Study of 18-cm long single-sided AC-coupled silicon microstripdetectors

The SSC GEM silicon Central Tracker design incorporated 18-cm long single-sided AC-coupled silicon microstrip ladders. Compared to the 12-cm long ladders considered in the preliminary stages of the tracker design, the 18-cm long ladders have the advantage of reduced cost, channel count and overall power consumption, and led to a simplified tracker assembly. However, such long ships also present the challenge of maintaining satisfactory performance. The increased capacitance and series resistance contribute to lower signal-to-noise ratios, longer time walk, higher power consumption per channel and increased probability of crosstalk to neighboring channels. In this paper, an accurate method to calculate the geometric capacitance of the AC-coupled microstrips is presented and the calculated results are compared with measurements, SPICE simulations are performed to predict the noise, the extent of interstrip capacitive coupling and the dispersion of the detector signal due to the finite series resistance of the metal strips and the long length of the detector. The influence of the preamplifier current and the shaping time on the signal and noise levels is also presented. The study concludes that the 18-cm long ladders can successfully satisfy the performance goals of the GEM silicon Central Tracker     

高效率平面磁控溅射器的研制

介绍一种新型磁控溅射装置。它采用两块极性相对的环状磁铁的设计方法，通过扩大靶表面的等离子放电区域面积，使传统磁控溅射枪使用中经常受到的两个限制──溅射速率与靶的利用率得到了较大的改善。实验中铜靶在溅射功率密度为11W／cm~2时溅射速率约为800nm／min，如果继续提高功率则可获得更高的速率。而靶的利用率可达64％左右。另外，在认为出射粒子符合cos~nθ分布的前提下，发现当n＝3．3时，实验数据和理论数据符合得较好。     

斗南锰矿选矿厂设计中几个问题的处理

作者在斗南锰矿选矿厂设计中,针对当前锰选厂生产的经验和存在的问题,从工艺角度分别对干、湿筛分、CS-2强磁机的处理量、矿泥强磁选机的选型、以及在强磁选前设置脱除强磁性物质装置等作了分析,并提出了作者的看法。     

β″－Al_2O_3陶瓷的强化和韧化

研究了稳定ＺｒＯ＿２和部份稳定ＺｒＯ＿２对β″－Ａｌ＿２Ｏ＿３陶瓷的强化和韧化作用，观察了不同种类、不同含量的ＺｒＯ＿２对β″－Ａｌ＿２Ｏ＿３陶瓷的显微结构、力学性能和电导率的影响，探讨了β″－Ａｌ＿２Ｏ＿３的韧化机理。     

Enhanced electron emission from phosphorus-doped diamond-cladsilicon field emitter arrays

Undoped and phosphorus (P)-doped diamond-clad Si field emitter arrays have been successfully fabricated using microwave plasma chemical vapor deposition (MPCVD) technology. The electron emission from the blunt diamond-clad microtips are much higher than those for the pure Si tips with sharp curvature due to a lower work function. Furthermore, the characteristics of emission current against applied voltage for the P-doped diamond-clad tips show superior emission at lower field to the undoped ones. After the examination of Auger electron spectroscopy (AES) and electrical characteristics of as-grown diamond, such a significant enhancement of the electron emission from the P-doped diamond-clad tips is attributed to a higher electron conductivity and defect densities     

Determination of the width of the transition layer between the crystalline and amorphous zones in nylon 1010 by SAXS

The width of the transition layer between the crystalline and amorphous zones in nylon 1010 was determined by SAXS with point collimation and long-slit collimation, respectively. The width of the transition layer, E, was found to be 1.7 nm. The results show that the width of the transition layer is independent of crystallinity.     

Exact evaluation of laser linewidth requirements for optical PSKhomodyne communication systems with balanced PLL receivers

The power penalty induced by imperfect phase recovery in PSK homodyne communication systems with balanced phase-locked loop receivers are exactly evaluated. Optimum phase deviations between the mark-state and the space-state bits are used in this study. This study for the first time shows the imperfect-phase-recovery-induced power penalty as a function of laser linewidth with optimum phase deviations considered. It can be estimated from the theoretical result that an optimal balanced PLL receiver requires the laser linewidth as Δν⩽1.15×10^-6× (bit rate) in contrast to the previous reported one Δν⩽5.88×10^-6× (bit rate). We also point out here that the previously reported laser linewidth requirement was wrongly estimated     

TiAl基合金表面改性对高温抗氧化性的影响

研究了渗碳处理ＴｉＡｌ基合金试样的高温氧化行为，发现渗碳处理可以在ＴｉＡｌ基合金试样表层形成致密的多层结构的渗碳层，并发生表层Ａｌ、Ｔｉ重新分配。致密的渗碳层具有良好的高温抗氧化性和高温热稳定性，同时，Ｔｉ、Ａｌ重新分配形成的富Ａｌ最外层也能进一步提高合金的抗氧化性。     

内蒙古大青山麻粒岩相糜棱岩石英的变形行为

在内蒙古大青山地区发育一套高温区域变质岩──麻粒岩，在这高温变质岩内有一系列的糜棱岩带．通过对糜棱岩带中石英的研究，对比深部地壳与浅部地壳石英的变形特点，获得一些新的认识．对石英显微构造、动态重结晶、TEM研究及石英岩组学方面进行了研究，发现石英的塑性变形显著，以缎带石英产出，发育各种塑性变形的显微构造，变形带、波状消光和亚颗粒显著：TEM观察到石英中有直线状的位错．岩组学研究显示出石英高温变形和多期构造叠加的特点．