Nutrient removal performance of an anaerobic–anoxic–aerobic process as a function of influent C/P ratio

The laboratory scale anaerobic–anoxic–aerobic (A²O) process fed with synthetic brewage wastewater was designed to investigate the effects of changing feed C/P ratio on the performance of biological nutrient removal (BNR) processes. In the experiment, the influent chemical oxygen demand (COD) concentration was kept at approximately 300 mg L^?1 while the total phosphorus concentration was varied to obtain the desired C/P ratio. Results showed that when the C/P ratio was lower than 32, phosphorus removal efficiency increased as C/P ratio increased linearly, while when the C/P ratio was higher than 32, the P removal efficiency was maintained at 90–98%, and effluent P concentration was lower than 0.5 mg L^?1. However, regardless of the C/P ratio, excellent COD removal (90% or higher) and good total nitrogen removal (75–84%) were maintained throughout the experiments. It was also found that very good linear correlation was obtained between COD uptake per unit P released in the anaerobic zone and C/P ratio. In addition, the P content in the wasted activated sludge increased with the decrease in the C/P ratio. Based on the results, it was recommended that the wastewater C/P ratio and its effects be incorporated into BNR design and operational procedures, appropriate C/P ratios were used to achieve the effluent treatment goals. Copyright © 2005 Society of Chemical Industry     

钒钛渣对刚玉莫来石耐火材料的侵蚀研究

通过不同温度下钒钛渣对刚玉莫来石耐火材料的侵蚀实验，分析了炉渣、温度对材料的影响，认为致密结构、低气孔率是提高炉衬寿命的关键，板条状莫来石的存在利于减缓渣的侵蚀过程。     

氪气和氙气的制备与应用

详细介绍了氪气、氙气的性质与应用，阐述了其制备的方法与特点，介绍了武钢氧气公司氪气、氙气生产的技术和产量等情况。     

Architectural Control of Hierarchical Nanobelt Superstructures in Catanionic Reverse Micelles

BaXO₄ (X = Mo, W) nanobelts and a variety of hierarchical superstructures assembled from the nanobelts have been synthesized in a catanionic reverse‐micelle system. The effects of various factors, such as the mixing ratio (r) between the anionic and cationic surfactants, the temperature, and the presence of polymeric additives, on the formation of the nanobelts and their hierarchical assembly have been examined in detail. In particular, r has been shown to be powerful in modulating the formation and assembly of the BaMoO₄ and BaWO₄ nanobelts. Architectural control of the penniform nanobelt superstructures has been readily achieved by changing the experimental parameters. A plausible two‐stage growth mechanism has been proposed for the formation of penniform BaXO₄ nanobelt superstructures in catanionic reverse micelles.     

Elastic constants of face-centered cubic and L1<Subscript>2</Subscript> Ni-Si alloys: Composition and temperature dependence

The adiabatic elastic stiffness constants C _ij of Ni-Si single-crystal solid-solution alloys of two slightly different compositions, 10.78 and 11.17 at. pct Si, were measured over the temperature range from 20 °C to 900 °C using the rectangular parallelepiped resonance method. The isotropic elastic constants of the polycrystalline ordered intermetallic compound Ni₃Si containing 23 at. pct Si were also measured over this temperature range. Values of the C _ij for Ni₃Si were estimated from the data on the polycrystalline alloy, as well as from published data in the literature on isomorphous ternary ordered intermetallic compounds containing different amounts of Si. Using measured values and previously published data, the stiffness constants of Ni₃Ti were estimated; these are the only available data on this alloy. The estimated single-crystal elastic constants of Ni₃Si, as well as the experimentally measured bulk modulus, are considerably smaller than published values calculated from first-principles methods. The same is true for the C _ij of Ni₃Ti, but the discrepancies are smaller.     

煤基链篦机-回转窑一步法直接还原设备改造及技术操作要点

本文主要论述了煤基链篦机-回转窑一步法直接还原关键设备改造及有关技术操作要点，并提出了进一步提高产量，稳定操作，延长作业周期，降低生产成本的技术改造方案。     

质子交换铌酸锂波导MMI光功分器

利用三维非旁轴近似光束传输法对退火质子交换铌酸锂渐变折射率分布波导中的自镜像效应进行分析与模拟 .在此基础上 ,利用退火质子交换技术在 X切 Y传铌酸锂衬底上进一步制作了 1× 8MMI光功分器 .测试表明器件实现了 1路分成 8路的光功分功能 .     

TPS/TDC3000系统串口通讯的规划与应用

针对TPS/TDC30 0 0系统串口通讯方式、机理进行了一般性的介绍 ,对规划与应用中常见的的问题 ,根据实际工程应用经验提出了解决方案。     

低乙烯含量抗冲聚丙烯的结构表征

采用二甲苯为溶剂，将不同乙烯含量（５％￣１５％质量）的抗冲聚丙烯用特定程序进行分级，将各样品分为室温下可溶于甲苯和不可溶于甲苯的两部分。使用＾１３Ｃ－ＮＭＲ方法和ＦＴ－ＩＲ方法对各组分进行表征，明确了乙烯链段在聚丙烯链上的分布，并在此基础上提出了产生这种链结构的聚合工艺的特点。