高炉炉渣流动性的实验研究

以宝钢高炉渣中的四大组元(CaO,SiO2,Al2O3,MgO)为基础,实验研究MgO,Al2O3含量及碱度对炉渣的熔化性温度和流动性的影响.结果表明,炉渣中Al2O3含量控制在16%,配制适量的MgO(9%～10%),在1 500℃以上的高温区域,炉渣仍能保持正常的流动性,适合炉缸温度充沛的高炉使用;MgO含量由6%增加到10%时,较明显地降低了炉渣粘度,粘度的递减值约为0.07～0.15 Pa.s.     

纳米NiO粉体的制备及其表征

采用溶胶转化－凝胶法制备了纳米级NiO粉体。Ni(OH)2粉体的TG－DSC分析表明：在升温速率为10℃/min的条件下，粉体在489K时开始显著分解，626K时分解完毕。X－射线衍射分析表明：分解产物为纯净的NiO2。NiO粉体的化学成分分析表明：其纯度高于国家标准。TEM电镜分析表明：NiO粉体呈单分散的球形或棒状颗粒。对NiO粉体的热敏性能有待进一步研究。     

壳聚糖和粉煤灰对间甲酚的吸附处理

用壳聚糖和粉煤灰对含间甲酚的废水进行吸附处理,考察了壳聚糖的用量、振荡时间、振荡速度以及粉煤灰与壳聚糖的混合比对处理效果的影响.结果表明:在常温下,对于初始质量浓度为56 mg/L的间甲酚,当壳聚糖用量为3 g/L,以170 r/min的转速吸附振荡0.5 h,去除率可达到88%以上;在上述条件下,加入质量比4:1的粉煤灰与壳聚糖混合物5g/L时,间甲酚的去除率可达到91%.     

酚醛树脂复合板在热连轧机中的应用

重点分析了现有F7机架出口导卫装置的情况。原导卫材料是由铸钢制造 ,由于摩擦和高温常常引起热连轧带钢表面划伤 ,根据现场实际情况用酚醛树脂复合板替代铸钢导卫装置。实践表明 ,这种改造即可行又可靠 ,并取得了好的效果     

乙烯-1-辛烯共聚物增韧应用研究

介绍了聚烯烃系弹性体（POE）的特点及其在PP增韧改性中的应用，同时还报道了马来酸酐接枝的POE在极性聚合物复合体系中的应用研究。     

Change of foot size with weightbearing. A study of 2829 children 3 to 18 years of age

The change of foot length and width with age has been reported in a few anthropometric studies in the literature. However, the relationship with body height rarely is reported, and the dynamic effect of weightbearing on foot size has not been documented. In this series, 2829 children 3 to 18 years of age of equal gender distribution were included in the study. The foot length and width on weightbearing and nonweightbearing were measured with a special precision electronic caliper. The foot length and width were found to increase linearly from the age of 3 years until 12 years in girls and 15 years in boys. This was followed by a phase during which the increase plateaued. The foot length and width increased significantly on weightbearing at all ages in both genders with a mean of 2.1 to 4.4 mm or 3.1% to 4.8%, respectively. The foot length and width also were found to correlate significantly with the body height in both genders, with a correlation coefficient of 0.96 to 0.98. No significant differences were found between the sizes of the dominant and nondominant foot in either gender.     

Configurable nonlinear filter generator

A configurable nonlinear filter generator is proposed. The nonlinear function employed is key controllable. By changing the key, a different sequence will be obtained. Simulated results show that an optimal linear complexity profile of the sequence can be generated     

An adaptive morphological filter for image processing

Novel types of opening operator (NOP) and closing operator (NCP) are proposed. An adaptive morphological filter is then constructed on the basis of the NOP and NCP. The filter can remove any details consisting of fewer pixels than a given number N, while preserving the other details. Efficient algorithms are also developed for the implementation of the NOP and NCP.     

New theorems for bianisotropic media

The general volume equivalence theorem for bianisotropic scatterers is presented, where the equivalent electric and magnetic currents are determined by a pair of coupled vector integral equations. Moreover, using the general volume equivalence theorem and conventional image principle, image theory is developed for a bianisotropic body over an infinite perfect electric or magnetic conducting ground plane.