Deriving the W-matrix via p-median complete correlation analysis of residuals

Most W-matrices are built on the basis of some metric or distance measure; this paper proposes correlation coefficients as a measure of proximity. The method is applied to the case of Belgium regional data and a small Monte Carlo confirms its utility.     

Demonstration of the conditions conducive to agglomeration of zinc calcine in fluidized bed roasters

Agglomeration in the fluidized bed roasting of zinc sulphide concentrate was investigated in a continuous pilot-scale fluidized bed roaster. Alone or together, low stoichiometric excess oxygen (<10%) and high temperature (>940 °C) contributed most significantly to agglomeration of zinc calcine particles. Only one test – with 0% excess oxygen at 940 °C – led to severe agglomeration and subsequent defluidisation. Neither large initial particle size nor low gas superficial velocity promoted agglomeration as much as the combination of low stoichiometric excess oxygen and high temperature.Lead sulphide, a common impurity in zinc sulphide concentrate, also appeared to have played a key role in agglomeration. Both low excess oxygen and high temperature favoured a high partial pressure of sublimated lead sulphide. Upon contact with oxygen, lead sulphide oxidised to lead oxide, which then precipitated as a liquid onto the rather inert bed particles. As a liquid, lead oxide formed coatings that caused small particles to adhere to larger ones, as well as liquid bridges that bound particles together.     

A Review of Three‐Dimensional Resistive Switching Cross‐Bar Array Memories from the Integration and Materials Property Points of View

Issues in the circuitry, integration, and material properties of the two‐dimensional (2D) and three‐dimensional (3D) crossbar array (CBA)‐type resistance switching memories are described. Two important quantitative guidelines for the memory integration are provided with respect to the required numbers of signal wires and sneak current paths. The advantage of 3D CBAs over 2D CBAs (i.e., the decrease in effect memory cell size) can be exploited only under certain limited conditions due to the increased area and layout complexity of the periphery circuits. The sneak current problem can be mitigated by the adoption of different voltage application schemes and various selection devices. These have critical correlations, however, and depend on the involved types of resistance switching memory. The problem is quantitatively dealt with using the generalized equation for the overall resistance of the parasitic current paths. Atomic layer deposition is discussed in detail as the most feasible fabrication process of 3D CBAs because it can provide the device with the necessary conformality and atomic‐level accuracy in thickness control. Other subsidiary issues related to the line resistance, maximum available current, and fabrication technologies are also reviewed. Finally, a summary and outlook on various other applications of 3D CBAs are provided.     

Cell‐Tethered Ligands Modulate Bone Remodeling by Osteoblasts and Osteoclasts

The goals of the present study are to establish an in vitro co‐culture model of osteoblast and osteoclast function and to quantify the resulting bone remodeling. The bone is tissue engineered using well‐defined silk protein biomaterials in 2D and 3D formats in combination with human cells. Parathyroid hormone (PTH) and glucose‐dependent insulinotropic peptide (GIP) are selected because of their roles in bone remodeling for expression in tethered format on human mesenchymal stem cells (hMSCs). The cell‐modified biomaterial surfaces are reconstructed from scanning electron microscopy images into 3D models for quantitative measurement of surface characteristics. Increased calcium deposition and surface roughness are found in 3D surface models of silk protein films remodeled by co‐cultures containing tethered PTH, and decreased surface roughness is found for the films remodeled by tethered GIP co‐cultures. Increased surface roughness is not found in monocultures of hMSCs expressing tethered PTH, suggesting that osteoclast‐osteoblast interactions in the presence of PTH signaling are responsible for the increased mineralization. These data point towards the design of in vitro bone models in which osteoblast‐osteoclast interactions are mimicked for a better understanding of bone remodeling.     

On the Relation between Morphology and FET Mobility of Poly(3‐alkylthiophene)s at the Polymer/SiO2 and Polymer/Air Interface

The influence of the interface of the dielectric SiO₂ on the performance of bottom‐contact, bottom‐gate poly(3‐alkylthiophene) (P3AT) field‐effect transistors (FETs) is investigated. In particular, the operation of transistors where the active polythiophene layer is directly spin‐coated from chlorobenzene (CB) onto the bare SiO₂ dielectric is compared to those where the active layer is first spin‐coated then laminated via a wet transfer process such that the film/air interface of this film contacts the SiO₂ surface. While an apparent alkyl side‐chain length dependent mobility is observed for films directly spin‐coated onto the SiO₂ dielectric (with mobilities of ≈10^?3 cm² V^?1 s^?1 or less) for laminated films mobilities of 0.14 ± 0.03 cm² V^?1 s^?1 independent of alkyl chain length are recorded. Surface‐sensitive near edge X‐ray absorption fine structure (NEXAFS) spectroscopy measurements indicate a strong out‐of‐plane orientation of the polymer backbone at the original air/film interface while much lower average tilt angles of the polymer backbone are observed at the SiO₂/film interface. A comparison with NEXAFS on crystalline P3AT nanofibers, as well as molecular mechanics and electronic structure calculations on ideal P3AT crystals suggest a close to crystalline polymer organization at the P3AT/air interface of films from CB. These results emphasize the negative influence of wrongly oriented polymer on charge carrier mobility and highlight the potential of the polymer/air interface in achieving excellent “out‐of‐plane” orientation and high FET mobilities.     

Fast Fluorescence Spectroscopy Methodology to Monitor the Evolution of Extra Virgin Olive Oils Under Illumination

Detailed regions of excitation and emission wavelengths for extra virgin olive oil samples have been extracted from three dimensional front-face fluorescence spectra. Information was applied to establish a right-angle fluorescence procedure. A right-angle device was assembled and tested with simultaneous excitation from 200 to 400 nm and registration of the fluorescence signal emitted from 400 to 850 nm. A principal component analysis was performed on the signal ranging from 400 to 550 nm from spectra of olive oils officially categorized as extra virgin in order to model the expected variability of compounds related to oxidative processes. Such model was useful to monitor the spectral evolution of extra virgin olive oil samples acquired at retail markets, which were exposed to indirect light during 2 months, through the analysis of the effect on their scores. Three relevant peaks characterized such evolution, with local maxima at around 434 to 437, 464 to 469 and 510 to 518 nm. Polynomial relationship was found between the evolution of those peaks and that of the chlorophyll, at around 670 to 673 nm, with R ² values of 0.98 and 0.99.     

Phytoforensics, dendrochemistry, and phytoscreening: new green tools for delineating contaminants from past and present

As plants evolved to be extremely proficient in mass transfer with their surroundings and survive as earth's dominant biomass, they also accumulate and store some contaminants from surroundings, acting as passive samplers. Novel applications and analytical methods have been utilized to gain information about a wide range of contaminants in the biosphere soil, water, and air, with information available on both past (dendrochemistry) and present (phytoscreening). Collectively these sampling approaches provide rapid, cheap, ecologically friendly, and overall "green" tools termed "Phytoforensics".     

Prevalence and stability of physical aggression between spouses: A longitudinal analysis.

Community couples (N?=?272) were assessed in a longitudinal study of early marriage. More women than men reported physically aggressing against their partners at premarriage (44% vs. 31%) and 18 months (36% vs. 27%). At 30 months, men and women did not report significantly different rates of aggression (32% vs. 25%). However, using either the self-report or the partner's report, the prevalence of aggression for both men and women were pushing, shoving, and slapping. Conditional probability analyses indicated that the likelihood of physically aggressing at 30 months given that one had engaged in such aggression before marriage and at 18 months after marriage was .72 for women and .59 for men. Furthermore, 25–30% of the recipients of physical aggression at all three assessment periods were seriously maritally discordant at 30 months. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Additivity and interaction between size ratio and response category in the comparison of size-discrepant shapes.

In Experiment 1, subjects made same–different judgments to pairs of shapes that could differ (irrelevantly) in size and in which different pairs combined distinct shapes. Size discrepancy had an effect both on same and different responses. It is argued that this nonmonotonicity was produced by a form of bias acting to slow different responses for same-sized pairs. Consistent with the proposed bias account, the nonmonotonic size-discrepancy effect on different trials was eliminated in Experiment 2, in which trials were blocked by size ratio. In Experiment 3, subjects performed a task similar to that in Experiments 1 and 2. However, additional visual information was added inside the bounding contour of the shapes, and this information was either the same or different across shapes. The match between within-contour information across shapes (whether same or different) was varied orthogonally with whether the bounding contours of the shapes were the same or different. In this experiment subjects decided whether the bounding contours of the shapes were the same or different, while ignoring the added information within the contours. When the added information matched across the two shapes, same responses were facilitated relative to when the added information mismatched. The converse occurred for different responses. This effect was more pronounced when the shapes were shown at the same size than when the shapes were at different sizes. (PsycINFO Database Record (c) 2010 APA, all rights reserved)