A parallel technique for signal-level perceptual organization

Due to the potential for essentially unbounded scene complexity, it is often necessary to translate the sensor-derived signals into richer symbolic representations. A key initial stage in this abstraction process is signal-level perceptual organization (SLPO) involving the processes of partitioning and identification. A parallel SLPO algorithm that follows the global hypothesis testing paradigm, but breaks the iterative structure of conventional region growing through the use of α-partitioning and region filtering is presented. These two techniques segment an image such that the gray-level variation within each region can be described by a regression model. Experimental results demonstrate the effectiveness of this algorithm     

集成模拟和实际测试带来更短的设计周期和更高质量的产品

尽管模拟和测试在产品开发过程中扮演着相似的角色,但到目前为止功能上的互补并未臻完整.它们存在于各自相对隔绝的环境中(一个处于实际环境中,另一个则处于虚拟环境中),彼此的结果不能互用,在许多情况下甚至不相信彼此的结果.……     

Evaluation of solid-desiccant-based evaporative cooling cycles for typical hot and humid climates

This paper presents an evaluation of various solid desiccant cycles for air conditioning in hot and humid climates. Psychometric evaluation of potential cycles for 16 typical Indian cities has been carried out with the objective of achieving standard comfort conditions in the room. Computer simulation is based on constant effectiveness of heat exchangers and evaporative coolers and actual performance data of a commercially available desiccant wheel dehumidifier. The influence of various outdoor conditions, the effectiveness of heat exchangers/evaporative coolers on the cooling coefficient of performance and volumetric air flowrate per unit cooling capacity have been investigated. It is found that amongst ventilation, recirculation and Dunkle cycles, the Dunkle cycle is better for a wide range of outdoor conditions. However, cycles using wet surface heat exchangers give even higher performance.     

Efficient dissemination of personalized information using content-based multicast

There has been a surge of interest in the delivery of personalized information to users (e.g., personalized stocks or travel information), particularly as mobile users with limited terminal device capabilities increasingly desire updated and targeted information in real time. When the number of information recipients is large and there is sufficient commonality in their interests, as is often the case, IP multicast is an efficient way of delivering the information. However, IP multicast services do not consider the structure and semantics of the information in the multicast process. We propose the use of Content-Based Multicast (CBM) where extra content filtering is performed at the interior nodes of the IP multicast tree; this will reduce network bandwidth usage and delivery delay, as well as the computation required at the sources and sinks. We evaluate the situations in which CBM is advantageous. The benefits of CBM depend critically upon how well filters are placed at interior nodes of the IP multicast tree and the costs depend upon those introduced by filters themselves. Further, we consider the benefits of allowing the filters to be mobile so as to respond to user mobility or changes in user interests and the corresponding costs of filter mobility. The criterion that we consider is the total network bandwidth utilization. For this criterion, we develop an optimal filter placement algorithm, as well as a heuristic that executes faster than the optimal algorithm. We evaluate the algorithms by means of simulation experiments. Our results indicate that filters can be effective in substantially reducing bandwidth. We also find filter mobility is worthwhile if there is marked large-scale user mobility. We conclude with suggestions for further work.     

A radix-8 wafer scale FFT processor

Wafer Scale Integration promises radical improvements in the performance of digital signal processing systems. This paper describes the design of a radix-8 systolic (pipeline) fast Fourier transform processor for implementation with wafer scale integration. By the use of the radix-8 FFT butterfly wafer that is currently under development, continuous data rates of 160 MSPS are anticipated for FFTs of up to 4096 points with 16-bit fixed point data.     

Effects of local geometry and fluid dynamics on regional platelet deposition on artificial surfaces

An important aspect of blood-material interactions is the activation, adhesion, and subsequent aggregation of blood platelets on the artificial surface, all of which are directly affected by local fluid dynamics. The objective of this work was to directly correlate changing local fluid dynamic conditions produced by various vessel geometries, including stenosis, aneurysm, and separate contraction and expansion geometries, with quantitative in vitro measurements of regional platelet deposition. We directly measured platelet deposition as a function of axial position along four Lexan flow chambers with axisymmetric models of these geometries using 111In-labeled platelets. Platelet deposition was maximum in observed areas of flow recirculation and reattachment and minimum in locations of high shear and separation. For the stenosis geometry, two distinct regions of increased platelet deposition were apparent, one proximal to and one distal to the stenosis throat. An approximately linear increase in platelet densities was produced in the aneurysm region, increasing in the direction of flow. Through a comparison of platelet deposition with local fluid streamline orientation, we have shown that platelet deposition is increased in certain areas due to the enhanced convective transport of platelets and blood cells to the vessel wall along locally curved streamlines with velocity components perpendicular to the vessel wall.     

Single-strand conformational polymorphism analysis of the M(r) 170,000 isozyme of DNA topoisomerase II in human tumor cells

Five cell lines selected for resistance to the cytotoxicity of inhibitors of DNA topoisomerase II have point mutations in the gene that codes for the M(r) 170,000 form of this enzyme. In each case, the mutation results in an amino acid change in or near an ATP binding sequence of the M(r) 170,000 isozyme of topoisomerase II. We used single-strand conformational polymorphism analysis to screen for similar mutations in other drug-resistant cell lines or in leukemic cells from patients previously treated with etoposide or teniposide. We also analyzed the region of the gene that codes for amino acids adjacent to the tyrosine at position 804 of topoisomerase II which binds covalently to DNA. CEM/VM-1, CEM/VM-1-5, and HL-60/AMSA human leukemic cell lines were used as controls; 3 of 3 known mutations were detected by migration differences of polymerase chain reaction products from the RNA extracted from these three lines. A previously unknown mutation was found in the tyrosine 804 region of the M(r) 170,000 topoisomerase II expressed by CEM/VM-1 and CEM/VM-1-5 cells. Sequence analysis showed that substitution of a T for a C at nucleotide 2404 resulted in an amino acid change of a serine for a proline at amino acid 802. No mutations in any of the ATP binding sequences or in the tyrosine 804 region were detected in polymerase chain reaction products from RNA extracted from human leukemia HL-60/MX2 or CEM/MX1 cells (both cell lines selected for resistance to mitoxantrone) or in human myeloma 8226/Dox1V cells (selected for resistance by simultaneous exposure to doxorubicin and verapamil). No mutations were detected in polymerase chain reaction products from RNA extracted from blasts of 15 patients with relapsed acute lymphocytic leukemia, previously treated with etoposide or teniposide. We conclude that: (a) single-strand conformational polymorphism analysis is useful for screening for mutations in topoisomerase II; (b) resistance to the cytotoxicity of inhibitors of DNA topoisomerase II is not always associated with mutations in ATP binding sequences or the active site tyrosine region of M(r) 170,000 topoisomerase II; and (c) mutations similar to those detected in drug resistant cells selected in culture have not been identified in blast cells from patients with relapsed acute lymphocytic leukemia, previously treated with etoposide or teniposide.     

Appearance of homogeneous smectic multilamellar microenvironments in biomembranes undergoing superoxide-initiated lipid peroxidation: lipid-dienyl radical accumulation and fluidity management in lipid bilayers

Erythrocyte ghosts were exposed to various levels of oxyradical shock in order to identify the extent of accumulation of peroxidative intermediates. Malondialdehyde reacting end products were the same in all different models. But, the accumulation of dienyl radical species increased with higher intensity of oxyradical shock. These dienyl radicals may rearrange to create a homogeneous smectic multilamellar microenvironment which may be more fluid in terms of the molecular dynamics.