纳米级无机粒子对聚乙烯的增强与增韧

对μｍ级ＣａＣＯ３、ＴｉＯ２和ｎｍ级ＳｉＣ／Ｓｉ３Ｎ４粒子填充ＬＤＰＥ的性能进行了研究。实验证明，μｍ级粒子对ＬＤＰＥ虽无明显的增强增韧作用，但也未使基体的机械性能大幅度下降。ｎｍ级ＳｉＣ／Ｓｉ３Ｎ４对ＬＤＰＥ有较大的增强增韧作用，在５％质量分数时冲击强度出现最大值，缺口冲击强度达５５．７ｋＪ／ｍ２为纯ＬＤＰＥ的２０３％；伸长率到６２５％时仍未断裂，为纯ＬＤＰＥ的５００％，但熔体流动速率急剧下降，仅为纯ＬＤＰＥ的２６％，当含量在３％和１５％质量分数时，熔体流动速率分别为纯ＬＤＰＥ的３３７％和１５１％。     

A new result on the delay‐dependent stability of discrete systems with time‐varying delays

This paper proposes an improvement to the delay‐dependent stability of discrete systems with time‐varying delays. The approach is based on the observation that the positive definiteness of a chosen Lyapunov–Krasovskii functional does not necessarily require all the involved symmetric matrices to be positive definite, which has been overlooked in the literature. The derived delay‐dependent stability conditions are in terms of linear matrix inequalities. It is theoretically proved that our results are less conservative than the corresponding ones obtained by requiring the positive definiteness of all the symmetric matrices in a chosen Lyapunov–Krasovskii functional. The importance of the present approach is that a great number of delay‐dependent analysis and synthesis results obtained by the aforementioned requirement in the literature can be improved by the present approach without introducing any new decision variables. Copyright © 2013 John Wiley & Sons, Ltd.     

有机-无机(硅溶胶)复合涂料的制备

有机-无机(硅溶胶)复合涂料，既具有硅溶胶耐候性好、硬度高、附着力强、耐水、耐碱、耐沾污等特点，又具有有机聚合物成膜性好、韧性大、光泽高等特点。本法选用江阴国联化工有限公司生产的交联改性的苯乙烯-丙烯酸酯乳液与硅溶胶通过物理混拼法，并辅以适当的颜填料、助剂制备的涂料，可作为外墙封闭型底漆用于水泥砂浆、混凝土等硅酸盐基材及用于外墙装饰。文章还述及制备工艺及注意事项。     

玻纤增强聚脂弯管应变导纳试验研究及其动应力分析

探讨了测定玻纤增强聚脂弯管应变导纳的试验方法。给出了力通道和应变通道的标定曲线。确定了玻纤聚脂弯管的第一、第二阶模态频率和阻尼比以及单位力幅下的动应变值。借助应变导纳的幅频特性和相频特性分析了弯管动应力。还用静态试验验证了动态测试的正确性     

Spartan6芯片μC/OS-Ⅱ的可抢占式嵌套中断控制方法

介绍了Spartan6芯片搭载MicroBlaze软核的硬件平台,以及集成了μC/OS-Ⅱ操作系统的软件平台;给出了在此软硬件平台上的可抢占、可嵌套的中断机制的实现方法;灵活地运用面向底层硬件代码与操作系统代码之间的参数传递,协调了中断处理与任务调度之间的关系。阐述了方案的原理,给出了程序流程图;通过试验,验证了可抢占、可嵌套的中断机制的正确性与可行性。     

丙烯酸粉末罩光清漆耐冲击性能的研究

针对汽车用甲基丙烯酸缩水甘油酯(GMA)类丙烯酸粉末罩光清漆耐冲击性能差的问题，通过使用3种不同的增韧方法进行改进。这3种方法分别是原位聚合法加入纳米TiO2、引入一元酸增加涂膜的柔性支链以及加入新型的纳米助剂多面低聚倍半硅氧烷(POSS)，均使涂膜的耐冲击性得到了很大的提高。但它们对涂膜其他性能的影响各不相同，本详细讨论了3种方法对涂膜性能的影响，并探讨了纳米TiO2、一元酸、POSS影响涂膜性能的机理。     

动态法快速测定催化剂比表面

本文采用动态法原理测定催化剂的比表面，利用热导检测器测定催化剂微孔在液氮下的吸附及常温下的脱附面积。用外标法进行定量。该方法分析速度快．在l小时内同时测定3个样品的比表面。其准确度及精密度满足要求。     

对我国有机硅工业现状及其发展的一些看法

回顾了我国有机硅工业的发展历史，并对国内外有机硅单体甲基氯硅烷的生产技术水平进行了对比，分析了我国与国外在甲基氯硅烷生产技术水平方面的差距，提出了发展我国有机硅工业的建议。     

红外热象仪对大化肥装置高压渣油气化炉的监测

介绍高压渣油气化炉炉温监测仪表红外热象仪的工作原理、组成和监测实例,并对此仪表的干扰因素ε提供了详细的去除办法。     

Oxidative dehydrogenation of ethane over Co–BaCO3 catalysts using CO2 as oxidant: effects of Co promoter

Co–BaCO₃ catalysts exhibited high catalytic performance for oxidative dehydrogenation of ethane (ODE) using CO₂ as oxidant. The maximal formation rate of C₂H₄ was 0.264 mmol · min⁻¹ · (g · cat.)⁻¹ (48.0% C₂H₆ conversion, 92.2% C₂H₄ selectivity, 44.3% C₂H₄ yield) on 7 wt% Co–BaCO₃ catalyst at 650 °C and 6000 ml. (g · cat.)⁻¹. h⁻¹. Co–BaCO₃ catalysts were comparatively characterized by XRF, N₂ isotherm adsorption-desorption, XRD, H₂-TPR and LRs. It was found that Co⁴⁺–O species were active sites on these catalysts in ODE with CO₂. The redox cycle of Co–O species played an important role on the catalytic performance of Co–BaCO₃ catalysts. On the other hand, the co-operation of BaCO₃ and BaCoO₃ was considered to be one of possible reasons for the high catalytic activity of these catalysts.