Potential and viability of grid-connected solar PV system in Bangladesh

The potential of grid-connected solar PV system in Bangladesh was estimated utilizing GeoSpatial toolkit, NASA SSE solar radiation data and HOMER optimization software. Financial viability of solar photovoltaic as an electricity generation source for Bangladesh was also assessed utilizing a proposed 1-MW grid-connected solar PV system using RETScreen simulation software for 14 widespread locations in Bangladesh. The technical potential of gird-connected solar PV in Bangladesh was calculated as about 50174 MW. The annual electricity generation of the proposed system varied depending on the location between 1653 MWh and 1854 MWh, with a mean value of 1729 MWh. Several different economic and financial indicators were calculated, such as the internal rate of return, net present value, benefit-cost ratio, cost of energy production and simple payback. All indicators – for all sites – showed favorable condition for development of the proposed solar PV system in Bangladesh. The results also showed that a minimum of 1423 tons of greenhouse gas emissions can be avoided annually utilizing the proposed system at any part of the country.     

Performance analysis of opportunistic nonregenerative relaying

Opportunistic relaying in cooperative communication depends on careful relay selection. However, the traditional centralized method used for opportunistic amplify‐and‐forward protocols requires precise measurements of channel state information at the destination. In this paper, we adopt the max–min criterion as a relay selection framework for opportunistic amplify‐and‐forward cooperative communications, which was exhaustively used for the decode‐and‐forward protocol, and offer an accurate performance analysis based on exact statistics of the local signal‐to‐noise ratios of the best relay. Furthermore, we evaluate the asymptotical performance and deduce the diversity order of our proposed scheme. Finally, we validate our analysis by showing that performance simulation results coincide with our analytical results over Rayleigh fading channels, and we compare the max–min relay selection with their centralized channel state information‐based and partial relay selection counterparts. Copyright © 2013 John Wiley & Sons, Ltd.     

Performance analysis of an opportunistic multi‐user cognitive network with multiple primary users

Consider a multi‐user underlay cognitive network where multiple cognitive users concurrently share the spectrum with a primary network with multiple users. The channel between the secondary network is assumed to have independent but not identical Nakagami‐m fading. The interference channel between the secondary users (SUs) and the primary users is assumed to have Rayleigh fading. A power allocation based on the instantaneous channel state information is derived when a peak interference power constraint is imposed on the secondary network in addition to the limited peak transmit power of each SU. The uplink scenario is considered where a single SU is selected for transmission. This opportunistic selection depends on the transmission channel power gain and the interference channel power gain as well as the power allocation policy adopted at the users. Exact closed form expressions for the moment‐generating function, outage performance, symbol error rate performance, and the ergodic capacity are derived. Numerical results corroborate the derived analytical results. The performance is also studied in the asymptotic regimes, and the generalized diversity gain of this scheduling scheme is derived. It is shown that when the interference channel is deeply faded and the peak transmit power constraint is relaxed, the scheduling scheme achieves full diversity and that increasing the number of primary users does not impact the diversity order. Copyright © 2014 John Wiley & Sons, Ltd.     

Aloe vera gel: a new thickening agent for pigment printing

An attempt was made to print cotton fabric with pigments using a new thickening agent based on Aloe vera gel in combination with sodium alginate. The results were compared with the standard conventional printing recipe containing synthetic thickener, and a favourable effect of Aloe vera introduction was achieved. The results show that the properties of the printed fabric (sharpness, colour yield, overall fastness properties, softness, and water vapour transmission) are dependent on the percentage of Aloe vera gel in the thickener combination, the concentration of printing auxiliaries, and the curing conditions. Optimal printing properties were achieved by using a printing paste containing 80% Aloe vera/20% sodium alginate (700 g kg^?1), pigment (50 g kg^?1), binder (145 g kg^?1), fixer (10 g kg^?1), and ammonium sulfate (5 g kg^?1), followed by drying at 85 °C for 5 min and curing at 150 °C for 3 min. The sample printed with the new recipe showed superior rubbing fastness and handle properties, with a slightly lower colour yield, when compared with the sample printed with synthetic thickener. Finally, economic issues arising from synthetic thickener substitution are highlighted.     

Economical treatment of reverse osmosis reject of textile industry effluent by electrodialysis–evaporation integrated process

Membrane separation methods such as electrodialysis (ED) can reduce the volume load on evaporators by facilitating further concentration of rejects from reverse osmosis (RO) plants. ED studies were carried out on a bench-scale system using five membrane cell pairs to obtain a textile effluent concentrate containing approximately 6 times the quantity of salts present in the RO reject. The limiting current densities were determined to be in the range 2.15–3.35 amp/m² for feed flow rates varying from 18 to 108 L/h. Apart from feed rate, the influence of volume of concentrate and current on membrane performance was evaluated to optimize current utilization. An estimation of energy requirement of an integrated process constituting ED and evaporation for concentration of inorganics present in textile effluent from 4.35% to 24% was made and found to be approximately one eighth of the operating cost incurred by evaporation alone. Detailed design of a commercial ED system revealed that a membrane area of 13.1 m² was required to treat a feed rate of 1500 L/h. The payback period to recover capital investment was found to be 110 days.     

Effect of different titania phases on the hydrogen gas sensing features of polyaniline/TiO2 nanocomposite

This paper presents a resistance-based hydrogen gas sensor using polyaniline (emeraldine)/TiO₂ nanocomposite (PT–NC) thin film. It is demonstrated that different gas sensing features can arise when various TiO₂ phases (anatase and rutile) are applied. The different wt% of TiO₂ phases were dispersed into an acidic solution of aniline monomers and PT–NCs were synthesized by an in-situ self-assembly chemical oxidative polymerization method of aniline. PT–NCs deposited on an epoxy glass substrate having Cu-interdigited electrodes for hydrogen gas sensing at air pressure and room temperature. Our results show that the better sensitivity of the sensor strongly depends on the sensor surface morphology and its components. Furthermore, hydrogen gas sensing mechanism of the sensor based contact areas between Pani chains and TiO₂ grains was studied.     

Faecal Composition and Nitrogen Excretion of Rats Fed on Diets Containing Sweet Lupin (Lupinus angustifoliusL) or its Fractions

Five N balance studies were conducted to determine the faecal composition and N excretion of feeding raw Lupinus angustifolius seed meal and its fractions for growing rats using a semi-synthetic lactalbumin-based diet as control. Diets were formulated to have equal amounts of energy. The protein was incorporated at the level of 10% bulk and contained unsupplemented lupin seed meal (LMU) and fully supplemented lupin seed meal (LMFS) at 360 g kg⁻¹ diet, aqueous extract non-dialysed (LPAND) at 196 g kg⁻¹ aqueous extract dialysed soluble at pH 7·0 (LPAD) at 148 g kg⁻¹ aqueous extract dialysed insoluble at pH 7·0 (LPADI) at 124 g kg⁻¹, buffer dialysed soluble at pH 7·0 (BUSOL) at 136 g kg⁻¹, buffer dialysed insoluble at pH 7·0 (BUDI) at 119 g kg⁻¹ and lupin meal residue after aqueous and buffer extraction (LMR) at 170 g kg⁻¹ diet. Rats were pair-fed for 10 days with all the above diets which had been supplemented with essential amino acids up to the target requirements for rats. Faecal wet and dry weight were increased in rats fed on LMU, LMPS and LMR diets compared to those obtained from the control diet based on lactalbumin (milk protein) LACT. The higher faecal weight was largely due to water content. The higher faecal N excretion observed in LMU, LMFS, LPAND, LPAD, BUSOL, BUDI and LMR compared to that of LACT diet was significantly lower and thus which was assumed not to be due to a decrease in the digestibility of the dietary protein, which was over 90% as compared to that in the control group. Analysis suggested that an increase in endogenous N excretion is involved in the rise of its excretion in the faeces, and indicates a long-term effect of this seed as a protein and or fibre source in monogastrics.     

Effect of tanniniferous Terminalia chebula extract on rumen biohydrogenation, ∆(9)-desaturase activity, CLA content and fatty acid composition in longissimus dorsi muscle of kids

Conjugated linoleic acid, a fatty acid found in milk fat and ruminant meat is one of the functional food components. Modifying fatty acid composition so as to increase CLA and other beneficial PUFA/MUFA level and reducing SFA levels might be a key to enhance the neutraceutical and therapeutic value of ruminant-derived food products. In the present experiment, the effect of supplementation of polyphenol rich Terminalia chebula plant extract at different concentrations (1.06 g/kg and 3.18 g/kg of body weight in T1 and T2 groups, respectively) was investigated on fatty acid composition of rumen fluid, plasma, intramuscular fat and Δ9-desaturase activity in longissimus dorsi muscle of crossbred kids. Total MUFA and PUFA content in muscle were enhanced by 25 and 35%, respectively, whereas SFA was reduced by 20% thereby improving the desaturation index. Δ9-desaturase activity also increased by 47% resulting in an enhancement of total CLA content (58.73%) in muscle.     

Novel multiplex PCR-RFLP assay discriminates bovine,porcine and fish gelatin substitution in Asian pharmaceuticals capsule shells

Gelatin is widely used in pharmaceuticals as a protective coating, such as soft and hard capsule shells. However, the animal source of gelatin is a sensitive issue because certain gelatins such as porcine and bovine gelatins are not welcome in Halal, Kosher and Hindus’ consumer goods. Recently, we have documented DNA barcoding and multiplex PCR platforms for discriminating porcine, bovine and fish gelatins in various fish and confectionary products; but those assays were not self-authenticating and also not tested in highly refined pharmaceutical products. To address this knowledge gap, here we report a self-authenticating multiplex PCR-restriction fragment length polymorphism (RFLP) assay to identify animal sources of various gelatin in pharmaceutical capsules. Three different restriction enzymes, BsaAI, Hpy188I and BcoDI were used to yield distinctive RFLP patterns for gelatin-based bovine (26, 94 bp), fish (97, 198 bp) and porcine (17, 70 bp) DNA in control experiments. The specificity was cross-tested against 16 non-target species and the optimised assay was used to screen gelatin sources in 30 halal-branded pharmaceuticals capsule shells. Bovine and porcine DNA was found in 27 and 3 of the 30 different capsules products. The assay was suitable for detecting 0.1 to 0.01 ng total DNA extracted from pure and mixed gelatins. The study might be useful to authenticate and monitor halal, kosher, vegetarian and Hindu compliant pharmaceuticals, foods and cosmetics.