Specificity of the pheromone system ofAdoxophyes orana andClepsis spectrana

The pheromone system of the summer fruit tortrix mothAdoxophyes orana (Fischer von Röslerstamm) consists of a mixture ofcis-9- andcis-11-tetradecen-1-ol acetate (cis-9- andcis-11-TDA, respectively) in a ratio of 9:1. Substitution of one or both of these compounds by related unsaturated acetates reduced the attractancy. Onlycis-11-TDA could be replaced bycis-11-tridecen-1-ol acetate (cis-11-TriDA), although the 9:1 mixture ofcis-9-TDA andcis-11-TriDA was less attractive in the field than the pheromone system itself. The major component of the pheromone system of the leaf rollerClepsis spectrana (Treitschke)(cis-9-TDA:cis-11-TDA=1:9) could also be replaced bycis-11-TriDA, again with some reduction in attractancy.     

Diffusion coefficient in polymer solutions

Molecular diffusivity of a solute in a solvent may be determined by measuring the extent of dispersion of solute in solvent flowing in a straight circular tube under the conditions of laminar flow. This simple and rapid method for determination of molecular diffusivity in aquous polymer solutions is discussed. Experimental results show a substantial reduction in the solute diffusivity with increase in polymer concentration.     

Vertical pneumatic conveying: An experimental study with particles in the intermediate and turbulent flow regimes

Vertical pneumatic conveying was studied in a 3-inch diameter riser 30 feet in length using solids ranging in particle Reynolds number from 100 to 3500. Particle to gas mass flow ratios varied from 0 to 8 and pipeline conditions extended from dilute flow down into the choking region. Average particle hold-up was determined by means of a series of quick-closing valves and particle slip velocity was often found to be greater than the calculated terminal velocity. The reasons for this are examined. Frictional pressure losses in the riser were also determined and compared with literature data. The phenomenon of choking is considered briefly.     

Towards properly controlled analytical measurement methods

It is of great practical importance to develop simple methods for the automatic detection ofthe controlled state of the analytical method being applied. The key point is to find quantities that greatly affect the quality of the analytical results and that can be easily estimated during the measurement process from the measured data. The signal-to-noise ratio has proved to be such a quantity in gas chromatographic methods. The statistical properties of the estimation of the signal-to-noise ratio from gas chromatographic data have been investigated. The suggested practical method for estimating the signal-to-noise ratio proved to be biased from a mathematical statistical point of view, but the bias is usually not greater than 10%. It has been shown by practical examples that the signal-to-noise ratio affects the quality of the analytical results and it is easy to estimate its value from practical data.     

Deposition of dense isotropic carbon from acetylene in fluidized bed

Pyrolytic carbon was deposited from acetylene in a fluidized bed at 1100°C on alumina microspheres. In case when only argon was used as the diluent gas, density and BAF of the deposit decreased and deposition yield increased with increasing acetylene concentration. Hydrogen sypply suppressed carbon formation and, consequently, caused an increase in density and Lc. BAF was relatively independent of hydrogen concentration. It was found that high density, isotropic carbon can be deposited from acetylene at 1100°C, if an appropriate proportion of hydrogen is added.     

Static and dynamic strain-dependent viscoelastic behavior of black-filled EPDM vulcanizates

The strain dependence of the dynamic mechanical properties of HAF-N330-filled EPDM vulcanizate was studied using a Rheovibron DDV III EP. It is shown that when a dynamic strain is superposed on a static strain, the viscoelastic response of filled rubbers becomes more complex. Under these conditions, dynamic mechanical properties do not correlate with the double strain amplitude. A strain called the “total strain” has been defined in order to interpret the experimental results. It is also shown that the dynamic mechanical properties are displacement velocity dependent, while the comparison is made under identical conditions of strain and frequency. Separability of time and strain effects is observed for the storage modulus, whereas the loss modulus is shown to be a nonseparable function. The elastic and the relaxation components, constituting the mixed function representing the storage modulus are shown to have similar deformation dependence. © 1994 John Wiley & Sons, Inc.