polyamide with polyethylene: pull-out of in situ-formed graft copolymers and its application for high-temperature materials

Reactive blending of polyamide 6 (PA) with polyethylene (PE) having reactive sites, maleic anhydride (MAH content=0.1 wt%),and glycidyl methacrylate (GMA content=3-12 wt%), was carried out at 70/30 and 65/35 (PA/PE) blend ratios. Blend morphology evolved by reactive blending was analyzed by light scattering and transmission electron microscopy. The blends were then irradiated by electron beam. The degree of crosslinking was estimated by measuring the dynamic storage modulus at a temperature above melting point of PA. It was found that surface-to-surface interparticle distance τ was significantly reduced by the micelle formation via pull-out of in situ-formed graft copolymers. The blend with shorter τ was crosslinked by electron-beam irradiation at the lower dose level. A blend having the minimum τ (∼0.2 μm) was nicely crosslinked at a low dose level same as for PE, and even for the PA matrix system.     

Studies on the biaxial stretching of polypropylene film. XI. Type II orientation during [2-2FI]-type stretching and its change by subsequent thermal contraction

In order to study the deformation mechanism of type II stretching, the change in orientation during the restretching and subsequent thermal contraction was investigated by x-ray diffraction method. When a uniaxially oriented film is restretched, the lamellae which are stacked in the stretching direction by the stretching rotate as a whole toward the restretching axis. They rotate backward nearly reversibly during the thermal contraction, unless the restretching exceeds a balancing state, where the orientation in the film plane are equal in all directions. However, when the restretching degree is so high and the film orientation exceeds the balancing state, the lamellar rotation is accompanied by a complex phenomenon. It is considered from the wide-angle and small-angle x-ray diffraction patterns that the lamellar surface becomes indented because of slippage between microfibrils composing the lamellae, and the microfibrils themselves bend at the boundary between the amorphous and crystalline regions within which the tilting of c-axis also occurs. Upon contracting of the film; these changes recover, but even in the last stage of contraction the orientation approaches the symmetrical biaxial orientation but not the uniaxial orientation from which the biaxial orientation is started. These orientation and disorientation behaviors are not affected basically by a slight change in the restretching temperature and the degree of stretching.     

Effective renaturation of reduced lysozyme by gentle removal of urea

To increase the folding yield of concentrated reduced lysozyme,we developed a renaturation method by means of dialysis fromconcentrated urea with redox agents. After lysozyme was incubatedin the reducing buffer (8 M urea solution) with oxidized glutathione,renaturation of reduced lysozyme was started by dialysis againstthe dialyzing buffer containing 8 M urea with redox agents.The urea concentration of the dialyzing bottle was graduallydiluted with dialyzing buffer without urea at a flow rate of0.1 ml/min by high pressure pump. Using this systematic dialysis,a concentration as high as 5 mg/ml of reduced lysozyme couldbe renaturated in 80% yield, while the folding yield was <5%even at a concentration of 1 mg/ml using a conventional rapiddilution method [Goldberg et al. (1991) Biochemistry, 30, 2790–2797].Therefore, it was concluded that gentle removal of urea fromdenatured proteins, dissolved in concentrated urea solution,by means of dialysis should be useful to renature denaturedproteins effectively.     

An Advanced Oscillation Mixing Method for Improving the Cooling Uniformity in Quenching

In quenching, the cooling uniformity is most important to diminish distortion occurring on work pieces. As a trial to accomplish uniform cooling, therefore, there exist various mixing methods of a quenchant and the quenchant circulation with an external pump has so far been the well accepted mixing method. However, this study proposes an advanced oscillation mixing method that can improve more the cooling uniformity in quenching. The proposed method includes a stirrer in oscillating motion, so that the simultaneous oscillating and mixing movements of the stirrer are considered to provide efecfively the uniform cooling characteristics for the quenchant. In comparison with the case of the circulation pump mixing, the investigation using the oscillation mixing method has demonstrated the following two experimental facts:(1) the short vapor blanket stage caused by the quick breakage of the oil vapor blanket and (2) the reduced variation of the quenching distortion.     

What kind of floor am I standing on? Floor surface identification by a small humanoid robot through full-body motions

This study addresses a floor identification method for small humanoid robots that work in such daily environments as homes. The fundamental difficulty lays in a method to understand the physical properties of floors. To achieve floor identification with small humanoid robots, we used inertial sensors that can be easily installed on such robots, and dynamically selected a full-body motion that physically senses floors to achieve accurate floor identification. We collected a training data-set over 10 different kinds of common floors in home environments. We achieved 85.7% precision with our proposed method. We also demonstrate that our robot could appropriately change its locomotion behaviours depending on the floor identification results.     

Construction of living cellular automata using the Physarum plasmodium

The plasmodium of Physarum polycephalum is a unicellular and multinuclear giant amoeba that has an amorphous cell body. To clearly observe how the plasmodium makes decisions in its motile and exploratory behaviours, we developed a new experimental system to pseudo-discretize the motility of the organism. In our experimental space that has agar surfaces arranged in a two-dimensional lattice, the continuous and omnidirectional movement of the plasmodium was limited to the stepwise one, and the direction of the locomotion was also limited to four neighbours. In such an experimental system, a cellular automata-like system was constructed using the living cell. We further analysed the exploratory behaviours of the plasmodium by duplicating the experimental results in the simulation models of cellular automata. As a result, it was revealed that the behaviours of the plasmodium are not reproduced by only local state transition rules; and for the reproduction, a kind of historical rule setting is needed.     

Development of flexible displays using back‐channel‐etched In–Sn–Zn–O thin‐film transistors and air‐stable inverted organic light‐emitting diodes

We developed flexible displays using back‐channel‐etched In–Sn–Zn–O (ITZO) thin‐film transistors (TFTs) and air‐stable inverted organic light‐emitting diodes (iOLEDs). The TFTs fabricated on a polyimide film exhibited high mobility (32.9 cm²/Vs) and stability by utilization of a solution‐processed organic passivation layer. ITZO was also used as an electron injection layer (EIL) in the iOLEDs instead of conventional air‐sensitive materials. The iOLED with ITZO as an EIL exhibited higher efficiency and a lower driving voltage than that of conventional iOLEDs. Our approach of the simultaneous formation of ITZO film as both of a channel layer in TFTs and of an EIL in iOLEDs offers simple fabrication process.     

Finding division points for a time series corpus based on structural change point detection

This paper describes a method of finding the proper points for dividing a corpus with time series information to extract local and frequent keywords. Previous works have proposed the corpus separating method for extracting keywords from a corpus. However, this method divides a corpus at equal intervals so that it cannot consider the topic changes. The present paper utilizes the idea of the topic model and the topic extracted through latent Dirichlet allocation to consider the topic change. This paper identifies the points at which large topic changes occur to divide the corpus using structural change detection method. An experiment involving newspaper articles with 5-year topics confirm that the points at which the topics of each document change are detected to find the division points based on the idea of structural change point detection and our method is better than previous methods based on recall measure.