High‐Performance,Monolithic Polyaniline Electrochemical Actuators

New polyaniline (PANI) asymmetric membranes were fabricated using a phase‐inversion technique with hexane as the coagulation bath. These membranes exhibit a dense structure with macrovoids distributed asymmetrically throughout the cross‐section. A stress–strain study demonstrated that the Young's modulus (1.421 GPa) and strain at break (7.6 %) of the new PANI asymmetric membranes prepared from hexane are approximately 12 and 4 times higher, respectively, than the values reported previously for the PANI integrally skinned asymmetric membranes (ISAMs) (123 MPa Young's modulus and 1.8 % strain at break). Furthermore, monolithic electrochemical actuators based on a single PANI asymmetric membrane were constructed, and a bending movement of up to 20 Hz was experimentally recorded in a hydrochloric acid aqueous solution. A lifetime of over 329 500 cycles was determined for these actuators at a ± 2° angular displacement (5 Hz). The lifetime is limited by a bending fatigue that creates a transversal crack on the PANI membrane at the air–water interface. Control over the actuator movement is also manifested by the linear dependences of the bending angle on the charge and of the angular velocity on the current. These relationships are independent of both the kind of applied electric signal and the frequency used.     

灞河生态治理工程模型试验研究

通过模型试验 ,对位于西安市东郊因采沙使河道破坏严重的灞河河段进行了复现试验和研究 ,并以此为依据 ,通过优化比较为设计部门提供了合理的橡胶坝坝址和坝座高程。在此基础上 ,又对建坝后橡胶坝对上下游冲淤变化的影响进行了试验研究和分析 ,解决了工程设计中的一些关键技术问题     

变频调速技术在济钢焦化厂高压氨水泵上的应用

济钢焦化厂高压氨水泵变频调速系统采用变频器和PLC相结合的方式 ,具有调速精度高、节能等多种功能 ,保证氨水泵正常工作。全年可增加经济效益 77.3万元。     

汽车发动机电机铁芯用钢(ADW2)的研制开发

鞍钢研制开发的汽车发动机启动电机用钢是针对汽车电机铁芯用钢（定、转子）而开发的电机钢类产品。介绍了该产品的研制过程及规格、特点。通过批量试制及装机试验，产品巳满足用户的使用要求。     

微机传真系统

本文介绍了集传真技术、通信技术、微型计算机技术于一体的微机传真系统，提出了微机传真系统在硬件接口及报表识别上的实现方法。     

秦岭金矿9~#脉主要矿物特征及矿物学标志

小秦岭地区金矿床严格受构造控制，各成矿阶段及矿物学特征明显，通过对矿物学特征的研究找出矿物学标志，认为今后找矿要注意各阶段石英的颜色、黄铁矿中金的含量以及矿石中银的含量，这些与金有密切关系.     

井下储存式电子压力计的软件设计

周静等．井下储存式电子压力计的软件设计．测井技术，１９９４，１８（４）：２８１～２８７论述小功耗井下储存式电子压力计测试系统的组成及系统软件工作原理。利用软硬件结合的方式，来达到降低功耗之目的。特别是采用了软件监视定时器，以便提高系统的稳定性。系统的特点是功耗小，抗干扰能力强，稳定性好，精度高。它与袖珍计算机ＰＣ－Ｅ５００配合进行采集，处理和绘出压力恢复曲线。     

铝对W9Mo3Cr4V高速钢组织和硬度的影响

用Ｘ－射线仪，扫描电镜和透射电镜系统研究了铝对钨钼系高速钢铸态，退火以及淬回火组织的影响，铝含量超过２．０％，淬火组织中出现含析出合金的铁素体组织和晶界屈氏体，导致钢硬的降低。     

Preparation of nanosized titania powder via the controlled hydrolysis of titanium alkoxide

By controlling the hydrolysis of titanium butoxide, followed with or without an ethanol washing process, the preparation of nanoscale titania powder was studied in detail. The characteristics of different powders produced by the direct precipitation (without an ethanol wash) and ethanol wash processes were studied by X-ray diffraction, transmission electron microscopy, BET, thermogravimetry and differential thermal analysis techniques. By comparison, it was found that both the direct precipitation and ethanol wash methods can obtain slightly agglomerated nanoscale titania powders of less than 15 nm, but the ethanol wash can further reduce the agglomeration. The particle sizes of titania powders can be modified while still retaining the anatase structure.     

The preparation and magnetic properties of Fe-Ag granular solid using a sol-gel method

The Fe-Ag granular metal solid samples with 10% and 30% weight iron have been successfully fabricated using a sol-gel method, which are characterized by X-ray diffraction and transmission electron micrography. The average diameters of iron particles are from about a few nanometres to a few tens of nanometres controlled by the reducing temperature. The evolution of magnetic properties and microstructure during heat treating are described in detail and explained by using the superparamagnetism, single domain and multi domain theories. The magnetic anisotropy of the Fe-Ag granular solid is studied by using the law of approach to saturation. It is found that the magnetic anisotropy constant is in the order of 10⁵ J m^–3 which is higher than the value of the bulk iron and increases with the increase of reducing temperature.